参数资料
| 型号： | LT3083EDF#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 4/28页 |
| 文件大小： | 0K |
| 描述： | IC REG LDO ADJ 3A 12-DFN |
| 标准包装： | 2,500 |
| 稳压器拓扑结构： | 正，可调式 |
| 输出电压： | 可调至 23V |
| 输入电压： | 1.2 V ~ 23 V |
| 电压 - 压降（标准）： | 1.25V @ 3A |
| 稳压器数量： | 1 |
| 电流 - 输出： | 3A |
| 电流 - 限制（最小）： | 3A |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 12-WFDFN 裸露焊盘 |
| 供应商设备封装： | 12-DFN-EP（4x4） |
| 包装： | 带卷 (TR) |
第1页第2页第3页当前第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LT3083
ELECTRICAL CHARACTERISTICS The l denotes the specifications which apply over the full operating
temperature range, otherwise specification s are at T A = 25°C (Note 2).
PARAMETER
V CONTROL Dropout Voltage (Note 4)
V IN Dropout Voltage (Note 4)
V CONTROL Pin Current (Note 5)
CONDITIONS
I LOAD = 100mA
I LOAD = 1A
I LOAD = 3A
I LOAD = 100mA
I LOAD = 1A, Q, T Packages
I LOAD = 1A, DF, FE Packages
I LOAD = 3A, Q, T Packages
I LOAD = 3A, DF, FE Packages
I LOAD = 100mA
I LOAD = 1A
I LOAD = 3A
l
l
l
l
l
l
l
l
l
l
MIN
TYP
1.2
1.22
1.25
10
120
90
310
240
5.5
18
40
MAX
1.55
1.6
25
190
160
510
420
10
35
80
UNITS
V
V
V
mV
mV
mV
mV
mV
mA
mA
mA
Current Limit
Error Amplifier RMS Output Noise (Note 6)
Reference Current RMS Output Noise (Note 6)
Ripple Rejection
V RIPPLE = 0.5V P-P , I L = 0.1A, C SET = 0.1μF,
C OUT = 10μF
Thermal Regulation, I SET
V IN = 5V, V CONTROL = 5V, V SET = 0V, V OUT = –0.1V
I LOAD = 500mA, 10Hz ≤ f ≤ 100kHz, C OUT = 10μF, C SET = 0.1μF
10Hz ≤ f ≤ 100kHz
f = 120Hz
f = 10kHz
f = 1MHz
10ms Pulse
l
3
3.7
40
1
85
75
20
0.003
A
μV RMS
nA RMS
dB
dB
dB
%/W
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: Unless otherwise specified, all voltages are with respect to V OUT.
The LT3083 is tested and specified under pulse load conditions such that
T J ? T A . The LT3083E is 100% tested at T A = 25°C. Performance of the
LT3083E over the full –40°C to 125°C operating junction temperature
range is assured by design, characterization, and correlation with
statistical process controls. The LT3083I regulators are guaranteed
over the full –40°C to 125°C operating junction temperature range. The
LT3083MP is 100% tested and guaranteed over the –55°C to 125°C
operating junction temperature range.
Note 3: Minimum load current is equivalent to the quiescent current of
the part. Since all quiescent and drive current is delivered to the output
of the part, the minimum load current is the minimum current required to
maintain regulation.
Note 4: For the LT3083, dropout is caused by either minimum control
voltage (V CONTROL ) or minimum input voltage (V IN ). Both parameters are
specified with respect to the output voltage. The specifications represent
the minimum input-to-output differential voltage required to maintain
regulation.
Note 5: The V CONTROL pin current is the drive current required for the
output transistor. This current will track output current with roughly a 1:60
ratio. The minimum value is equal to the quiescent current of the device.
Note 6: Output noise is lowered by adding a small capacitor across the
voltage setting resistor. Adding this capacitor bypasses the voltage setting
resistor shot noise and reference current noise; output noise is then equal
to error amplifier noise (see the Applications Information section).
Note 7: The SET pin is clamped to the output with diodes through 1k
resistors. These resistors and diodes will only carry current under
transient overloads.
Note 8: Load regulation is Kelvin sensed at the package.
Note 9: Current limit includes foldback protection circuitry. Current limit
decreases at higher input-to-output differential voltages.
Note 10: This IC includes overtemperature protection that is intended
to protect the device during momentary overload conditions. Junction
temperature will exceed the maximum operating junction temperature
when overtemperature protection is active. Overtemperature protection
(thermal limit) is typically active at junction temperatures of 165°C.
Continuous operation above the specified maximum operating junction
temperature may impair device reliability.
3083fa
4
相关PDF资料 |
PDF描述 |
|---|---|
| MIC5322-MGYMT TR | IC REG LDO 2.8V/1.8V .15A 6TMLF |
| LFXP10C-3F388I | IC FPGA 9.7KLUTS 244I/O 388-BGA |
| IDT72V51443L7-5BB8 | IC FLOW CTRL MULTI QUEUE 256-BGA |
| LFEC15E-3FN256C | IC FPGA 15.3KLUTS 256FPBGA |
| LFECP10E-3QN208I | IC FPGA 10.2KLUTS 208PQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3083EFE | 制造商:LINER 制造商全称:Linear Technology 功能描述:Adjustable 3A Single Resistor Low Dropout Regulator |
| LT3083EFE#PBF | 功能描述:IC REG LDO ADJ 3A 16-TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:1 系列:- 稳压器拓扑结构:正，固定式 输出电压:8V 输入电压:10.5 V ~ 23 V 电压 - 压降（标准）:1.7V @ 40mA 稳压器数量:1 电流 - 输出:100mA（最小值） 电流 - 限制（最小）:- 工作温度:0°C ~ 125°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 供应商设备封装:8-SOIC 包装:剪切带 (CT) 产品目录页面:1075 (CN2011-ZH PDF) 其它名称:296-24390-1 |
| LT3083EFE#PBF-ES | 制造商:Linear Technology 功能描述:LDO Regulator Pos 0V to 23V 3A 16-Pin TSSOP EP |
| LT3083EFE#TRPBF | 功能描述:IC REG LDO ADJ 3A 16-TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:1 系列:- 稳压器拓扑结构:正，固定式 输出电压:3V 输入电压:2.3 V ~ 5.5 V 电压 - 压降（标准）:0.035V @ 150mA 稳压器数量:2 电流 - 输出:150mA 电流 - 限制（最小）:300mA 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:6-UFDFN 裸露焊盘，6-TMLF? 供应商设备封装:6-TMLF?（1.6x1.6） 包装:Digi-Reel® 产品目录页面:1104 (CN2011-ZH PDF) 其它名称:576-3018-6 |
| LT3083EFE#TRPBF-ES | 制造商:Linear Technology 功能描述:LDO Regulator Pos 0V to 23V 3A 16-Pin TSSOP EP T/R |
发布紧急采购，3分钟左右您将得到回复。