参数资料
型号: LT3437HFE#TRPBF
厂商: Linear Technology
文件页数: 14/28页
文件大小: 0K
描述: IC REG BUCK ADJ 0.5A 16TSSOP
标准包装: 2,500
类型: 降压(降压)
输出类型: 可调式
输出数: 1
输出电压: 1.25 V ~ 54 V
输入电压: 3.3 V ~ 60 V
PWM 型: 电流模式,混合
频率 - 开关: 200kHz
电流 - 输出: 500mA
同步整流器:
工作温度: -40°C ~ 125°C
安装类型: 表面贴装
封装/外壳: 16-TSSOP(0.173",4.40mm)裸露焊盘
包装: 带卷 (TR)
供应商设备封装: 16-TSSOP-EP
LT3437
APPLICATIO S I FOR ATIO
V OUT ( IN OUT )
( )( ) 5
2 ( 68 e – 6 )( 200 e 3 )( 8 )
( )( ) 5
2 ( 68 e – 6 )( 200 e 3 )( 15 )
V OUT ( IN OUT )
( )( )( )
V OUT
10mV/DIV
100 μ F TANTALUM
ESR 75m ?
V OUT
10mV/DIV
100 μ F CERAMIC
V SW
10V/DIV
V IN = 12V 1 μ s/DIV 3437 F03
V OUT = 3.3V
I LOAD = 500mA
L = 100 μ H
Figure 3. LT3437 Ripple Voltage Waveform
MAXIMUM OUTPUT LOAD CURRENT
Maximum load current for a buck converter is limited by
the maximum switch current rating (I PK ). The current
rating for the LT3437 is 500mA. Unlike most current mode
converters, the LT3437 maximum switch current limit
does not fall off at high duty cycles. Most current mode
converters suffer a drop off of peak switch current for duty
cycles above 50%. This is due to the effects of slope
compensation required to prevent subharmonic oscilla-
tions in current mode converters. (For detailed analysis,
see Application Note 19.)
The LT3437 is able to maintain peak switch current limit
over the full duty cycle range by using patented circuitry to
cancel the effects of slope compensation on peak switch
current without affecting the frequency compensation it
provides.
Maximum load current would be equal to maximum
switch current for an infinitely large inductor, but with
Discontinuous operation occurs when:
V – V
I OUT ( DIS ) ≤
2 ( L )( f )( V IN )
For V OUT = 5V, V IN = 8V and L = 68 μ H:
5 8 –
I OUT ( MAX ) = 0 . 5 –
= 0 . 5 – 0 . 069 = 0 . 431 A
Note that there is less load current available at the higher
input voltage because inductor ripple current increases. At
V IN = 15V, duty cycle is 33% and for the same set of
conditions:
5 15 –
I OUT ( MAX ) = 0 . 5 –
= 0 . 5 – 0 . 121 = 0 . 379 A
To calculate actual peak switch current in continuous
mode with a given set of conditions, use:
V – V
I SW ( PK ) = I OUT +
2 L f V IN
If a small inductor is chosen which results in discontinuous
mode operation over the entire load range, the maximum
load current is equal to:
( )( )( )
( V OUT )( V IN OUT ) = I PK – I P -P
2 ( )( )( V IN )
finite inductor size, maximum load current is reduced by
one-half peak-to-peak inductor current. The following
formula assumes continuous mode operation, implying
that the term on the right (I P-P /2) is less than I OUT .
– V
I OUT ( MAX ) = I PK –
L f 2
I OUT ( MAX ) =
2
I PK 2 f L V IN
2 ( V OUT )( V IN – V OUT )
3437fc
14
相关PDF资料
PDF描述
S1812-561K INDUCTOR SHIELDED .56UH SMD
V28C28C100BF CONVERTER MOD DC/DC 28V 100W
LT1767EMS8E-5 IC REG BUCK 5V 1.5A 8MSOP
V28C28C100BL3 CONVERTER MOD DC/DC 28V 100W
LT1767EMS8E-3.3 IC REG BUCK 3.3V 1.5A 8MSOP
相关代理商/技术参数
参数描述
LT3437IDD 制造商:Linear Technology 功能描述:SP-SWREG/Monolithic, 60V, 500mA, 200kHz Step-down Converter w/ BurstMode
LT3437IDD#PBF 功能描述:IC REG BUCK ADJ 0.5A 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压(降压) 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON(1.45x1) 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2
LT3437IDD#PBF 制造商:Linear Technology 功能描述:DC-DC CONVERTER BUCK 200KHZ 制造商:Linear Technology 功能描述:DC-DC CONVERTER, BUCK, 200KHZ, DFN-10
LT3437IDD#TRPBF 功能描述:IC REG BUCK ADJ 0.5A 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压(降压) 输出类型:固定 输出数:1 输出电压:1.2V,1.5V,1.8V,2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP,10-MSOP(0.118",3.00mm 宽)裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘
LT3437IDDPBF 制造商:Linear Technology 功能描述:500mA, Hi Volt Buck Sw Reg, LT3437IDD