参数资料
型号: LT3439EFE#TR
厂商: Linear Technology
文件页数: 10/12页
文件大小: 0K
描述: IC REG PSH-PLL CTRLR ISO 16TSSOP
标准包装: 2,500
类型: 推挽式控制器,隔离式
输出数: 1
输入电压: 2.8 V ~ 17.5 V
频率 - 开关: 20kHz ~ 250kHz
电流 - 输出: 1A
同步整流器:
工作温度: -40°C ~ 125°C
安装类型: 表面贴装
封装/外壳: 16-TSSOP(0.173",4.40mm)裸露焊盘
包装: 带卷 (TR)
供应商设备封装: 16-TSSOP-EP
LT3439
APPLICATIO S I FOR ATIO
= 5 100 kHz = 467 μ H
= V
f OSC
? I PRI
The primary inductance is then calculated:
1 1
L PRI IN
0 . 107 A
? I = 15% of I PRI = 0 . 15 ? 0 . 714 A = 0 . 107 A
Next, build a transformer with the calculated values of
turns ratio and primary inductance. Minimize resistance in
Optional LC Filter
An optional LC filter, as shown on the Typical Application
on the first page of this data sheet, should be included if
ultralow noise and ripple are required. It is recommended
that the corner frequency of the filter should be set a
decade below the switching frequency so that the switch
noise is attenuated by a factor of 100. For example, if the
f OSC = 100kHz, then f CORNER = 10kHz where:
the windings. The turns ratio can be tweaked to get the
specified output voltage.
f CORNER
1
2 ? π LC
Capacitors
The DC transformer topology runs effectively at 100%
duty cycle (50% each side). This means that the input
supply current is approximately constant. Therefore, large
“hold-up type” capacitors are not necessary. A low value
(> 4.7 μ F), low ESR ceramic will be adequate to filter high
frequency noise at the input.
The output capacitors supply energy to the output load only
during switch transitions. Therefore, large capacitance
values are not necessary. Low ESR, surface mount capaci-
tors such as ceramic, OS-CON of POSCAPs are recom-
mended. An additional LC filter can be added in addition to
the output capacitor to further reduce output noise.
Transformer winding capacitance between the isolated
primary and secondary have parasitic currents that can
cause noise on the grounds. Providing a high frequency,
low impedance path between the primary and secondary
gives the parasitic currents a local return path. A 2.2nF, 1kV
ceramic capacitor is recommended.
Switching Diode Selection
A fast recovery, surface mount diode such as a Schottky
is recommended. The proximity of the diodes to the
transformer outputs is important and should be as close
as possible with short, wide traces connecting them.
Output Voltage Regulation
The output voltage of the DC transformer topology is
unregulated. Variations in the input voltage will cause the
output voltage to vary because the output voltage is a
function of the input voltage and the transformer turn
ratio. Also, variations in the output load will cause the
output voltage to change because of circuit parasitics,
such as the transformer DC resistance and power switch
on resistance. If regulation is necessary, a post regulator
such as a linear regulator can be added to the output of the
supply. See the Typical Applications for examples of
adding a linear regulator.
More Help
AN70: “A Monolithic Switching Regulator with 100 μ V
Output Noise” contains much information concerning
applications and noise measurement techniques.
AN19: “LT1070 Design Manual”
AN29: “Some Thoughts on DC-DC Converters” also have
general knowledge on switching regulators.
An LTC SwitcherCAD TM model is available to verify design
performance.
The LTC Applications department is always ready to lend
a helping hand.
SwitcherCAD is a trademark of Linear Technology Corporation.
sn3439 3439fs
10
相关PDF资料
PDF描述
V110B36E200BG2 CONVERTER MOD DC/DC 36V 200W
DS1233DZ-5/T&R IC ECONORESET NO PBR 5% SOT-223
LTC3520EUF#TRPBF IC REG BUCK BOOST SYNC ADJ 24QFN
V110B36E200BF3 CONVERTER MOD DC/DC 36V 200W
LT3508EFE#TRPBF IC REG BUCK ADJ 1.4A DL 16TSSOP
相关代理商/技术参数
参数描述
LT343L 制造商:未知厂家 制造商全称:未知厂家 功能描述:Optoelectronic
LT344L 制造商:未知厂家 制造商全称:未知厂家 功能描述:Optoelectronic
LT344LR 制造商:未知厂家 制造商全称:未知厂家 功能描述:Optoelectronic
LT3460 制造商:LINER 制造商全称:Linear Technology 功能描述:1.3MHz Step-Up DC/DC Converter in SC70 and ThinSOT
LT3460EDC-1#PBF 制造商:Linear Technology 功能描述:SP-SWREG/Monolithic, CUT TAPE 150mA, 650kHz Boost Converter in 2x2 DFN