- 您现在的位置：买卖IC网 > PDF目录20875 > LT3466EFE#TRPBF (Linear Technology)IC LED DRVR WHITE BCKLGT 16TSSOP PDF资料下载
参数资料
| 型号： | LT3466EFE#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 12/20页 |
| 文件大小： | 0K |
| 描述： | IC LED DRVR WHITE BCKLGT 16TSSOP |
| 标准包装： | 2,500 |
| 恒定电流： | 是 |
| 拓扑： | PWM，升压（升压） |
| 输出数： | 2 |
| 内部驱动器： | 是 |
| 类型 - 主要： | 车载，背光 |
| 类型 - 次要： | 白色 LED |
| 频率： | 800kHz ~ 1.3MHz |
| 电源电压： | 2.7 V ~ 24 V |
| 输出电压： | 39.5V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-TSSOP（0.173"，4.40mm）裸露焊盘 |
| 供应商设备封装： | 16-TSSOP-EP |
| 包装： | 带卷 (TR) |
| 工作温度： | -40°C ~ 85°C |
LT3466
APPLICATIO S I FOR ATIO
Table 3. Inrush Peak Current
Using a DC Voltage
V IN (V)
5
5
5
5
9
12
L ( μ H)
15
33
47
68
47
33
C OUT ( μ F)
0.47
1.00
2.2
1.00
0.47
0.22
I P (A)
0.78
0.77
0.95
0.53
0.84
0.93
For some applications, the preferred method of brightness
control is a variable DC voltage to adjust the LED current.
The CTRL pin voltage can be modulated to set the dimming
of the respective LED string. As the voltage on the CTRL
pin increases from 0V to 1.6V, the LED current increases
from 0 to I LED . As the CTRL pin voltage increases beyond
1.6V, it has no effect on the LED current.
Typically peak inrush current will be less than the value
calculated above. This is due to the fact that the DC
resistance in the inductor provides some damping result-
ing in a lower peak inrush current.
PROGRAMMING LED CURRENT
The LED current of each LED string can be set indepen-
dently by the choice of resistors R FB1 and R FB2 respec-
tively (Figure 2). The feedback reference is 200mV. In
order to have accurate LED current, precision resistors are
preferred (1% is recommended).
The LED current can be set by:
I LED ≈ (200mV/R FB ), when V CTRL > 1.6V
I LED ≈ (V CTRL /5 ? R FB ), when V CTRL < 1V
Feedback voltage variation versus control voltage is given
in the Typical Performance Characteristics graphs.
Using a Filtered PWM Signal
A variable duty cycle PWM can be used to control the
brightness of the LED string. The PWM signal is filtered
(Figure 8) by an RC network and fed to the CTRL1, CTRL2
pins.
R FB 1 =
R FB 2 =
200 mV
I LED 1
200 mV
I LED 2
The corner frequency of R1, C1 should be much lower than
the frequency of the PWM signal. R1 needs to be much
smaller than the internal impedance in the CTRL pins,
which is 100k ? .
Table 4. R FB Value Selection
I LED (mA)
5
R FB ( ? )
40.2
PWM
10kHz TYP
R1
10k
C1
1 μ F
LT3466
CTRL1,2
3466 F08
10
20.0
15
20
25
13.3
10.0
8.06
Figure 8. Dimming Control Using a Filtered PWM Signal
LOW INPUT VOLTAGE APPLICATIONS
Most White LEDs are driven at maximum currents of
15mA to 20mA.
DIMMING CONTROL
There are two different types of dimming control circuits.
The LED current in the two drivers can be set indepen-
dently by modulating the CTRL1 and CTRL2 pins
The LT3466 can be used in low input voltage applications.
The input supply voltage to the LT3466 must be 2.7V or
higher. However, the inductors can be run off a lower
battery voltage. This technique allows the LEDs to be
powered off two alkaline cells. Most portable devices have
a 3.3V logic supply voltage which can be used to power the
LT3466. The LEDs can be driven straight from the battery,
resulting in higher efficiency.
respectively.
3466fa
12
相关PDF资料 |
PDF描述 |
|---|---|
| LT3466EDD#TRPBF | IC LED DRIVR WHITE BCKLGT 10-DFN |
| LT3466EDD#TR | IC LED DRIVR WHITE BCKLGT 10-DFN |
| GBC07DRYI | CONN EDGECARD 14POS DIP .100 SLD |
| P51-100-A-J-M12-4.5OVP-000-000 | SENSOR 100PSI 3/8-24UNF .5-4.5V |
| REC5-2415SRWZ/H6/A/SMD | CONV DC/DC 5W 9-36VIN 15VOUT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3467 | 制造商:LINER 制造商全称:Linear Technology 功能描述:700mA Low Noise High Current LED Charge Pump |
| LT3467A | 制造商:LINER 制造商全称:Linear Technology 功能描述:700mA Low Noise High Current LED Charge Pump |
| LT3467AEDDB#PBF | 制造商:Linear Technology 功能描述:SP-SWREG/Monolithic, Cut Tape 1.1A, 2.1MHz Boost Converter |
| LT3467AEDDB#TRMPBF | 功能描述:IC REG BOOST ADJ 1.1A 8DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
| LT3467AEDDB#TRPBF | 功能描述:IC REG BOOST ADJ 1.1A 8DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
发布紧急采购，3分钟左右您将得到回复。