参数资料
型号: LT3473AEDE#PBF
厂商: Linear Technology
文件页数: 7/12页
文件大小: 0K
描述: IC REG BOOST ADJ 1A 12DFN
标准包装: 91
类型: 升压(升压)
输出类型: 可调式
输出数: 1
输出电压: 可调至 34V
输入电压: 2.2 V ~ 16 V
PWM 型: 电流模式,混合
频率 - 开关: 1.2MHz
电流 - 输出: 1A
同步整流器:
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 12-WFDFN 裸露焊盘
包装: 管件
供应商设备封装: 12-DFN(4x3)
产品目录页面: 1331 (CN2011-ZH PDF)
LT3473/LT3473A
APPLICATIO S I FOR ATIO
Operation
The LT3473 combines a current mode, fixed frequency
PWM architecture with Burst Mode micropower operation
to maintain high efficiency at light loads. Operation can
best be understood by referring to the Block Diagram.
The reference of the part is determined by the lower of the
internal 1.25V bandgap reference and the voltage at the
CTRL pin. The error amplifier compares voltage at the FB
pin with the reference and generates an error signal V C .
When V C is below the Burst Mode threshold voltage, B TH ,
the hysteretic comparator, A1, shuts off the power section
leaving only the low power circuitry running. Total current
consumption in this state is minimized. As output loading
causes the FB voltage to decrease, V C increases causing A1
to enable the power section circuitry. The chip starts switch-
ing. If the load is light, the output voltage (and FB voltage)
will increase until A1 turns off the power section. The output
voltage starts to fall again. This cycle repeats and gener-
ates low frequency ripple at the output. This Burst Mode
operation keeps the output regulated and reduces average
current into the IC, resulting in high efficiency at light load.
If the output load increases sufficiently, A1’s output remains
high, resulting in continuous operation.
At the start of each oscillator cycle, the SR latch is set,
turning on the power switch Q1. A voltage proportional to
the switch current is added to a stabilizing ramp and the
I L
200mA/DIV
Switching Waveforms
I L
200mA/DIV
Switching Waveforms
V OUT
200mV/DIV
I L
200mA/DIV
Transient Response
V SW
10V/DIV
V SW
10V/DIV
I LOAD
11mA
1mA
V IN = 3.6V
V OUT = 20V
I LOAD = 50mA
0.5 μ s/DIV
3473 AI01
V IN = 3.6V
V OUT = 20V
I LOAD = 8mA
0.5 μ s/DIV
3473 AI02
V IN = 3.6V
V OUT = 20V
500 μ s/DIV
3473 AI03
V OUT
500mV/DIV
I L
500mA/DIV
Transient Response
V OUT
500mV/DIV
I L
500mA/DIV
Transient Response
V OUT
500mV/DIV
I L
500mA/DIV
Transient Response
I LOAD
51mA
1mA
I LOAD
55mA
5mA
I LOAD
75mA
25mA
V IN = 3.6V
V OUT = 20V
500 μ s/DIV
3473 AI04
V IN = 3.6V
V OUT = 20V
500 μ s/DIV
3473 AI05
V IN = 3.6V
V OUT = 20V
200 μ s/DIV
3473 AI06
V OUT
10V/DIV
CAP
0.5V/DIV
SHDN
5V/DIV
Shutdown Waveforms
V OUT
10V/DIV
IL
500mA/DIV
SHDN
2V/DIV
Start-Up Waveforms
V IN = 3.6V
V OUT = 20V
I LOAD = 60mA
100 μ s/DIV
3473 AI07
V IN = 3.6V
V OUT = 20V
I LOAD = 30mA
SHDN 20k, 100nF
500 μ s/DIV
3473 AI08
3473f
7
相关PDF资料
PDF描述
LT3479EDE#TRPBF IC REG BOOST INV ADJ 3A 14DFN
LT3480MPMSE#TRPBF IC REG BUCK ADJ 2A 10MSOP
LT3481HMSE#TRPBF IC REG BUCK ADJ 2A 10MSOP
LT3482IUD#TRPBF IC REG BOOST ADJ 0.28A 16QFN
LT3483AIDC#TRPBF IC REG INV ADJ 0.4A 8DFN
相关代理商/技术参数
参数描述
LT3473EDD 制造商:LINER 制造商全称:Linear Technology 功能描述:Micropower 1A Boost Converter with Schottky and Output Disconnect
LT3473EDD#PBF 功能描述:IC REG BOOST ADJ 1A 8DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压(降压) 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON(1.45x1) 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2
LT3473EDD#PBF 制造商:Linear Technology 功能描述:Switching Regulator IC 制造商:Linear Technology 功能描述:IC, DC/DC BOOST CONVERTER, DFN-8
LT3473EDD#TRPBF 功能描述:IC REG BOOST ADJ 1A 8DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压(升压) 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式,混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC(0.154",3.90mm 宽) 包装:带卷 (TR) 供应商设备封装:8-SOIC
LT3473EDDPBF 制造商:Linear Technology 功能描述:1A Boost Converter, LT3473EDD