- 您现在的位置：买卖IC网 > PDF目录20851 > LT3476EUHF#TRPBF (Linear Technology)IC LED DRVR HP CONST CURR 38-QFN PDF资料下载
参数资料
| 型号： | LT3476EUHF#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 5/14页 |
| 文件大小： | 0K |
| 描述： | IC LED DRVR HP CONST CURR 38-QFN |
| 标准包装： | 2,500 |
| 恒定电流： | 是 |
| 拓扑： | PWM，降压（降压），升压（升压） |
| 输出数： | 4 |
| 内部驱动器： | 是 |
| 类型 - 主要： | 车载，背光 |
| 类型 - 次要： | 颜色，RGB |
| 频率： | 200kHz ~ 2MHz |
| 电源电压： | 2.8 V ~ 16 V |
| 输出电压： | 2.2 V ~ 36 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 38-WFQFN 裸露焊盘 |
| 供应商设备封装： | 38-QFN（5x7） |
| 包装： | 带卷 (TR) |
| 工作温度： | -40°C ~ 85°C |
LT3476
TYPICAL PERFORMANCE CHARACTERISTICS
T A = 25°C, unless otherwise noted.
120
SHDN and PWM Pins Current vs
Voltage
1.6
SHDN and PWM Pins Threshold
vs Temperature
36.0
CAP Pins Overvoltage Threshold
vs Temperature
100
80
60
40
20
PWM 1-4
SHDN
1.4
1.2
1.0
0.8
0.6
35.5
35.0
34.5
34.0
33.5
0
0
4
8
12
16
0.4
–45
–20
5
30
55
80
105
130
33.0
–45
–20
5
30
55
80
105
130
PIN VOLTAGE (V)
PIN FUNCTIONS
3476 G10
TEMPERATURE (°C)
3476 G11
TEMPERATURE (°C)
3476 G12
VC1, VC4, VC3, VC2, (Pins 1, 12, 13, 38): Error Ampli-
fier Compensation Pin. When PWM is low, VC pin floats
external compensation capacitor to save state for next cycle.
LED1, LED2, LED3, LED4, (Pins 2, 5, 8, 11): Non-
Inverting Input of Current Sense Error Amplifier. Connect
directly to LED current sense resistor terminal. Switcher
will regulate this node to a voltage of 0.1 ? V ADJ below the
CAP node. Also connected to CAP node through external
sense resistor and to anode of LED string. Do not allow
this pin to float independently of corresponding CAP input
pin. In applications where the LED current is low and the
PV IN changes widely, connect the output filter capacitor
to LED n .
CAP1, CAP2, CAP3, CAP4, (Pins 3, 4, 9, 10): Inverting
input of current sense error amplifier. Connect directly to
other terminal of LED current sense resistor. Also con-
nected to output filter capacitor and cathode of external
Schottky rectifier. CAP greater than the overvoltage protect
threshold will inhibit switching.
RT (Pin 6): Oscillator Programming Pin. Place resistor
connected to GND to program oscillator frequency.
REF: (Pin 7): Reference Output Pin. Connect to V ADJ pin
to get full-scale LED current. Connect to resistor dividers
to program V ADJ pins to values lower than 1.05V. Bypass
to local GND with 0.1μF capacitor.
V ADJ4 , V ADJ3 , V ADJ2 , V ADJ1 , (Pins 14, 15, 36, 37): LED
Current Adjustment Pin. Sets voltage across external sense
resistor between CAP n and LED n . Connect directly to
REF for full-scale threshold of 105mV, or use signal vales
between GND and REF to modulate LED current. V ADJ pin
input range is 1.25V maximum.
PWM4, PWM3, PWM2, PWM1, (Pins 16, 17, 34, 35):
Signal low turns off the channel—disables the main switch,
reduces quiescent supply current to the channel, and causes
the VC pin for the channel to become high impedance.
SHDN (Pin 18): Shutdown Pin. Higher than 1.5V turns
the device on.
NC (Pins 19, 20, 21, 30, 31, 32): Not Used. Connect to
GND (Pin 39) for better heat dissipation.
SW4, SW3, SW2, SW1, (Pins 22, 23, 24, 25, 26, 27, 28, 29):
Switch Pin. Connect to external inductor and anode of external
Schottky rectifier. Minimize area of SW trace and use a
GND plane to reduce EMI. Adjacent pins of same name
are internally connected.
V IN (Pin 33): Input Supply Pin. Must be locally bypassed.
GND (Pin 39): Signal and Power GND. Solder exposed
pad directly to ground plane. The exposed pad metal of
the package provides both electrical contact to ground
and good thermal contact to the printed circuit board. It
must be soldered to the circuit board for proper operation.
3476fb
5
相关PDF资料 |
PDF描述 |
|---|---|
| GMC06DREH | CONN EDGECARD 12POS .100 EYELET |
| P51-100-S-L-I12-4.5V-000-000 | SENSOR 100PSI M10-1.25 6H 4.5V |
| NPH15S4812IC | CONV DC/DC 15W48VIN 12.1VOUT DIP |
| P51-75-S-A-P-4.5OVP-000-000 | SENSOR 75PSI 1/4-18NPT .5-4.5V |
| GEC06DRAI | CONN EDGECARD 12POS R/A .100 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3476IUHF#PBF | 功能描述:IC LED DRVR HP CONST CURR 38QFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND |
| LT3476IUHF#TRPBF | 功能描述:IC LED DRVR HP CONST CURR 38QFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND |
| LT3477 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Full-Featured LED Driver with 1.5A Switch Current |
| LT3477EFE | 制造商:Linear Technology 功能描述:LED DRVR 4Segment 3.3V/5V/9V/12V/15V/18V/24V 20-Pin TSSOP EP |
| LT3477EFE#PBF | 功能描述:IC LED DRVR HP CONS CURR 20TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:60 系列:- 恒定电流:- 恒定电压:- 拓扑:线性（LDO），PWM，升压（升压） 输出数:8 内部驱动器:是 类型 - 主要:背光 类型 - 次要:RGB，白色 LED 频率:500kHz ~ 1.5MHz 电源电压:4.75 V ~ 26 V 输出电压:45V 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:* 工作温度:-40°C ~ 85°C |
发布紧急采购，3分钟左右您将得到回复。