- 您现在的位置：买卖IC网 > PDF目录20848 > LT3478IFE-1#PBF (Linear Technology)IC LED DRVR HP CONS CURR 16TSSOP PDF资料下载
参数资料
| 型号： | LT3478IFE-1#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 13/24页 |
| 文件大小： | 0K |
| 描述： | IC LED DRVR HP CONS CURR 16TSSOP |
| 标准包装： | 95 |
| 恒定电流： | 是 |
| 拓扑： | PWM，降压（降压），升压（升压） |
| 输出数： | 1 |
| 内部驱动器： | 是 |
| 类型 - 主要： | 车载，背光 |
| 类型 - 次要： | 颜色，白色 LED |
| 频率： | 200kHz ~ 2.25MHz |
| 电源电压： | 2.8 V ~ 36 V |
| 输出电压： | 42V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-TSSOP（0.173"，4.40mm）裸露焊盘 |
| 供应商设备封装： | 16-TSSOP-EP |
| 包装： | 管件 |
| 工作温度： | -40°C ~ 125°C |
| 产品目录页面： | 1339 (CN2011-ZH PDF) |
LT3478/LT3478-1
APPLICATIO S I FOR ATIO
CTRL2 to achieve the desired CTRL2 curve vs temperature.
The current derating curve shown in Figure 6 uses the
resistor network shown in option C of Figure 7.
to obtain a resistor’s exact values over temperature from
the manufacturer. Hand calculations of CTRL2 voltage
can then be performed at each given temperature and the
resulting CTRL2 curve plotted versus temperature. Several
10
V REF
iterations of resistor value calculations may be required
R2
R4
13
12
LT3478/LT3478-1
CTRL2
CTRL1
to achieve the desired breakpoint and slope of the LED
current derating curve.
Table 5. NTC Resistor Manufacturers/Distributors
R1
R3
OPTION A TO D
MANUFACTURER
Murata Electronics North America
www.murata.com
R Y
R Y
TDK Corporation
Digi-key
www.tdk.com
www.digikey.com
R NTC
R NTC
R X R NTC
R NTC
R X
If calculation of CTRL2 voltage at various temperatures
A
B
C
D
3478 F07
gives a downward slope that is too strong, alternative
Figure 7. Programming LED Current Derating Curve
vs Temperature (R NTC Located on LEDs PCB)
1100
1000
900
resistor networks can be chosen (B, C, D in Figure 7)
which use temperature independent resistance to reduce
the effects of the NTC resistor over temperature.
Murata Electronics provides a selection of NTC resistors
with complete data over a wide range of temperatures. In
800
700
600
CTRL1
addition, a software tool is available which allows the user
to select from different resistor networks and NTC resistor
values and then simulate the exact output voltage curve
CTRL2
LED CURRENT = MINIMUM
500
400
300
200
100 OF CTRL1, CTRL2
R3 = OPTION C
0
0 25 50 75
T A AMBIENT TEMPERATURE ( ° C)
100
(CTRL2 behavior) over temperature. Referred to as the
‘Murata Chip NTC Thermistor Output Voltage Simulator’,
users can log onto www.murata.com/designlib and down-
load the software followed by instructions for creating an
output voltage V OUT (CTRL2) from a speci?ed V CC supply
(V REF ). At any time during selection of circuit parameters
3478 F08
Figure 8. CTRL1, 2 Programmed Voltages vs Temperature
Table 5 shows a list of manufacturers/distributors of NTC
resistors. There are several other manufacturers available
and the chosen supplier should be contacted for more
detailed information. To use an NTC resistor to indicate
LED temperature it is only effective if the resistor is con-
nected as close as possible to the LED(s). LED derating
curves shown by manufacturers are listed for ambient
temperature. The NTC resistor should be submitted to
the same ambient temperature as the LED(s). Since the
temperature dependency of an NTC resistor can be non-
linear over a wide range of temperatures it is important
the user can access data on the chosen NTC resistor by
clicking on a link to the Murata catalog.
The following example uses hand calculations to derive
the resistor values required for CTRL1 and CTRL2 pin
voltages to achieve a given LED current derating curve.
The resistor values obtained using the Murata simulation
tool are also provided and were used to create the derating
curve shown in Figure 6. The simulation tool illustrates
the non-linear nature of the NTC resistor temperature
coef?cient at temperatures exceeding 50°C ambient. In
addition, the resistor divider technique using an NTC
resistor to derive CTRL2 voltage inherently has a ?atten-
ing characteristic (reduced downward slope) at higher
temperatures. To avoid LED current exceeding a maximum
34781f
13
相关PDF资料 |
PDF描述 |
|---|---|
| VLCF4020T-100MR85 | INDUCTOR POWER 10UH .85A SMD |
| P51-1000-S-Y-MD-4.5V-000-000 | SENSOR 1000PSI 7/16-20-2B 4.5V |
| P51-75-A-AA-M12-4.5OVP-000-000 | SENSOR 75PSI 7/16-20UNF .5-4.5V |
| REC5-0505SRW/H2/C/SMD-R | CONV DC/DC 5W 4.5-9VIN 05VOUT |
| P51-1000-S-J-I12-4.5V-000-000 | SENSOR 1000PSI 3/8-24 UNF 4.5V |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3479 | 制造商:LINER 制造商全称:Linear Technology 功能描述:700mA Low Noise High Current LED Charge Pump |
| LT3479EDE | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Up 2.5V to 24V 14-Pin DFN EP |
| LT3479EDE#PBF | 功能描述:IC REG BOOST INV ADJ 3A 14DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LT3479EDE#PBF | 制造商:Linear Technology 功能描述:DC-DC CONVERTER CURRENT MODE 制造商:Linear Technology 功能描述:DC-DC CONVERTER, CURRENT MODE, 3.5MHZ, D |
| LT3479EDE#TRPBF | 功能描述:IC REG BOOST INV ADJ 3A 14DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
发布紧急采购，3分钟左右您将得到回复。