- 您现在的位置：买卖IC网 > PDF目录20627 > LT3500EDD#TRPBF (Linear Technology)IC REG DL BUCK/LINEAR 12-DFN PDF资料下载
参数资料
| 型号： | LT3500EDD#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 10/28页 |
| 文件大小： | 322K |
| 描述： | IC REG DL BUCK/LINEAR 12-DFN |
| 标准包装： | 2,500 |
| 拓扑： | 降压（降压）（1），线性（LDO）（1） |
| 功能： | 任何功能 |
| 输出数： | 2 |
| 频率 - 开关： | 500kHz ~ 2.4MHz |
| 电压/电流 - 输出 1： | 0.8 V ~ 38.9 V，2A |
| 电压/电流 - 输出 2： | 可调式，13mA |
| 带 LED 驱动器： | 无 |
| 带监控器： | 无 |
| 带序列发生器： | 无 |
| 电源电压： | 3 V ~ 36 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 12-WFDFN 裸露焊盘 |
| 供应商设备封装： | 12-DFN |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LT3500
10
3500fc
OPERATION
The LT3500 is a constant frequency, current mode buck
converter with an internal 2.3A switch plus a linear regula-
tor with 13mA output capability. Control of both outputs
is achieved with a common SHDN pin, internal regulator,
oscillator, undervoltage detect, soft-start, thermal shut-
down and power-on reset.
If the SHDN pin is taken below its 0.8V threshold, the
LT3500 will be placed in a low quiescent current mode.
In this mode the LT3500 typically draws 12糀 from the
V
IN
pin.
When the SHDN pin is oated or driven above 0.76V, the
internal bias circuits turn on generating an internal regu-
lated voltage, 0.8(V
FB
) and 1V(R
T
/SYNC) references, and
a POR signal which sets the soft-start latch.
As the R
T
/SYNC pin reaches its 1V regulation point, the
internal oscillator will start generating a clock signal at a
frequency determined by the resistor from the R
T
/SYNC
pin to ground. Alternatively, if a synchronization signal is
detected by the LT3500 at the R
T
/SYNC pin, a clock signal
will be generated at the incoming frequency on the rising
edge of the synchronization pulse. In addition, the internal
slope compensation will be automatically adjusted to pre-
vent subharmonic oscillation during synchronization.
The LT3500 is a constant frequency, current mode step-
down converter. Current mode regulators are controlled
by an internal clock and two feedback loops that control
the duty cycle of the power switch. In addition to the
normal error ampli er, there is a current sense ampli er
that monitors switch current on a cycle-by-cycle basis.
This technique means that the error ampli er commands
current to be delivered to the output rather than voltage.
A voltage fed system will have low phase shift up to the
resonant frequency of the inductor and output capacitor,
then an abrupt 180?shift will occur. The current fed system
will have 90?phase shift at a much lower frequency, but
will not have the additional 90?shift until well beyond
the LC resonant frequency. This makes it much easier to
frequency compensate the feedback loop and also gives
much quicker transient response.
During power up, the POR signal sets the soft-start latch,
which discharges the SS pin to ensure proper start-up
operation. When the SS pin voltage drops below 100mV,
the V
C
pin is driven low disabling switching and the soft-
start latch is reset. Once the latch is reset the soft-start
capacitor starts to charge with a typical value of 2.75糀.
As the voltage rises above 100mV on the SS pin, the V
C
pin will be driven high by the error ampli er. When the
voltage on the V
C
pin exceeds 0.8V, the clock set-pulse sets
the driver ip- op which turns on the internal power NPN
switch. This causes current from V
IN
, through the NPN
switch, inductor and internal sense resistor, to increase.
When the voltage drop across the internal sense resistor
exceeds a predetermined level set by the voltage on the
V
C
pin, the ip- op is reset and the internal NPN switch
is turned off. Once the switch is turned off the inductor
will drive the voltage at the SW pin low until the external
Schottky diode starts to conduct, decreasing the current
in the inductor. The cycle is repeated with the start of each
clock cycle. However, if the internal sense resistor voltage
exceeds the predetermined level at the start of a clock cycle,
the ip- op will not be set resulting in a further decrease in
inductor current. Since the output current is controlled by
the V
C
voltage, output regulation is achieved by the error
ampli er continually adjusting the V
C
pin voltage.
The error ampli er is a transconductance ampli er that
compares the FB voltage to either the SS pin voltage minus
100mV or an internally regulated 800mV, whichever is
lowest. Compensation of the loop is easily achieved with
a simple capacitor or series resistor/capacitor from the
V
C
pin to ground.
Since the SS pin is driven by a constant current source, a
single capacitor on the soft-start pin will generate controlled
linear ramp on the output voltage.
If the current demanded by the output exceeds the maxi-
mum current dictated by the V
C
pin clamp, the SS pin
will be discharged, lowering the regulation point until the
output voltage can be supported by the maximum current.
When overload is removed, the output will soft-start from
the overload regulation point.
相关PDF资料 |
PDF描述 |
|---|---|
| EYM12DTAD-S189 | CONN EDGECARD 24POS R/A .156 SLD |
| FIN1.50RD25 | FIREFLEX FIBERGLASS 1.5" RED 25' |
| T95Y686K004LZAL | CAP TANT 68UF 4V 10% 2910 |
| EEM25DTAD-S189 | CONN EDGECARD 50POS R/A .156 SLD |
| M7VXK-0910R | D-SUB CABLE - MMU09K/MC10M/X |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3500EMSE#PBF | 功能描述:IC REG DL BUCK/LINEAR 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 + 切换式 系列:- 标准包装:2,500 系列:- 拓扑:降压（降压）同步（3），线性（LDO）（2） 功能:任何功能 输出数:5 频率 - 开关:300kHz 电压/电流 - 输出 1:控制器 电压/电流 - 输出 2:控制器 电压/电流 - 输出 3:控制器 带 LED 驱动器:无 带监控器:无 带序列发生器:是 电源电压:5.6 V ~ 24 V 工作温度:-40°C ~ 85°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:* |
| LT3500EMSE#TRPBF | 功能描述:IC REG DL BUCK/LINEAR 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 + 切换式 系列:- 标准包装:2,500 系列:- 拓扑:降压（降压）同步（3），线性（LDO）（2） 功能:任何功能 输出数:5 频率 - 开关:300kHz 电压/电流 - 输出 1:控制器 电压/电流 - 输出 2:控制器 电压/电流 - 输出 3:控制器 带 LED 驱动器:无 带监控器:无 带序列发生器:是 电源电压:5.6 V ~ 24 V 工作温度:-40°C ~ 85°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:* |
| LT3500EMSE-PBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic 2A Step-Down Regulator Plus Linear Regulator/Controller |
| LT3500EMSE-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic 2A Step-Down Regulator Plus Linear Regulator/Controller |
| LT3500HDD#PBF | 功能描述:IC REG DL BUCK/LINEAR 12-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 + 切换式 系列:- 标准包装:2,500 系列:- 拓扑:降压（降压）同步（3），线性（LDO）（2） 功能:任何功能 输出数:5 频率 - 开关:300kHz 电压/电流 - 输出 1:控制器 电压/电流 - 输出 2:控制器 电压/电流 - 输出 3:控制器 带 LED 驱动器:无 带监控器:无 带序列发生器:是 电源电压:5.6 V ~ 24 V 工作温度:-40°C ~ 85°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:* |
发布紧急采购，3分钟左右您将得到回复。