- 您现在的位置：买卖IC网 > PDF目录20624 > LT3500HMSE#PBF (Linear Technology)IC REG DL BUCK/LINEAR 16-MSOP PDF资料下载
参数资料
| 型号： | LT3500HMSE#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 15/28页 |
| 文件大小： | 322K |
| 描述： | IC REG DL BUCK/LINEAR 16-MSOP |
| 标准包装： | 37 |
| 拓扑： | 降压（降压）（1），线性（LDO）（1） |
| 功能： | 任何功能 |
| 输出数： | 2 |
| 频率 - 开关： | 500kHz ~ 2.4MHz |
| 电压/电流 - 输出 1： | 0.8 V ~ 38.9 V，2A |
| 电压/电流 - 输出 2： | 可调式，13mA |
| 带 LED 驱动器： | 无 |
| 带监控器： | 无 |
| 带序列发生器： | 无 |
| 电源电压： | 3 V ~ 36 V |
| 工作温度： | -40°C ~ 150°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-TFSOP（0.118"，3.00mm 宽）裸露焊盘 |
| 供应商设备封装： | 16-MSOP，裸露焊盘 |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页当前第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LT3500
15
3500fc
The frequency, V
IN
to V
OUT1
ratio, and maximum load
current requirement of the LT3500 along with the input
supply source impedance, determine the energy storage
requirements of the input capacitor. Determine the worst-
case condition for input ripple current and then size the
input capacitor such that it reduces input voltage ripple to
an acceptable level. Typical values for input capacitors run
from 10糉 at low frequencies to 2.2糉 at higher frequencies.
The combination of small size and low impedance (low
equivalent series resistance or ESR) of ceramic capacitors
make them the preferred choice. The low ESR results in
very low voltage ripple and the capacitors can handle plenty
of ripple current. They are also comparatively robust and
can be used in this application at their rated voltage. X5R
and X7R types are stable over temperature and applied
voltage, and give dependable service. Other types (Y5V and
Z5U) have very large temperature and voltage coef cients
of capacitance, so they may have only a small fraction of
their nominal capacitance in your application. While they
will still handle the RMS ripple current, the input voltage
ripple may become fairly large, and the ripple current may
end up owing from your input supply or from other by-
pass capacitors in your system, as opposed to being fully
sourced from the local input capacitor. An alternative to a
high value ceramic capacitor is a lower value along with
a larger electrolytic capacitor, for example a 1糉 ceramic
capacitor in parallel with a low ESR tantalum capacitor.
For the electrolytic capacitor, a value larger than 10糉 will
be required to meet the ESR and ripple current require-
ments. Because the input capacitor is likely to see high
surge currents when the input source is applied, tantalum
capacitors should be surge rated. The manufacturer may
also recommend operation below the rated voltage of the
capacitor. Be sure to place the 1糉 ceramic as close as
possible to the V
IN
and GND pins on the IC for optimal
noise immunity.
A nal caution regarding the use of ceramic capacitors for
input bypassing. A ceramic input capacitor can combine
with stray inductance to form a resonant tank circuit. If
power is applied quickly (for example, by plugging the
circuit into a live power source) this tank can ring, doubling
the input voltage and damaging the LT3500. The solution is
to either clamp the input voltage or dampen the tank circuit
by adding a lossy capacitor in parallel with the ceramic
capacitor. For details see Application Note 88.
Output Capacitor Selection
Typically step-down regulators are easily compensated with
an output crossover frequency that is 1/10 of the switch-
ing frequency. This means that the time that the output
capacitor must supply the output load during a transient
step is ~2 or 3 switching periods. With an allowable 5%
drop in output voltage during the step, a good starting
value for the output capacitor can be expressed by:
C
VOUT1
=
Max Load Step
Frequency"0.05"V
OUT1
Example:
V
OUT1
= 3.3V, Frequency = 1MHz, Max Load Step =
2A
C
VOUT1
=
2
1MHz"0.05"3.3
=12糉
The calculated value is only a suggested starting value.
Increase the value if transient response needs improvement
or reduce the capacitance if size is a priority. The output
capacitor lters the inductor current to generate an output
with low voltage ripple. It also stores energy in order to
satisfy transient loads and to stabilize the LT3500s control
loop. The switching frequency of the LT3500 determines
APPLICATIONS INFORMATION
相关PDF资料 |
PDF描述 |
|---|---|
| 591D477X96W3R2T20H | CAP TANT 470UF 6.3V 10% 2824 |
| LT3694IUFD-1#PBF | IC REG TRPL BUCK/LINEAR 28QFN |
| GSA50DTBZ-S664 | CONN EDGECARD 100PS R/A .125 SLD |
| LQW18AN12NJ00D | INDUCTOR 12NH 600MA 0603 |
| LT3694IUFD#PBF | IC REG TRPL BUCK/LINEAR 28QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3500HMSE-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic 2A Step-Down Regulator Plus Linear Regulator/Controller |
| LT3500IDD#PBF | 功能描述:IC REG DL BUCK/LINEAR 12-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 + 切换式 系列:- 标准包装:2,500 系列:- 拓扑:降压（降压）同步（3），线性（LDO）（2） 功能:任何功能 输出数:5 频率 - 开关:300kHz 电压/电流 - 输出 1:控制器 电压/电流 - 输出 2:控制器 电压/电流 - 输出 3:控制器 带 LED 驱动器:无 带监控器:无 带序列发生器:是 电源电压:5.6 V ~ 24 V 工作温度:-40°C ~ 85°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:* |
| LT3500IDD#TRPBF | 功能描述:IC REG DL BUCK/LINEAR 12-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 + 切换式 系列:- 标准包装:2,500 系列:- 拓扑:降压（降压）同步（3），线性（LDO）（2） 功能:任何功能 输出数:5 频率 - 开关:300kHz 电压/电流 - 输出 1:控制器 电压/电流 - 输出 2:控制器 电压/电流 - 输出 3:控制器 带 LED 驱动器:无 带监控器:无 带序列发生器:是 电源电压:5.6 V ~ 24 V 工作温度:-40°C ~ 85°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:* |
| LT3500IDD-PBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic 2A Step-Down Regulator Plus Linear Regulator/Controller |
| LT3500IDD-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic 2A Step-Down Regulator Plus Linear Regulator/Controller |
发布紧急采购，3分钟左右您将得到回复。