- 您现在的位置：买卖IC网 > PDF目录14835 > LT3505EDD#PBF (Linear Technology)IC REG BUCK ADJ 1.2A 8DFN PDF资料下载
参数资料
| 型号： | LT3505EDD#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 9/24页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK ADJ 1.2A 8DFN |
| 标准包装： | 121 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.78 V ~ 33.8 V |
| 输入电压： | 3.6 V ~ 36 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 200kHz ~ 3.01MHz |
| 电流 - 输出： | 1.2A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-WFDFN 裸露焊盘 |
| 包装： | 管件 |
| 供应商设备封装： | 8-DFN-EP（3x3） |
| 产品目录页面： | 1331 (CN2011-ZH PDF) |
LT3505
APPLICATIONS INFORMATION
R 1 = R 2 ? OUT – 1 ?
V OUT + V D
V IN – V SW + V D
V OUT + V D
V IN ( MIN ) = – V D + V SW
FBResistorNetwork
The output voltage is programmed with a resistor divider
between the output and the FB pin. Choose the 1% resis-
tors according to:
? V ?
? 0 . 78 V ?
R2 should be 20k or less to avoid bias current errors.
Reference designators refer to the Block Diagram.
Input Voltage Range
The input voltage range for LT3505 applications depends
on the output voltage, on the absolute maximum ratings
of the V IN and BOOST pins, and on the programmed
switching frequency.
The minimum input voltage is determined by either the
LT3505’s minimum operating voltage of 3.6V, or by its
maximum duty cycle. The duty cycle is the fraction of
time that the internal switch is on and is determined by
the input and output voltages:
DC =
where V D is the forward voltage drop of the catch diode
(~0.4V) and V SW is the voltage drop of the internal switch
(~0.4V at maximum load). This leads to a minimum input
voltage of:
DC MAX
with DC MAX = 1 – f SW /8.33, where f SW is in MHz.
The maximum input voltage is determined by the abso-
lute maximum ratings of the V IN and BOOST pins. For
constant-frequency operation, the maximum input voltage
is determined by the minimum duty cycle requirement.
As the input voltage increases, the required duty cycle
to regulate the output voltage decreases. The minimum
duty-cycle is:
DC MIN = f SW ? t ON(MIN)
where f SW is the switching frequency in hertz and t ON(MIN) is
the worst-case minimum on-time in seconds. The minimum
on-time of the LT3505 is a strong function of temperature.
The typical performance characteristics section of the
datasheet contains a graph of minimum on-time versus
temperature to help determine the worst-case minimum
on-time for the intended application.
If the input voltage is high enough that the duty-cycle
requirement is lower than DC MIN , the part enters pulse-
skipping mode. Speci?cally, the onset of pulse-skipping
occurs at:
V IN(PS) = (V OUT + V D ) / DC MIN – V D + V SW
Above V IN(PS) the part turns on for brief periods of time
to control the inductor current and regulate the output
voltage, possibly producing a spectrum of frequencies
below the programmed switching frequency. To remain
in constant-frequency operation the input voltage should
remain below V IN(PS) . See the “Minimum On Time” sec-
tion of the data sheet for more information on operating
above V IN(PS) .
Note that this is a restriction on the operating input voltage
to remain in constant-frequency operation; the circuit will
tolerate brief transient inputs up to the absolute maximum
ratings of the V IN and BOOST pins when the output is in
regulation. The input voltage should be limited to V IN(PS)
during overload conditions (short-circuit or start-up).
Minimum On Time
For switching frequencies less than 750kHz, the part
will still regulate the output at input voltages that exceed
V IN(PS) (up to 40V), however, the output voltage ripple
increases as the input voltage is increased. Figure 1 il-
lustrates switching waveforms in continuous mode for a
3V output application near V IN(PS) = 33V.
As the input voltage is increased, the part is required to
switch for shorter periods of time. Delays associated with
turning off the power switch determine the minimum on
time of the part. The worst-case typical minimum on-time
is 130ns. Figure 2 illustrates the switching waveforms
when the input voltage is increased to V IN = 35V.
3505fc
9
相关PDF资料 |
PDF描述 |
|---|---|
| MAX6464UK44+T | IC VOLT DETECTOR LP SOT23-5 |
| VI-BTY-EY-F1 | CONVERTER MOD DC/DC 3.3V 33W |
| RCM25DREF | CONN EDGECARD 50POS .156 EYELET |
| EBM40DRSN | CONN EDGECARD 80POS DIP .156 SLD |
| RBA36DTMN | CONN EDGECARD 72POS R/A .125 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3505EDD-TR | 制造商:LINER 制造商全称:Linear Technology 功能描述:1.2A, Step-Down Switching Regulator in 3mm × 3mm DFN |
| LT3505EDDTRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:1.2A, Step-Down Switching Regulator in 3mm x 3mm DFN |
| LT3505EDD-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:1.2A, Step-Down Switching Regulator in 3mm × 3mm DFN |
| LT3505EMS8E | 制造商:LINER 制造商全称:Linear Technology 功能描述:1.2A, Step-Down Switching Regulator in 3mm × 3mm DFN |
| LT3505EMS8E#PBF | 功能描述:IC REG BUCK ADJ 1.2A 8MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
发布紧急采购，3分钟左右您将得到回复。