- 您现在的位置：买卖IC网 > PDF目录67757 > LT3513EUHF#TRPBF (LINEAR TECHNOLOGY CORP) 3.5 A SWITCHING REGULATOR, 2220 kHz SWITCHING FREQ-MAX, PQCC38 PDF资料下载
参数资料
| 型号： | LT3513EUHF#TRPBF |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | 3.5 A SWITCHING REGULATOR, 2220 kHz SWITCHING FREQ-MAX, PQCC38 |
| 封装： | 5 X 7 MM, LEAD FREE, PLASTIC, MO-220WHKD, QFN-38 |
| 文件页数： | 21/22页 |
| 文件大小： | 374K |
| 代理商： | LT3513EUHF#TRPBF |
LT3513
8
3513fc
FB5 (Pin 1): Feedback Pin. Tie the resistor tap to this pin
and set the output of the LDO according to VLDO = 0.625
(1 + R14/R15). Reference designators refer to Figure 1.
VC1 (Pin 2): Control Voltage and Compensation Pin for
Internal Error Amplifier. Connect a series RC from this pin
to ground to compensate switching regulator 1.
RUN-SS3/4 (Pin 3): Run/Soft-Start Pin. This is the soft-
start pin for switching regulators 3 and 4. Place a soft-start
capacitor here to limit start-up inrush current and output
voltage ramp rate. When the BIAS pin reaches 2.25V, a 2A
current source charges the capacitor. When the voltage at
this pin reaches 0.8V, switches 3 and 4 turn on and begin
switching. For slower start-up use a larger capacitor. For
complete shutdown tie RUN-SS3/4 to ground.
FB3 (Pin 4): Feedback Pin. Tie the resistor tap to this pin
and set VON according to VON = 1.22V (1 + R8/R9) –
150mV. Reference designators refer to Figure 1.
RUN-SS2 (Pin 5): Run/Soft-Start Pin. This is the soft-start
pin for switching regulator 2. Place a soft-start capacitor
here to limit start-up inrush current and output voltage
ramp rate. When the BIAS pin reaches 2.25V, a 2A cur-
rent source charges the capacitor. When the voltage at this
pin reaches 0.8V, switch 2 turns on and begins switching.
For slower start-up use a larger capacitor. For complete
shutdown tie RUN-SS2 to ground.
SW3 (Pin 6): Switch Node. The SW3 pin is the collector of
theinternalNPNbipolartransistorforswitchingregulator3.
Minimize trace area at this pin to keep EMI down.
E3 (Pin 7): This is switching regulator 3’s output and
the emitter of the output disconnect PNP. Tie the output
capacitor and resistor divider here.
VON (Pin 8): This is the delayed output for switching
regulator 3. VON reaches its programmed voltage after the
internal CT timer times out. Protection circuitry ensures
VON is disabled if any of the four outputs are more than
10% below normal voltage. This output is also disabled
when VON_CLK is high.
VONSINK(Pin9):Thisisanopen-collectoroutputcontrolled
by the VON_CLKpin.WhenVON_CLKislow,thispindrawsno
current and when VON_CLK is high, this pin draws current.
VON_CLK (Pin 10): This pin controls the output disconnect
device and the open collector of VONSINK. When this pin is
low, the VON pin is enabled and the VONSINK pin is a high
impedance. When this pin is high, the VON pin is disabled
and the VONSINK pin sinks current to ground.
PGOOD (Pin 11): Power Good Comparator Output. This is
the open collector output of the power good comparator
and can be used in conjunction with an external P-channel
MOSFETtoprovideoutputdisconnectforAVDDasshownin
Figure 2. When switcher 2’s output reaches approximately
90% of its programmed voltage, PGOOD will be pulled to
ground. This will pull down on the gate of the MOSFET,
connecting AVDD. A 100k pull-up resistor between the
source and the gate of the P-channel MOSFET keeps it
off when switcher 2’s output is low.
VC3 (Pin 12): Control Voltage and Compensation Pin for
Internal Error Amplifier. Connect a series RC from this pin
to ground to compensate switching regulator 3.
CT (Pin 13): Timing Capacitor Pin. This is the input to
the VON timer and programs the time delay from all four
feedback pins reaching 1.125V to VON turning on. The CT
capacitor value can be set using the equation C = (20A
tDELAY)/1.1V.
GND (Pins 14, 17, 33): Ground.
SW2 (Pins 15, 16): Switch Node. The SW2 pin is the col-
lector of the internal NPN bipolar transistor for switching
regulator 2. Minimize trace area at this pin to keep EMI
down.
BIAS (Pins 18, 29): The BIAS pin is used to improve effi-
ciencywhenoperatingathigherinputvoltages.Connecting
this pin to the output of switching regulator 1 forces most
of the internal circuitry to draw its operating current from
VLOGIC rather than VIN. The drivers of switches 2, 3 and
4 and the LDO are supplied by BIAS. Switches 2, 3 and 4
and the LDO will not function until the BIAS pin reaches
approximately 2.7V. Both BIAS pins must be tied to VLOGIC.
FB2 (Pin 19): Feedback Pin. Tie the resistor divider tap
to this pin and set AVDD according to AVDD = 1.22V
(1 + R5/R6). Reference designators refer to Figure 2.
pin FuncTions
相关PDF资料 |
PDF描述 |
|---|---|
| LT3513EUHF#PBF | 3.5 A SWITCHING REGULATOR, 2220 kHz SWITCHING FREQ-MAX, PQCC38 |
| LT3513IUHF#TRPBF | 3.5 A SWITCHING REGULATOR, 2220 kHz SWITCHING FREQ-MAX, PQCC38 |
| LT3573EMSE#TRPBF | 1.85 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| LT3573IMSE#PBF | 1.85 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| LT3573EMSE#PBF | 1.85 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3513IUHF#PBF | 功能描述:IC REG 5-OUT FOR TFT-LCD 38QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| LT3513IUHF#TRPBF | 功能描述:IC REG 5-OUT FOR TFT-LCD 38QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| LT3513IUHF-PBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:2MHz High Current 5-Output Regulator for TFT-LCD Panels |
| LT3513IUHF-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:2MHz High Current 5-Output Regulator for TFT-LCD Panels |
| LT3514EFE#PBF | 制造商:Linear Technology 功能描述:IC REG BUCK ADJ 24-TSSOP 制造商:Linear Technology 功能描述:BUCK 350KHZ-2.2MHZ 3.2-36V 制造商:Linear Technology 功能描述:BUCK, 350KHZ-2.2MHZ, 3.2-36V, TSSOP-24 制造商:Linear Technology 功能描述:DC-DC CONV, BUCK, ADJ, 2.1MHZ, TSSOP-24, Primary Input Voltage:36V, No. of Outputs:3, Output Current:2A, No. of Pins:24, Operating Temperature Min:-40C, Operating Temperature Max:125C, MSL:MSL 1 - Unlimited, Package / Case:24-TSSOP |
发布紧急采购，3分钟左右您将得到回复。