- 您现在的位置：买卖IC网 > PDF目录67757 > LT3573EMSE#PBF (LINEAR TECHNOLOGY CORP) 1.85 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO16 PDF资料下载
参数资料
| 型号： | LT3573EMSE#PBF |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | 1.85 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封装： | LEAD FREE, PLASTIC, MSOP-16 |
| 文件页数： | 26/26页 |
| 文件大小： | 1182K |
| 代理商： | LT3573EMSE#PBF |
LT3573
3573fc
applications inForMation
ERROR AMPLIFIER—DYNAMIC THEORY
Due to the sampling nature of the feedback loop, there
are several timing signals and other constraints that are
required for proper LT3573 operation.
Minimum Current Limit
The LT3573 obtains output voltage information from the
SW pin when the secondary winding conducts current.
The sampling circuitry needs a minimum amount of time
to sample the output voltage. To guarantee enough time,
a minimum inductance value must be maintained. The
primary-side magnetizing inductance must be chosen
above the following value:
L
V
t
I
N
V
N
H
V
PRI
OUT
MIN
PS
OUT
PS
≥
=
.
1 4
tMIN = minimum off-time, 350ns
IMIN = minimum current limit, 250mA
The minimum current limit is higher than that on the Elec-
trical Characteristics table due to the overshoot caused by
the comparator delay.
Leakage Inductance Blanking
When the output switch first turns off, the flyback pulse
appears.However,ittakesafinitetimeuntilthetransformer
primary-side voltage waveform approximately represents
the output voltage. This is partly due to the rise time on
the SW node, but more importantly due to the trans-
former leakage inductance. The latter causes a very fast
voltage spike on the primary-side of the transformer that
is not directly related to output voltage (some time is also
required for internal settling of the feedback amplifier
circuitry). The leakage inductance spike is largest when
the power switch current is highest.
In order to maintain immunity to these phenomena, a fixed
delay is introduced between the switch turn-off command
andthebeginningofthesampling.Theblankingisinternally
set to 150ns. In certain cases, the leakage inductance may
not be settled by the end of the blanking period, but will
not significantly affect output regulation.
Selecting RFB and RREF Resistor Values
The expression for VOUT, developed in the Operation sec-
tion, can be rearranged to yield the following expression
for RFB:
R
N
V
FB
REF
PS
OUT
F
TC
BG
=
+
(
) +
a
where,
VOUT = Output voltage
VF = Switching diode forward voltage
a = Ratio of Q1, IC to IE, typically 0.986
NPS = Effective primary-to-secondary turns ratio
VTC = 0.55V
The equation assumes the temperature coefficients of
the diode and VTC are equal, which is a good first-order
approximation.
Strictly speaking, the above equation defines RFB not as an
absolute value, but as a ratio of RREF. So, the next ques-
tion is, “What is the proper value for RREF?” The answer
is that RREF should be approximately 6.04k. The LT3573
is trimmed and specified using this value of RREF. If the
impedance of RREF varies considerably from 6.04k, ad-
ditional errors will result. However, a variation in RREF of
several percent is acceptable. This yields a bit of freedom
in selecting standard 1% resistor values to yield nominal
RFB/RREF ratios.
Tables 1-4 are useful for selecting the resistor values for
RREF and RFB with no equations. The tables provide RFB,
RREF and RTC values for common output voltages and
common winding ratios.
Table 1. Common Resistor Values for 1:1 Transformers
VOUT (V)
NPS
RFB (kΩ)
RREF (kΩ)
RTC (kΩ)
3.3
1.00
18.7
6.04
19.1
5
1.00
27.4
6.04
28
12
1.00
64.9
6.04
66.5
15
1.00
80.6
6.04
80.6
20
1.00
107
6.04
105
相关PDF资料 |
PDF描述 |
|---|---|
| LT3573IMSE#TRPBF | 1.85 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| LT3581EDE#PBF | SWITCHING REGULATOR, PDSO14 |
| LT3581EDE#TRPBF | SWITCHING REGULATOR, PDSO14 |
| LT3581EMSE#PBF | SWITCHING REGULATOR, PDSO16 |
| LT3581EMSE#TRPBF | SWITCHING REGULATOR, PDSO16 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3573EMSETRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Isolated Flyback Converter without an Opto-Coupler |
| LT3573EMSE-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Isolated Flyback Converter Without an Opto-Coupler |
| LT3573IMSE#PBF | 功能描述:IC REG FLYBACK ISO ADJ 16MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LT3573IMSE#PBF | 制造商:Linear Technology 功能描述:DC-DC CONVERTER FLYBACK 1MHZ MSOP-16 制造商:Linear Technology 功能描述:DC-DC CONVERTER, FLYBACK, 1MHZ, MSOP-16 |
| LT3573IMSE#TRPBF | 功能描述:IC REG FLYBACK ISO ADJ 16MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
发布紧急采购，3分钟左右您将得到回复。