- 您现在的位置：买卖IC网 > PDF目录13817 > LT3580MPMS8E#PBF (Linear Technology)IC REG BOOST INV SEPIC 2A 8MSOP PDF资料下载
参数资料
| 型号： | LT3580MPMS8E#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 9/28页 |
| 文件大小： | 0K |
| 描述： | IC REG BOOST INV SEPIC 2A 8MSOP |
| 标准包装： | 50 |
| 类型： | 升压（升压），反相，Sepic |
| 输出数： | 1 |
| 输入电压： | 2.5 V ~ 32 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 200kHz ~ 2.5MHz |
| 电流 - 输出： | 2A |
| 同步整流器： | 无 |
| 工作温度： | -55°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-TSSOP，8-MSOP（0.118"，3.00mm 宽）裸露焊盘 |
| 包装： | 管件 |
| 供应商设备封装： | 8-MSOP-EP |
第1页第2页第3页第4页第5页第6页第7页第8页当前第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LT3580
APPLICATIONS INFORMATION
provided to a load (I OUT ). In order to provide adequate
load current, L should be at least:
for the uncoupled inductor SEPIC and uncoupled inductor
inverting topologies.
2(f) ? I LIM ?
L >
? | V OUT | ? I OUT ?
DC ? V IN
?
? V IN ? η ?
Maximum Inductance: Excessive inductance can reduce
current ripple to levels that are difficult for the current com-
parator (A3 in the Block Diagram) to cleanly discriminate,
thus causing duty cycle jitter and/or poor regulation. The
for boost, topologies, or:
maximum inductance can be calculated by:
2(f) ?? I LIM ?
? I OUT ??
L MAX =
V IN – V CESAT DC
I MIN ? RIPPLE
L >
?
?
DC ? V IN
V OUT ? I OUT
V IN ? η
?
?
?
f
where L MAX is L1||L2 for uncoupled dual inductor topolo-
for the SEPIC and inverting topologies.
where:
L = L1||L2 for uncoupled dual inductor topologies
DC = switch duty cycle (see previous section)
gies and I MIN-RIPPLE is typically 95mA.
Current Rating: Finally, the inductor(s) must have a rating
greater than its peak operating current to prevent inductor
saturation resulting in efficiency loss. In steady state, the
peak input inductor current (continuous conduction mode
only) is given by:
I LIM = switch current limit, typically about 2.4A at 50%
duty cycle (see the Typical Performance Characteristics
section).
I L1 ? PEAK =
V OUT ?I OUT
V IN ? η
+
V IN ? DC
2 ? L1? f
η = power conversion efficiency (typically 88% for
boost and 75% for dual inductor topologies at high
currents).
f = switching frequency
for the boost, uncoupled inductor SEPIC and uncoupled
inductor inverting topologies.
For uncoupled dual inductor topologies, the peak output
inductor current is given by:
Negative values of L indicate that the output load current
I OUT exceeds the switch current limit capability of the
LT3580.
I L2 ? PEAK = I OUT +
V OUT ? ( 1– DC )
2 ? L2 ? f
Avoiding Subharmonic Oscillations: The LT3580’s internal
For the coupled inductor topologies:
I OUT ? 1 +
?+
η ? V IN ?
slopecompensationcircuitwillpreventsubharmonicoscil-
lations that can occur when the duty cycle is greater than
50%, provided that the inductance exceeds a minimum
?
?
V OUT ? V IN ? DC
2 ?L ? f
V ? ( )
L > IN
V IN ? ( 2 ? DC – 1 )
value.Inapplicationsthatoperatewithdutycyclesgreater
than 50%, the inductance must be at least:
2 ? DC – 1
(1 ? DC) ? (f)
for boost, coupled inductor SEPIC, and coupled inductor
inverting topologies, or:
L1 L2 >
(1 ? DC) ? (f)
Note: Inductor current can be higher during load transients.
It can also be higher during start-up if inadequate soft-start
capacitance is used.
Capacitor Selection
Low ESR (equivalent series resistance) capacitors should
be used at the output to minimize the output ripple voltage.
Multilayer ceramic capacitors are an excellent choice, as
they have an extremely low ESR and are available in very
small packages. X5R or X7R dielectrics are preferred, as
3580fg
9
相关PDF资料 |
PDF描述 |
|---|---|
| RCB09DHAN | CONN EDGECARD 18POS R/A .050 SLD |
| VI-24Z-EX-S | CONVERTER MOD DC/DC 2V 30W |
| RCB09DHAD | CONN EDGECARD 18POS R/A .050 SLD |
| VI-24Y-EY-S | CONVERTER MOD DC/DC 3.3V 33W |
| VI-24Y-EX-S | CONVERTER MOD DC/DC 3.3V 49.5W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3581 | 制造商:LINER 制造商全称:Linear Technology 功能描述:3.3A Boost/Inverting DC/DC Converter with Fault Protection |
| LT3581EDE#PBF | 功能描述:IC REG MULTI CONFIG ADJ 14DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LT3581EDE#TRPBF | 功能描述:IC REG MULTI CONFIG ADJ 14DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LT3581EDE-PBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:3.3A Boost/Inverting DC/DC Converter with Fault Protection |
| LT3581EDE-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:3.3A Boost/Inverting DC/DC Converter with Fault Protection |
发布紧急采购，3分钟左右您将得到回复。