- 您现在的位置：买卖IC网 > PDF目录98002 > LT3587EUD#PBF (LINEAR TECHNOLOGY CORP) SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PQCC20 PDF资料下载
参数资料
| 型号： | LT3587EUD#PBF |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PQCC20 |
| 封装： | 3 X 3 MM, LEAD FREE, PLASTIC, QFN-20 |
| 文件页数： | 7/24页 |
| 文件大小： | 395K |
| 代理商： | LT3587EUD#PBF |
LT3587
15
3587fc
APPLICATIONS INFORMATION
However, in the case of a short-circuit fault at the VOUT
pins, the LT3587 will switch continuously because the FB1
or the VFB3 pin is low. While operating in this open-loop
condition, the rising voltage at the CAP pins is limited
only by the protection circuit of their respective output
disconnects. At the worst case, the CAP pin rises to 10V
above the corresponding VOUT pin. So in the case of short-
circuit fault to ground, the voltage on the CAP pins may
reach 10V. When the short-circuit condition is removed,
the VOUT pins rise up to the voltage on the CAP pins,
potentially exceeding the programmed output voltage until
the capacitor voltages fall back into regulation. While this
is harmless to the LT3587, this should be considered in
the context of the external circuitry if short-circuit events
are expected.
Regulating the CAP pins ensures that the voltage on the
VOUT pins never exceeds the set output voltage after a
short-circuit event. However, this setup does not com-
pensate for the voltage drop across the output disconnect,
resulting in an output voltage that is slightly lower than
the voltage set by the feedback resistor. This voltage drop
is equal to the product of the output current and the on
resistance of the PMOS disconnect transistor. This drop
can be accounted for when using the CAP pin as the
feedback node by setting the output voltage according to
the following formula:
Figure 10. Waveforms During Fault
Detection of a Short-Circuit Event
R
FB1 =
V
VOUT1 + IVOUT1 RDISC1 1.22V
13.8
μA
R
FB3 =
V
VOUT3 + IVOUT3 RDISC3 0.8V
14.3
μA
Fault Detection and Indicator
The LT3587 features fault detection on all its outputs and
a fault indicator pin (FLT). The fault detection circuitry is
enabled only when at least one of the channels has com-
pleted the soft-start process and is free running with full
inductor current. Once the fault detection is enabled, the
Fault pin pulls low when any of the feedback voltages (VFB1,
VFB2 or Max(VVFB3,VIFB3)) fall below their regulation value
for more than 16ms.
One particularly important case is an overload or short-
circuit condition on any of the channel outputs. In this case,
if the corresponding loop is unable to bring the output
back into regulation within 16ms, a fault is detected and
the Fault pin is pulled low.
Note that the fault condition is latched. Once the Fault pin
is pulled low, all the three channels are disabled. In order
to enable any of the channels again, reset the part by shut-
ting it down and then turning it on again. This is done by
rst forcing both the EN/SS1 and EN/SS3 pins low below
200mV and then either letting them go high again in a
soft-start process or forcing them high immediately if no
soft-start is desired. Figure 10 shows the waveforms when
a short-circuit condition occurs at Boost1 for more than
16ms as well as the subsequent resetting of the part.
3587 F10
ENSS1/ENSS3
5V/DIV
VNEG
10V/DIV
VVOUT3
20V/DIV
VVOUT1
10V/DIV
VFLT
5V/DIV
100ms/DIV
PART RESET
SHORT
AT VOUT1
Figure 9. Feedback Connection Using the VOUT and CAP Pins
3587 F09
VOUT3
CAP3
VFB3
IFB3
SW2
DN
FB2
GND
CAP1
FB1
VOUT1
LT3587
FLT
B1
EN/SS
B3
EN/SS
SW3
SW1
VIN
VOUT3
CAP3
VFB3
IFB3
SW2
DN
FB2
GND
CAP1
FB1
VOUT1
LT3587
FLT
B1
EN/SS
B3
EN/SS
SW3
SW1
VIN
RVFB3
RFB1
RVFB3
RFB1
相关PDF资料 |
PDF描述 |
|---|---|
| LT3587EUD#TRPBF | SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PQCC20 |
| LT6600CS8#TR | SPECIALTY ANALOG CIRCUIT, PDSO8 |
| LTC1043MD#PBF | SPECIALTY ANALOG CIRCUIT, CDIP18 |
| LTC1043MD883C | SPECIALTY ANALOG CIRCUIT, CDIP18 |
| LTC1147LCS8-3.3#TR | SWITCHING CONTROLLER, 400 kHz SWITCHING FREQ-MAX, PDSO8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3587EUD-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Voltage Monolithic Inverter and Dual Boost |
| LT3590 | 制造商:LINER 制造商全称:Linear Technology 功能描述:60V Triple Step-Down LED Driver Programmable Temperature Protection |
| LT3590EDC#PBF | 制造商:Linear Technology 功能描述:IC LED DRIVER BULK MODE 48V 制造商:Linear Technology 功能描述:IC, LED DRIVER, BULK MODE, 48V |
| LT3590EDC#TRMPBF | 功能描述:IC LED DRIVER WHITE BCKLGT 6-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND |
| LT3590EDC#TRPBF | 功能描述:IC LED DRIVER WHITE BCKLGT 6-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND |
发布紧急采购，3分钟左右您将得到回复。