- 您现在的位置：买卖IC网 > PDF目录13913 > LT3641EFE#TRPBF (Linear Technology)IC REG BUCK SYNC ADJ DL 28TSSOP PDF资料下载
参数资料
| 型号： | LT3641EFE#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 17/28页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ DL 28TSSOP |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 2 |
| 输出电压： | 可调至 1.265V，可调至 0.6V |
| 输入电压： | 2.5 V ~ 42 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 500kHz ~ 2MHz |
| 电流 - 输出： | 1.3A，1.1A |
| 同步整流器： | 两者兼有 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-SOIC（0.173"，4.40mm 宽）裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 28-TSSOP 裸露焊盘 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页当前第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LT3641
APPLICATIONS INFORMATION
Soft-Start
The LT3641 has a soft-start pin for each channel. The
feedback pin voltage is regulated to the lower of the
corresponding SS pin and the internal references, which
is 1.265V for the high voltage channel, and 600mV for the
low voltage channel. A capacitor from the SS pin to ground
EN/UVLO
2V/DIV
V OUT1
2V/DIV
V OUT2
1V/DIV
is charged by an internal 2μA current source resulting in an
output ramping linearly from 0V to the regulated voltage.
The duration of the ramp is:
PGOOD2
2V/DIV
V IN = 12V
500μs/DIV
3641 F04
t SS1 = C SS1 ?
t SS2 = C SS2 ?
1.265V
2μA
600mV
2μA
R T SET = 2MHz
EN2 TIED TO FB2
Figure 3. Soft-Start of LT3641
Shorted-Output Protection
where t SS1 is the ramping time for the SS1 pin, t SS2 is
the ramping time for the SS2 pin, C SS1 is the capacitance
from the SS1 pin to ground, and C SS2 is the capacitance
from the SS2 pin to ground.
At power-up, a latch is set to discharge the SS1 pin.
After the SS1 pin is discharged to below 100mV, the latch
is reset. The internal 2μA current source starts to charge
the SS1 pin when the (BST-SW) voltage is charged to
above 2V.
In the event of V IN undervoltage lockout, or the EN/UVLO
pin being driven below 1.26V, the soft-start latch is set,
triggering a start-up sequence.
A latch is set to discharge the SS2 pin at power-up. After
EN/UVLO is enabled, the V IN2 voltage is above 2.3V, the
EN2 pin is enabled, and the SS2 pin is below 100mV, the
latch is reset. The internal 2μA current source starts to
charge the SS2 pin.
In the event of the V IN2 pin falling below 2.2V, or the EN2
pin going below its threshold, the SS2 discharging latch
If an inductor is chosen that will not saturate excessively,
the LT3641 will tolerate a shorted output. For the high
voltage channel, the DA current comparator extends the
internal oscillator period until the catch diode current is
below its limit. Both the top switch and the DA comparator
have current foldback to help limit load current when the
output is shorted to ground. The DA current limit is 1.7A
when the FB1 voltage is above 0.2V, and is 1A when the
FB1 voltage is below 0.2V. Figure 4 shows the high voltage
channel operation under shorted output.
Because of the low V IN2 voltage, the low voltage channel
does not have current foldback. The low voltage channel
does not extend the internal oscillator in shorted output
condition allowing the high voltage channel to operate
in constant frequency. If the bottom MOSFET current
exceeds the NMOS current limit at the start of a clock
cycle, the top MOSFET is kept off until the overcurrent
situation clears. The inductor valley current is kept below
the NMOS current limit to ensure robustness in shorted
output condition (Figure 5).
is set, triggering a start-up sequence.
The SS pins can also be pulled up by external current
sources or resistors for output tracking. The external pull-
up current should not exceed 100μA for either SS pin.
Figure 3 shows the soft-start for a 3.3V and 1.8V
application.
3641fa
17
相关PDF资料 |
PDF描述 |
|---|---|
| EBM36DCCD-S189 | CONN EDGECARD 72POS R/A .156 SLD |
| LTC3616EUDD#TRPBF | IC REG BUCK SYNC ADJ 6A 24QFN |
| V300B5C150BF3 | CONVERTER MOD DC/DC 5V 150W |
| LTC3412EFE | IC REG BUCK SYNC ADJ 16TSSOP |
| EBM36DCBN-S189 | CONN EDGECARD 72POS R/A .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3641EUFD#PBF | 功能描述:IC REG BUCK SYNC ADJ DL 28QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3641EUFD#TRPBF | 功能描述:IC REG BUCK SYNC ADJ DL 28QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3641HFE#PBF | 功能描述:IC REG BUCK SYNC ADJ DL 28TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3641HFE#TRPBF | 功能描述:IC REG BUCK SYNC ADJ DL 28TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3641IFE#PBF | 功能描述:IC REG BUCK SYNC ADJ DL 28TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
发布紧急采购，3分钟左右您将得到回复。