- 您现在的位置：买卖IC网 > PDF目录1825 > LT3641HFE#TRPBF (Linear Technology)IC REG BUCK SYNC ADJ DL 28TSSOP PDF资料下载
参数资料
| 型号： | LT3641HFE#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 11/28页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ DL 28TSSOP |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 2 |
| 输出电压： | 可调至 1.265V，可调至 0.6V |
| 输入电压： | 2.5 V ~ 42 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 500kHz ~ 2MHz |
| 电流 - 输出： | 1.3A，1.1A |
| 同步整流器： | 两者兼有 |
| 工作温度： | -40°C ~ 150°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-SOIC（0.173"，4.40mm 宽）裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 28-TSSOP 裸露焊盘 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页当前第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LT3641
OPERATION
when the V IN2 pin voltage is above 2.3V, and the EN2 pin
is above its threshold. The internal top power MOSFET is
turned on each cycle at the beginning of each oscillator
cycle, and turned off when the current ?owing through
the top MOSFET reaches a level determined by the voltage
at the VC2 node. An error ampli?er measures the output
voltage through an external resistor divider tied to the FB2
pin and servos the VC2 node. The reference of the error
ampli?er is determined by the lower of the internal 600mV
reference and the voltage at the SS2 pin.
While the top MOSFET is off, the bottom MOSFET is
turned on in an oscillator cycle until the inductor current
starts to reverse. If the inductor current is higher than the
valley current limit at the beginning of an oscillator cycle,
the bottom MOSFET will remain on and prevent the top
MOSFET from turning on until the overcurrent situation
clears, limiting inductor current in shorted output fault.
An internal regulator provides power to the control circuitry.
The regulator draws most power from the V IN2 pin and a
small portion of power from the V IN pin when the V IN2 pin
voltage is higher than 3V. If the voltage at V IN2 pin is lower
than 3V, the regulator draws all power from the V IN pin.
The EN/UVLO pin is used to put the LT3641 in shutdown,
reducing the input current to less than 1μA. The accurate
1.26V threshold of the EN/UVLO pin provides a program-
mable V IN undervoltage lockout through an external resistor
divider tied to the EN/UVLO pin. A 2μA hysteresis current
on the EN/UVLO pin prevents switching noise from shut-
ting down the LT3641.
The LT3641 has an overtemperature protection feature
which disables switching in both channels when the junc-
tion temperature exceeds the overtemperature threshold.
Junction temperature will exceed the maximum operating
junction when overtemperature protection is active.
Internal 2μA current sources charge the SS1 pin and the SS2
pin up to about 2V. Soft-start or output voltage tracking of
the two channels can be independently implemented with
undervoltage condition on the V IN pin triggers an internal
latch that discharges the SS1 pin to below 100mV before
it is released. If the EN2 pin goes below its threshold,
or the V IN2 voltage falls below 2.2V, the SS2 pin will be
discharged to below 100mV before it is released.
To optimize ef?ciency, the LT3641 switches to low ripple
Burst Mode operation in light load situations. Between
switching pulses, control-circuitry current is minimized.
A power good comparator with 40mV of hysteresis trips
when the low voltage channel is enabled and the FB2 pin
is above 550mV. The PGOOD2 pin is an open-drain output
that is pulled low when both the outputs are in regulation.
Power-On Reset and Watchdog Timer
The LT3641 includes one power-on reset timer for each
buck regulator and one common watchdog timer. Power-
on reset and watchdog timers are both adjustable using
external capacitors. Operation can be best understood by
referring to the Timing Diagram.
The RST1 , RST2 and WDO pins are all open-drain outputs
with weak internal pull-ups to about 2V. The RST1 and RST2
pins are pulled low when the LT3641 is enabled and V IN is
above 3.6V. Once the FB1 pin rises above 1.165V, the high
voltage channel reset timer is started and RST1 is released
after the reset timeout period. The low voltage channel reset
timer is started once the FB2 pin rises above 550mV, and
releases RST2 after the reset timeout period.
The watchdog circuit monitors a μP ’s activity. As soon as
RST2 is released, a delay timer is started. The watchdog
timer is started after the delay timer times out. The LT3641
implements windowed watchdog function for higher sys-
tem reliability. The watchdog timer detects falling edges
on the WDI pin. If the falling edges are grouped too close
together or too far apart, the WDO pin is pulled down and
the reset timer is started. When the reset timer times out,
WDO is released and the watchdog timer is again started
after the delay period.
capacitors from the SS1 pin and the SS2 pin to ground. Any
3641fa
11
相关PDF资料 |
PDF描述 |
|---|---|
| LT3650IMSE-8.4#TRPBF | IC CHARGER LI-ION 8.4V 2A 12MSOP |
| LT3652EMSE#PBF | IC BATTERY CHARGER SOLAR 12MSOP |
| LT3653IDCB#TRPBF | IC REG BUCK ADJ 1.2A 8DFN |
| LT3663HMS8E-3.3#PBF | IC REG BUCK 3.3V 1.2A 8MSOP |
| LT3680HMSE#TRPBF | IC REG BUCK ADJ 3.5A 10MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3641IFE#PBF | 功能描述:IC REG BUCK SYNC ADJ DL 28TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3641IFE#TRPBF | 功能描述:IC REG BUCK SYNC ADJ DL 28TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3641IUFD#PBF | 功能描述:IC REG BUCK SYNC ADJ DL 28QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3641IUFD#TRPBF | 功能描述:IC REG BUCK SYNC ADJ DL 28QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3645 | 制造商:LINER 制造商全称:Linear Technology 功能描述:36V 500mA Step-Down Regulator and 200mA LDO |
发布紧急采购，3分钟左右您将得到回复。