- 您现在的位置：买卖IC网 > PDF目录44986 > LT3688HFE#TRPBF (LINEAR TECHNOLOGY CORP) SWITCHING REGULATOR, PDSO24 PDF资料下载
参数资料
| 型号： | LT3688HFE#TRPBF |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | SWITCHING REGULATOR, PDSO24 |
| 封装： | LEAD FREE, PLASTIC, TSSOP-24 |
| 文件页数： | 5/28页 |
| 文件大小： | 415K |
| 代理商： | LT3688HFE#TRPBF |
第1页第2页第3页第4页当前第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LT3688
13
3688f
APPLICATIONS INFORMATION
Setting the Output Voltage
The output voltage is programmed with a resistor divider
between the output and the FB pin. Choose the 1% resistors
according to:
R1
= R2
VOUT
0.8V
–1
For reference designators, refer to the Block Diagram.
Setting the Switching Frequency
The LT3688 uses a constant-frequency PWM architecture
that can be programmed to switch from 350 kHz to 2.2 MHz
by using a resistor tied from the RT pin to ground. Table 1
shows the RT values for various switching frequencies
Table 1. Switching Frequency vs RT
SWITCHING FREQUENCY (MHz)
RT
(kΩ)
0.35
165
0.5
110
0.6
88.7
0.7
75
0.8
64.9
0.9
56.2
1
49.9
1.2
40.2
1.4
33.2
1.6
27.4
1.8
23.2
2.1
20
2.3
17.4
Operating Frequency Tradeoffs
Selection of the operating frequency is a tradeoff between
efciency, component size and maximum input voltage.
The advantage of high frequency operation is that
smaller inductor and capacitor values may be used. The
disadvantages are lower efciency, and narrower input
voltage range at constant-frequency. The highest constant-
switching frequency (fSW(MAX)) for a given application can
be calculated as follows:
fSW(MAX) =
VOUT + VF
tON(MIN) VIN + VF –VSW
()
where VIN is the typical input voltage, VOUT is the output
voltage, VF is the catch diode drop (~0.5V) and VSW is
the internal switch drop (~0.3V at maximum load). If the
LT3688 is programmed to operate at a frequency higher
than fSW(MAX) for a given input voltage, the LT3688 enters
pulse skip mode, where it skips switching cycles to maintain
regulation. At frequencies higher than fSW(MAX), the LT3688
no longer operates with constant frequency. The LT3688
enters pulse skip mode at frequencies higher than fSW(MAX)
because of the limitation on the LT3688’s minimum on time
of 140ns (180ns for TJ>125°C).Astheswitchingfrequency
is increased above fSW(MAX), the part is required to switch
for shorter periods to maintain the same duty cycle. Delays
associated with turning off the power switch dictate the
minimum on-time of the part. When the required on-time
decreases below the minimum on-time of 140ns, the switch
pulse width remains xed at 140ns (instead of becoming
narrower) to accommodate the same duty cycle require-
ment. The inductor current ramps up to a value exceeding
the load current and the output ripple increases. The part
then remains off until the output voltage dips below the
programmed value before it begins switching again.
Maximum Operating Voltage Range
The maximum input voltage for LT3688 applications
depends on switching frequency, the absolute maximum
ratings of the VIN and BST pins, and by the minimum
duty cycle (DCMIN). The LT3688 can operate from input
voltages up to 36V.
DCMIN = tON(MIN) fSW
where tON(MIN) is equal to 140ns and fSW is the switching
frequency. Running at a lower switching frequency allows
a lower minimum duty cycle. The maximum input voltage
before pulse-skipping occurs depends on the output volt-
age and the minimum duty cycle:
VIN(PS) =
VOUT + VF
DCMIN
–VF + VSW
Example: f = 2.1MHz, VOUT = 3.3V
DCMIN = 140ns 2.1MHz = 0.294
VIN(PS) =
3.3V
+ 0.5V
0.294
– 0.5V
+ 0.3V = 12.7V
相关PDF资料 |
PDF描述 |
|---|---|
| LT3689IUD-5#PBF | 1.95 A SWITCHING REGULATOR, 2160 kHz SWITCHING FREQ-MAX, PQCC16 |
| LT3689EMSE-5#TRPBF | 1.95 A SWITCHING REGULATOR, 2160 kHz SWITCHING FREQ-MAX, PDSO16 |
| LT3689EUD-5#TRPBF | 1.95 A SWITCHING REGULATOR, 2160 kHz SWITCHING FREQ-MAX, PQCC16 |
| LT3689EMSE-5#PBF | 1.95 A SWITCHING REGULATOR, 2160 kHz SWITCHING FREQ-MAX, PDSO16 |
| LT3689IUD-5#TRPBF | 1.95 A SWITCHING REGULATOR, 2160 kHz SWITCHING FREQ-MAX, PQCC16 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3688IFE#PBF | 功能描述:IC REG BUCK ADJ 0.8A DL 24TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:MIC23xxx HyperLight Load™ Regulators 标准包装:5,000 系列:HyperLight Load® 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.8V 输入电压:2.7 V ~ 5.5 V PWM 型:混合物 频率 - 开关:4MHz 电流 - 输出:2A 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘，8-MLF? 包装:带卷 (TR) 供应商设备封装:8-MLF?（2x2） 产品目录页面:1094 (CN2011-ZH PDF) 其它名称:576-3303-2 |
| LT3688IFE#TRPBF | 功能描述:IC REG BUCK ADJ 0.8A DL 24TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3688IFEPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual 800mA Step-Down Switching Regulator with Power-On Reset |
| LT3688IUF#PBF | 功能描述:IC REG BUCK ADJ 0.8A DL 24QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:MIC23xxx HyperLight Load™ Regulators 标准包装:5,000 系列:HyperLight Load® 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.8V 输入电压:2.7 V ~ 5.5 V PWM 型:混合物 频率 - 开关:4MHz 电流 - 输出:2A 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘，8-MLF? 包装:带卷 (TR) 供应商设备封装:8-MLF?（2x2） 产品目录页面:1094 (CN2011-ZH PDF) 其它名称:576-3303-2 |
| LT3688IUF#TRPBF | 功能描述:IC REG BUCK ADJ 0.8A DL 24QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
发布紧急采购，3分钟左右您将得到回复。