- 您现在的位置：买卖IC网 > PDF目录15502 > LT3710EFE (Linear Technology)IC REG CTRLR BUCK PWM 16-TSSOP PDF资料下载
参数资料
| 型号： | LT3710EFE |
| 厂商： | Linear Technology |
| 文件页数： | 8/12页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM 16-TSSOP |
| 标准包装： | 95 |
| PWM 型： | 电流/电压模式 |
| 输出数： | 2 |
| 频率 - 最大： | 340kHz |
| 占空比： | 90% |
| 电源电压： | 8 V ~ 24 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 16-TSSOP（0.173"，4.40mm）裸露焊盘 |
| 包装： | 管件 |
| 产品目录页面： | 1332 (CN2011-ZH PDF) |
LT3710
APPLICATIO S I FOR ATIO
V OUT2 = 0 . 8 ? ? 1 +
?
Output N-Channel MOSFET Drivers
The LT3710 employs high speed N-channel MOSFET
synchronous drivers to achieve high system efficiency.
GBIAS is the 8V regulator output to bias and supply the
drivers and should be properly bypassed with a low ESR
capacitor to ground plane. A Schottky catch diode is
required on the switch node.
Light Load Operation
If the BGS pin is grounded, the LT3710 stays in continuous
mode independent of load condition except in soft-start
operation (see Soft-Start section). If the BGS pin is left
open, under light load and V RS1 drops below 8mV, BGATE
will be turned off(see comparator CA2 of Block Diagram)
and the LT3710 goes into discontinous mode operation.
Current Limit
Current limit is set by the 70mV threshold across CL + and
CL – , the inputs of the amplifier CA1. By connecting an
external resistor RS1(see Block Diagram), the current
limit is set for 70mV/R S1 . R6 and C6 stablize the current
limit loop. If current limit is not used, both CL + and CL –
should be grounded and the BGS pin should also be
grounded to disable comparator CA2.
Soft-Start and Shutdown
During soft-start, V SS is the reference voltage that controls
the output voltage and the output ramps up following V SS .
The effective range of V SS is from 0V to V REF . The typical
time for the output to reach the programmed level is
(C ? 0.8V)/10 μ A.
During start up, BGATE will stay off until V SS gets up to
1.6V. This prevents the bottom MOSFET from turning on
if the output is precharged.
To shut down the LT3710, the SS pin should be pulled
below 50mV by a VN2222 type N-channel transistor. Note
that during shutdown BGATE will be locked off when V SS
drops below 0.6V. This prevents the bottom MOSFET from
discharging the output, which would cause the output to
undershoot below ground.
Layout Considerations
For maximum efficiency, the switching rise and fall times
are less than 20ns. To prevent radiation, the power
MOSFETs, SW pin and input bypass capacitor leads should
be kept as short as possible. A ground plane should be
used under the switching circuitry to prevent interplane
coupling and to act as a thermal spreading path. Note that
the bottom metal of the package is the heat sink, as well as
the IC signal ground, and must be soldered to the ground
plane.
Output Voltage Programming
The feedback reference voltage is 0.8V. The output voltage
can be easily programmed by the resistor divider, R3 and
R4, as shown in the Block Diagram.
? R 3 ?
? R 4 ?
Filtering on the SYNC Input
It is necessary to add RC filtering on the SYNC input of the
LT3710 to eliminate the negative glitch at the turn on of the
top MOSFET. When the top MOSFET M1 turns on, the
transformer secondary current instantly changes from the
original first output inductor current to the sum of two
output inductor currents. The high di/dt on the trans-
former leakage inductance causes the transformer sec-
ondary voltage V S to drop for a short interval. If the leakage
inductance is large enough, the V S dip will be lower than
the synchronization threshold (about 2.5V), falsely trig-
gering the synchronization. The top MOSFET is turned off
immediately. As a result, the output voltage will not be
regulated properly.
A filter circuit is needed to ensure proper operation. A
small RC filter with R S = 10k and C S = 10pF are typical.
3710f
8
相关PDF资料 |
PDF描述 |
|---|---|
| SPD62-183M | INDUCTOR PWR SHIELDED 18.0UH SMD |
| LTC3869IUFD#PBF | IC REG CTRLR BUCK PWM CM 28-QFN |
| LT1725CGN#PBF | IC REG CTRLR FLYBK ISO CM 16SSOP |
| LTC3830ES#PBF | IC REG CTRLR BUCK PWM VM 16-SOIC |
| SPD62-153M | INDUCTOR PWR SHIELDED 15.0UH SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3710EFE#PBF | 功能描述:IC REG CTRLR BUCK PWM 16-TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP（0.173"，4.40mm 宽） 包装:带卷 (TR) |
| LT3710EFE#TR | 功能描述:IC REG CTRLR BUCK PWM 16-TSSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LT3710EFE#TRPBF | 功能描述:IC REG CTRLR BUCK PWM 16-TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LT371LF | 制造商:EDSYN 功能描述: |
| LT3724 | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Voltage, Current Mode Switching Regulator Controller |
发布紧急采购，3分钟左右您将得到回复。