- 您现在的位置：买卖IC网 > PDF目录15302 > LT3748EMS#TRPBF (Linear Technology)IC REG CTRLR FLYBK ISO CM 16MSOP PDF资料下载
参数资料
| 型号： | LT3748EMS#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 22/30页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR FLYBK ISO CM 16MSOP |
| 产品培训模块： | LT3748 100V Flyback Controller |
| 标准包装： | 2,500 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 电源电压： | 5 V ~ 100 V |
| 降压： | 无 |
| 升压： | 无 |
| 回扫： | 是 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 是 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 16-TFSOP（0.118"，3.00mm），12 引线 |
| 包装： | 带卷 (TR) |
| 配用： | 732-3308-ND - BOARD EVAL FOR LT3748 732-3305-ND - BOARD EVAL FOR LT3748 |
| 相关产品： | 732-2669-2-ND - TRANS FLYBACK LT3748 20UH SMD 732-2669-6-ND - TRANS FLYBACK LT3748 20UH SMD 732-2668-6-ND - TRANS FLYBACK LT3748 14UH SMD 732-2667-6-ND - TRANS FLYBACK LT3748 500UH SMD 732-2666-6-ND - TRANS FLYBACK LT3748 12UH SMD 732-2665-6-ND - TRANS FLYBACK LT3748 12UH SMD 732-2664-6-ND - TRANS FLYBACK LT3748 15UH SMD 732-2663-6-ND - TRANS FLYBACK LT3748 15UH SMD 732-2662-6-ND - TRANS FLYBACK LT3748 8UH SMD 732-2661-6-ND - TRANS FLYBACK LT3748 8UH SMD 更多... |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页当前第22页第23页第24页第25页第26页第27页第28页第29页第30页
LT3748
APPLICATIONS INFORMATION
6. Select the Feedback Resistor for Proper Output
Voltage
Using the iterative process laid out earlier in the Applications
Information section, select the feedback resistor R FB and
program the output voltage to 5V. Adjust the R TC resistor
for temperature compensation of the output voltage. R REF
is selected as 6.04k.
7. Select the Output Capacitor
The output capacitor should be chosen to minimize the
output voltage ripple while considering the increase in
size and cost of a larger capacitor. The following equation
calculates the output voltage ripple:
clamp was considered in order to maximize efficiency but
was unable to turn on fast enough to sufficiently clamp the
very fast leakage spike. The final solution is an RC snubber,
implemented iteratively, that decreases efficiency by less
than 1% across the majority of the output load range while
reducing the worst-case drain voltage spike to just 80V.
Similarly, the anode of the output diode is probed to look
at potential ringing when the MOSFET switch turns on and
a peak of 45V is measured across the diode. Therefore,
no snubber circuitry is required.
9. Optimize the Compensation Network
To set the compensation, the application is first configured
with a 22nF capacitor and 10k resistor as a starting point. A
Δ V MAX =
L PRI ? I LIM2
2 ? C OUT ? V OUT
load step is applied at both light and heavy loads at the 60V
maximum input voltage and the capacitance is decreased
until damping decreases to the desired limit, in this case
8. Add Snubber Circuitry as Necessary
With the primary components selected, the application
should be constructed to evaluate ringing at the drain of the
MOSFET switch and to evaluate step response to optimize
the compensation network. If using an RC snubber, the
equations from the Applications Information section can
be used or a rough estimate of component values may
come from using the published leakage inductance of the
transformer and selecting a snubber capacitor ranging
from 1 to 3 times larger than the published MOSFET output
capacitance. In this application, the peak MOSFET drain
voltage was measured at maximum load from minimum
V IN and exceeded the 150V rating of the Si7738. A DZ
with a compensation capacitance of 2.2nF and a response
implying about 60? of phase margin. After verifying stability
at the minimum input voltage, as well, the compensation
capacitance is doubled for safety margin. The series resis-
tance is varied from 5k to 50k but the optimal response is
observed with 24.7k. For best ripple performance, select
a compensation capacitor not less than 1nF, and select a
compensation resistor not greater than 50k.
10. Soft-Start Capacitor and UVLO Resistor Divider
A soft-start capacitor helps during the start-up of the
flyback converter. Select the UVLO resistor divider for
the intended input operation range. These equations are
aforementioned.
3748fa
22
相关PDF资料 |
PDF描述 |
|---|---|
| UVY1V222MHD | CAP ALUM 2200UF 35V 20% RADIAL |
| ESA22DRMI | CONN EDGECARD 44POS .125 SQ WW |
| VI-JWL-EW-F1 | CONVERTER MOD DC/DC 28V 100W |
| VI-JWK-EW-F4 | CONVERTER MOD DC/DC 40V 100W |
| ESRD8R2M08B | CAP ALUM 8.2UF 8V 20% SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3748HMS#PBF | 功能描述:IC REG CTRLR FLYBK ISO CM 16MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LT3748HMS#TRPBF | 功能描述:IC REG CTRLR FLYBK ISO CM 16MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LT3748HMSPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:100V Isolated Flyback Controller |
| LT3748HMSTRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:100V Isolated Flyback Controller |
| LT3748IMS#PBF | 功能描述:IC REG CTRLR FLYBK ISO CM 16MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。