参数资料
| 型号： | LT3757EMSE#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 15/36页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR PWM CM 10-MSOP |
| 产品培训模块： | LT3757 and LT3758 - Boost, Flyback, SEPIC and Inverting Controllers |
| 特色产品： | LT3757 - Inverting Controller |
| 标准包装： | 50 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 1MHz |
| 电源电压： | 2.9 V ~ 40 V |
| 降压： | 无 |
| 升压： | 是 |
| 回扫： | 是 |
| 反相： | 是 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 |
| 包装： | 管件 |
| 产品目录页面： | 1332 (CN2011-ZH PDF) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页当前第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
LT3757/LT3757A
APPLICATIONS INFORMATION
I L(MAX) = I O(MAX) ?
R SENSE =
? I L = c ? I L(MAX) = c ? I O(MAX) ?
V IN(MIN)
? I L ? f
I L(PEAK) = I L(MAX) ? ? 1 + ?
c
I L(RMS) = I L(MAX) ? 1 +
BoostConverter:InductorandSenseResistorSelection
For the boost topology, the maximum average inductor
current is:
1
1 ? D MAX
Then, the ripple current can be calculated by:
1
1 ? D MAX
The constant c in the preceding equation represents the
percentage peak-to-peak ripple current in the inductor,
relative to I L(MAX) .
The inductor ripple current has a direct effect on the choice
of the inductor value. Choosing smaller values of ?I L
requires large inductances and reduces the current loop
gain (the converter will approach voltage mode). Accepting
larger values of ?I L provides fast transient response and
allows the use of low inductances, but results in higher input
current ripple and greater core losses. It is recommended
that c fall within the range of 0.2 to 0.6.
Given an operating input voltage range, and having chosen
the operating frequency and ripple current in the inductor,
the inductor value of the boost converter can be determined
using the following equation:
L = ? D MAX
The peak and RMS inductor current are:
? c ?
? 2 ?
2
12
Based on these equations, the user should choose the
inductors having sufficient saturation and RMS current
ratings.
Set the sense voltage at I L(PEAK) to be the minimum of the
SENSE current limit threshold with a 20% margin. The
sense resistor value can then be calculated to be:
80mV
I L(PEAK)
Boost Converter: Power MOSFET Selection
Important parameters for the power MOSFET include the
drain-source voltage rating (V DS ), the threshold voltage
(V GS(TH) ), the on-resistance (R DS(ON) ), the gate to source
and gate to drain charges (Q GS and Q GD ), the maximum
drain current (I D(MAX) ) and the MOSFET’s thermal
resistances (R θ JC and R θ JA ).
The power MOSFET will see full output voltage, plus a
diode forward voltage, and any additional ringing across
its drain-to-source during its off-time. It is recommended
to choose a MOSFET whose B VDSS is higher than V OUT by
a safety margin (a 10V safety margin is usually sufficient).
The power dissipated by the MOSFET in a boost conver-
ter is:
P FET = I 2L(MAX) ? R DS(ON) ? D MAX + 2 ? V 2OUT ? I L(MAX)
? C RSS ? f /1A
The first term in the preceding equation represents the
conduction losses in the device, and the second term, the
switching loss. C RSS is the reverse transfer capacitance,
which is usually specified in the MOSFET characteristics.
For maximum efficiency, R DS(ON) and C RSS should be
minimized. From a known power dissipated in the power
MOSFET, its junction temperature can be obtained using
the following equation:
T J = T A + P FET ? θ JA = T A + P FET ? ( θ JC + θ CA )
T J must not exceed the MOSFET maximum junction
temperature rating. It is recommended to measure the
MOSFET temperature in steady state to ensure that absolute
maximum ratings are not exceeded.
3757afd
15
相关PDF资料 |
PDF描述 |
|---|---|
| MIC2182-3.3YSM | IC REG CTRLR BUCK PWM CM 16-SSOP |
| ABC15DRXN-S734 | CONN EDGECARD 30POS DIP .100 SLD |
| MIC2182YSM | IC REG CTRLR BUCK PWM CM 16-SSOP |
| LTC3853EUJ#TRPBF | IC REG CTRLR BUCK PWM CM 40-QFN |
| LT1619ES8#PBF | IC REG CTRLR PWM CM 8-SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3757EMSE-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Boost, Flyback, SEPIC and Inverting Controller |
| LT3757HMSE | 制造商:LINER 制造商全称:Linear Technology 功能描述:Boost, Flyback, SEPIC and Inverting Controller |
| LT3757HMSE#PBF | 功能描述:IC REG CTRLR PWM CM 10-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LT3757HMSE#PBF | 制造商:Linear Technology 功能描述:DC-DC CONTROLLER SEPIC 1MHZ 制造商:Linear Technology 功能描述:DC-DC CONTROLLER, SEPIC, 1MHZ, MSOP-10 |
| LT3757HMSE#TRPBF | 功能描述:IC REG CTRLR PWM CM 10-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。