- 您现在的位置：买卖IC网 > PDF目录4961 > LT3758EDD#PBF (Linear Technology)IC REG CTRLR BST FLYBK INV 10DFN PDF资料下载
参数资料
| 型号： | LT3758EDD#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 14/36页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BST FLYBK INV 10DFN |
| 标准包装： | 121 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 1MHz |
| 电源电压： | 5.5 V ~ 100 V |
| 降压： | 无 |
| 升压： | 是 |
| 回扫： | 是 |
| 反相： | 是 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 10-WFDFN 裸露焊盘 |
| 包装： | 管件 |
| 产品目录页面： | 1340 (CN2011-ZH PDF) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页当前第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
LT3758/LT3758A
APPLICATIONS INFORMATION
FBX Frequency Foldback
When V OUT is very low during start-up or a GND fault on
the output, the switching regulator must operate at low
duty cycles to maintain the power switch current within
the current limit range, since the inductor current decay
rate is very low during switch off time. The minimum on-
time limitation may prevent the switcher from attaining a
sufficiently low duty cycle at the programmed switching
frequency. So, the switch current will keep increasing
through each switch cycle, exceeding the programmed
current limit. To prevent the switch peak currents from
exceeding the programmed value, the LT3758 contains
a frequency foldback function to reduce the switching
frequency when the FBX voltage is low (see the Normal-
ized Switching Frequency vs FBX graph in the Typical
Performance Characteristics section).
During frequency foldback, external clock synchroniza-
tion is disabled to prevent interference with frequency
reducing operation.
Thermal Lockout
If LT3758 die temperature reaches 165°C (typical), the
part will go into thermal lockout. The power switch will
be turned off. A soft-start operation will be triggered. The
part will be enabled again when the die temperature has
dropped by 5°C (nominal).
Loop Compensation
Loop compensation determines the stability and transient
performance. The LT3758/LT3758A use current mode
control to regulate the output which simplifies loop com-
pensation. The LT3758A improves the no-load to heavy
load transient response, when compared to the LT3758.
New internal circuits ensure that the transient from not
switching to switching at high current can be made in a
few cycles. The optimum values depend on the converter
topology, the component values and the operating condi-
tions (including the input voltage, load current, etc.). To
compensate the feedback loop of the LT3758/LT3758A,
a series resistor-capacitor network is usually connected
from the V C pin to GND. Figure 1 shows the typical V C
compensation network. For most applications, the capacitor
should be in the range of 470pF to 22nF, and the resistor
should be in the range of 5k to 50k. A small capacitor is
often connected in parallel with the RC compensation
network to attenuate the V C voltage ripple induced from the
output voltage ripple through the internal error amplifier.
The parallel capacitor usually ranges in value from 10pF to
100pF. A practical approach to design the compensation
network is to start with one of the circuits in this data sheet
that is similar to your application, and tune the compensa-
tion network to optimize the performance. Stability should
then be checked across all operating conditions, including
load current, input voltage and temperature.
SENSE Pin Programming
For control and protection, the LT3758 measures the
power MOSFET current by using a sense resistor (R SENSE )
between GND and the MOSFET source. Figure 4 shows a
typical waveform of the sense voltage (V SENSE ) across the
sense resistor. It is important to use Kelvin traces between
the SENSE pin and R SENSE , and to place the IC GND as
close as possible to the GND terminal of the R SENSE for
proper operation.
V SENSE
? V SENSE = χ ? V SENSE(MAX)
V SENSE(MAX)
DT S
V SENSE(PEAK)
t
T S
3758 F04
Figure 4. The Sense Voltage During a Switching Cycle
3758afd
14
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3850EGN#PBF | IC REG CTRLR BUCK PWM CM 28-SSOP |
| RCA24DTMH | CONN EDGECARD 48POS R/A .125 SLD |
| AHA475M2AE16B-F | CAP ALUM 4.7UF 100V 20% SMD |
| GMM36DSXI | CONN EDGECARD 72POS DIP .156 SLD |
| RCA24DTMD | CONN EDGECARD 48POS R/A .125 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3758EDDTRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Input Voltage, Boost, Flyback, SEPIC and Inverting Controller |
| LT3758EMSE#PBF | 功能描述:IC REG CTRLR PWM CM 10-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LT3758EMSE#PBF | 制造商:Linear Technology 功能描述:DC-DC CONTROLLER INVERTING 1 制造商:Linear Technology 功能描述:DC-DC CONTROLLER, INVERTING, 1MHZ, MSOP- |
| LT3758EMSE#TRPBF | 功能描述:IC REG CTRLR PWM CM 10-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LT3758EMSEPBF | 制造商:Linear Technology 功能描述:100V Flyback SEPIC Controller MSOP10EP |
发布紧急采购，3分钟左右您将得到回复。