参数资料
| 型号： | LT3782EUFD#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 6/20页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BST PWM CM 28-QFN |
| 标准包装： | 73 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 533kHz |
| 占空比： | 94% |
| 电源电压： | 6 V ~ 40 V |
| 降压： | 无 |
| 升压： | 是 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 28-WFQFN 裸露焊盘 |
| 包装： | 管件 |
| 产品目录页面： | 1332 (CN2011-ZH PDF) |
LT3782
PIN FUNCTIONS
(FE/UFD)
SGATE2 (Pin 1/Pin 26): Second Phase Synchronous Drive
Signal. An external driver buffer is needed to drive the top
synchronous power FET.
SGATE1 (Pin 2/Pin 27): First Phase Synchronous Drive
Signal. An external driver buffer is needed to drive the top
synchronous power FET.
GND (Pin 4/Pin 28): Chip Ground.
SYNC (Pin 5/Pin 1): Synchronization Input. The pulse
width can range from 10% to 70%. Note that the operating
frequency is half of the sync frequency.
DELAY (Pin 6/Pin 2): When synchronous drivers are used,
the programmable delay that delays BGATE turns on after
SGATE turns off.
DCL (Pin 7/Pin 3): This pin programs the limit of the maxi-
mum duty cycle. When connected to V RSET , it operates at
natural maximum duty cycle, approximately 90%.
SENSE1 + (Pin 8/Pin 4): First Phase Current Sense Ampli?er
Positive Input. An RC ?lter is required across the current
sense resistor. Current limit threshold is set at 60mV.
SENSE1 – (Pin 9/Pin 5): First Phase Current Sense Ampli?er
Negative Input. An RC ?lter is required across the current
sense resistor.
SLOPE (Pin 10/Pin 6): A resistor from SLOPE to GND
increases the internal current mode PWM slope com-
pensation.
R SET (Pin 11/Pin 7): A resistor from R SET to GND sets the
oscillator charging current and the operating frequency.
SENSE2 – (Pin 12/Pin 8): Second Phase Current Sense
Ampli?er Negative Input. An RC ?lter is required across
the current sense resistor.
SENSE2 + (Pin 13/Pin 10): Second Phase Current Sense
Ampli?er Positive Input. An RC ?lter is required across
the current sense resistor. Current limit threshold is set
at 60mV.
SS (Pin 14/Pin 11): Soft-Start. A capacitor on this pin sets
V C (Pin 15/Pin 12): The output of the g m error ampli?er and
the control signal of the current loop of the current-mode
PWM. Switching starts at 0.7V, and higher V C voltages
corresponds to higher inductor current.
FB (Pin 16/Pin 13): Error Ampli?er Inverting Input. A
resistor divider to this pin sets the output voltage.
RUN (Pin 17/Pin 14): LT3782 goes into shutdown mode
when V RUN is below 2.2V and goes to low bias current
shutdown mode when V RUN is below 0.3V.
V EE2 (Pin 19/Pin 16): Gate Driver BGATE2 Ground. This
pin should be connected to the ground side of the second
current sense resistor.
BGATE2 (Pin 20/Pin 17): Second Phase MOSFET Driver.
GBIAS2 (Pin 21/Pin 18): Bias for Gate Driver BGATE2.
Should be connected to GBIAS or an external power supply
between 12V to 14V. A bypass low ESR capacitor of 2μF
or larger is needed and should be connected directly to
the pin to minimize parasitic impedance.
GBIAS1 (Pin 22/Pin 21): Bias for Gate Driver BGATE1.
Should be connected to GBIAS2.
BGATE1 (Pin 23/Pin 22): First Phase MOSFET Driver.
V EE1 (Pin 24/Pin 23): Gate Driver BGATE1 Ground. This
pin should be connected to the ground side of the second
current sense resistor.
V CC (Pin 27/Pin 24): Chip Power Supply. Good supply
bypassing is required.
GBIAS (Pin 28/Pin 25): Internal 11V regulator output for
biasing internal circuitry. Should be connected to GBIAS1
and GBIAS2.
Exposed Pad (Pin 29/Pin 29): The exposed package pad
is fused to internal ground and is for heat sinking. Solder
the bottom metal plate onto expanded ground plane for
optimum thermal performance.
NC (Pins 3, 18, 25, 26/Pins 9, 15, 19, 20): Not Connected.
Can be connected to GND.
the output ramp up rate. The typical time for SS to reach
the programmed level is (C ? 2.44V)/10μA.
3782fg
6
相关PDF资料 |
PDF描述 |
|---|---|
| LT3800IFE#PBF | IC REG CTRLR INV PWM CM 16-TSSOP |
| LT3804EFE#PBF | IC REG CTRLR ISO PWM 28-TSSOP |
| LT3825EFE#PBF | IC REG CTRLR FLYBK ISO 16-TSSOP |
| LT3837EFE#PBF | IC REG CTRLR FLYBK ISO 16-TSSOP |
| LT3844EFE#PBF | IC REG CTRLR BST INV PWM 16TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3782EUFD-TR | 制造商:LINER 制造商全称:Linear Technology 功能描述:2-Phase Step-UP DC/DC Controller |
| LT3782EUFD-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:2-Phase Step-UP DC/DC Controller |
| LT3782IFE | 制造商:LINER 制造商全称:Linear Technology 功能描述:2-Phase Step-UP DC/DC Controller |
| LT3782IFE#PBF | 功能描述:IC REG CTRLR BST PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LT3782IFE#TRPBF | 功能描述:IC REG CTRLR BST PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
发布紧急采购，3分钟左右您将得到回复。