- 您现在的位置：买卖IC网 > PDF目录14012 > LT3970HMS-3.3#TRPBF (Linear Technology)IC REG BUCK 3.3V 0.35A 10MSOP PDF资料下载
参数资料
| 型号： | LT3970HMS-3.3#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 11/22页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK 3.3V 0.35A 10MSOP |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 固定 |
| 输出数： | 1 |
| 输出电压： | 3.3V |
| 输入电压： | 4.2 V ~ 40 V |
| PWM 型： | 电流模式，Burst Mode? |
| 频率 - 开关： | 200kHz ~ 2.25MHz |
| 电流 - 输出： | 350mA |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-TFSOP，10-MSOP（0.118"，3.00mm 宽） |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 10-MSOP |
LT3970 Series
APPLICATIONS INFORMATION
V IN(OP-MAX) =
– V D + V SW
V OUT + V D
f SW
The highest allowed V IN during normal operation
(V IN(OP-MAX) ) is limited by minimum duty cycle and can
be calculated by the following equation:
V OUT + V D
f SW ? t ON(MIN)
where t ON(MIN) is the minimum switch on-time (~150ns).
However, the circuit will tolerate inputs up to the absolute
maximum ratings of the V IN and BOOST pins, regardless of
chosen switching frequency. During such transients where
V IN is higher than V IN(OP-MAX) , the switching frequency will
be reduced below the programmed frequency to prevent
damage to the part. The output voltage ripple and inductor
current ripple may also be higher than in typical operation,
however the output will still be in regulation.
Inductor Selection
For a given input and output voltage, the inductor value
and switching frequency will determine the ripple current.
The ripple current increases with higher V IN or V OUT and
decreases with higher inductance and faster switching
frequency. A good starting point for selecting the induc-
tor value is:
L = 3
Table 2. Inductor Vendors
where V D is the voltage drop of the catch diode (~0.7V),
L is in μH and f SW is in MHz. The inductor’s RMS current
rating must be greater than the maximum load current
and its saturation current should be about 30% higher.
For robust operation in fault conditions (start-up or short
circuit) and high input voltage (>30V), the saturation current
should be above 500mA. To keep the efficiency high, the
series resistance (DCR) should be less than 0.1Ω, and the
core material should be intended for high frequency ap-
plications. Table 2 lists several vendors and suitable types.
This simple design guide will not always result in the
optimum inductor selection for a given application. As a
general rule, lower output voltages and higher switching
frequency will require smaller inductor values. If the ap-
plication requires less than 350mA load current, then a
lesser inductor value may be acceptable. This allows use
of a physically smaller inductor, or one with a lower DCR
resulting in higher efficiency. There are several graphs in
the Typical Performance Characteristics section of this data
sheet that show the maximum load current as a function
of input voltage for several popular output voltages. Low
inductance may result in discontinuous mode operation,
which is acceptable but reduces maximum load current.
For details of maximum output current and discontinu-
ous mode operation, see Linear Technology Application
Note 44. Finally, for duty cycles greater than 50% (V OUT /
V IN > 0.5), there is a minimum inductance required to
avoid subharmonic oscillations. See Application Note 19.
11
VENDOR
Coilcraft
Sumida
Toko
Würth Elektronik
Coiltronics
Murata
URL
www.coilcraft.com
www.sumida.com
www.tokoam.com
www.we-online.com
www.cooperet.com
www.murata.com
Input Capacitor
Bypass the input of the LT3970 circuit with a ceramic
capacitor of X7R or X5R type. Y5V types have poor
performance over temperature and applied voltage, and
should not be used. A 1μF to 4.7μF ceramic capacitor is
adequate to bypass the LT3970 and will easily handle the
ripple current. Note that larger input capacitance is required
3970fc
相关PDF资料 |
PDF描述 |
|---|---|
| LTC1174CN8-5#PBF | IC REG BUCK INV 5V 1A 8DIP |
| V28C48C100B3 | CONVERTER MOD DC/DC 48V 100W |
| LTC1174CN8-5 | IC REG BUCK INV 5V 1A 8DIP |
| MAX6717AUKVDD6+T | IC SUPERVISOR MPU SOT23-5 |
| MAX6717AUKZGD5+T | IC SUPERVISOR MPU SOT23-5 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3970HMS-5#PBF | 功能描述:IC REG BUCK 5V 0.35A 10MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LT3970HMS-5#TRPBF | 功能描述:IC REG BUCK 5V 0.35A 10MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LT3970HMS-5-PBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:40V, 350mA Step-Down Regulator with 2.5μA Quiescent Current and Integrated Diodes |
| LT3970HMS-5-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:40V, 350mA Step-Down Regulator with 2.5μA Quiescent Current and Integrated Diodes |
| LT3970IDDB#PBF | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 4.2V to 40V 10-Pin DFN EP 制造商:Linear Technology 功能描述:Bulk |
发布紧急采购，3分钟左右您将得到回复。