- 您现在的位置：买卖IC网 > PDF目录6108 > LT6106CS5#TRMPBF (Linear Technology)IC AMP CURRENT SENSE TSOT23-5 PDF资料下载
参数资料
| 型号： | LT6106CS5#TRMPBF |
| 厂商： | Linear Technology |
| 文件页数： | 2/12页 |
| 文件大小： | 0K |
| 描述： | IC AMP CURRENT SENSE TSOT23-5 |
| 标准包装： | 1 |
| 放大器类型： | 电流检测 |
| 电路数： | 1 |
| -3db带宽： | 200kHz |
| 电流 - 输入偏压： | 40nA |
| 电压 - 输入偏移： | 150µV |
| 电流 - 电源： | 70µA |
| 电流 - 输出 / 通道： | 1mA |
| 电压 - 电源，单路/双路(±)： | 2.7 V ~ 36 V |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | SOT-23-5 细型，TSOT-23-5 |
| 供应商设备封装： | TSOT-23-5 |
| 包装： | 标准包装 |
| 产品目录页面： | 1320 (CN2011-ZH PDF) |
| 其它名称： | LT6106CS5#TRMPBFDKR |
LT6106
10
6106fa
APPLICATIONS INFORMATION
power dissipation is 41mW. This amount of power dis-
sipation will result in a 10°C rise in junction temperature
above the ambient temperature.
It is important to note that the LT6106 has been designed
to provide at least 1mA to the output when required, and
can deliver more depending on the conditions. Care must
be taken to limit the maximum output current by proper
choice of sense resistor and RIN– and, if input fault con-
ditions exist, external clamps.
Output Filtering
The output voltage, VOUT, is simply IOUT ZOUT. This makes
ltering straightforward. Any circuit may be used which
generates the required ZOUT to get the desired lter re-
sponse. For example, a capacitor in parallel with ROUT
will give a lowpass response. This will reduce unwanted
noise from the output, and may also be useful as a charge
reservoir to keep the output steady while driving a switch-
ing circuit such as a MUX or ADC. This output capacitor
in parallel with an output resistor will create a pole in the
output response at:
f
RC
dB
OUT
–
3
1
2
=
π
Useful Equations
Input Voltage: VSENSE = IR
Voltage
SENSE
G
Gain:
VOUT
V
R
SENSE
OUT
IN
=
Current Gain:
I
Transcond
OUT
I
R
SENSE
IN
=
u
uctance:
I
Transimpedance:
V
OUT
O
VR
SENSE
IN
=
1
U
UT
I
R
SENSE
OUT
IN
=
Power Supply Connection
For normal operation, the V+ pin should be connected to
either side of the sense resistor. Either connection will
meet the constraint that +IN ≤ V+ and –IN ≤ V+. During
normal operation, VSENSE should not exceed 500mV (see
VSENSE(MAX) under Electrical Characteristics). This ad-
ditional constraint can be stated as V+ – (+IN) ≤ 500mV.
Referring to Figure 5, feedback will force the voltages
at the inputs –IN and +IN to be equal to (VS – VSENSE).
Connecting V+ to the load side of the shunt results in equal
voltages at +IN, –IN and V+. Connecting V+ to the supply
end of the shunt results in the voltages at +IN and –IN to
be VSENSE below V+.
If the V+ pin is connected to the supply side of the shunt
resistor the supply current drawn by the LT6106 is not
included in the monitored current. If the V+ pin is con-
nected to the load side of the shunt resistor (Figure 5),
the supply current drawn by the LT6106 is included in
the monitored current. It should be noted that in either
conguration, the output current of the LT6106 will not
be monitored since it is drawn through the RIN resistor
connected to the positive side of the shunt. Contract the
factory for operation of the LT6106 with a V+ outside of
the recommended operating range.
Figure 5. LT6106 Supply Current Monitored with the Load
Reverse Supply Protection
Some applications may be tested with reverse-polarity
supplies due to an expectation of the type of fault during
operation. The LT6106 is not protected internally from ex-
ternal reversal of supply polarity. To prevent damage that
may occur during this condition, a Schottky diode should
be added in series with V– (Figure 6). This will limit the
reverse current through the LT6106. Note that this diode
will limit the low voltage performance of the LT6106 by
effectively reducing the supply voltage to the part by VD.
LT6106
ROUT
VOUT
6106 F05
RIN
VS
LOAD
RSENSE
–
+
V+
V–
OUT
–IN
+IN
相关PDF资料 |
PDF描述 |
|---|---|
| SBH11-PBPC-D07-RA-BK | CONN HEADR 2.54MM 14POS GOLD R/A |
| 0070.1781.A2 | VARISTOR 17V 20MM RADIAL |
| 68602-120HLF | CONN HEADER 20POS .100 STR 30AU |
| 0070.1481.A2 | VARISTOR 14V 20MM RADIAL |
| ADM4073FWRJZ-REEL7 | IC AMP CS 1.8MHZ SOT23-6 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT6106HS5#PBF | 制造商:Linear Technology 功能描述:SP Amp Current Sense Amp Single 36V 5-Pin TSOT-23 制造商:Linear Technology 功能描述:SP Amp Current Sense Amp Single 36V 5-Pin TSOT-23 Bulk 制造商:Linear Technology 功能描述:AMP CURRENT SENSE 36V TSOT-23-5 制造商:Linear Technology 功能描述:IC OP-AMP 200kHz 5-SOT-23 制造商:Linear Technology 功能描述:AMP, CURRENT SENSE, 36V, TSOT-23-5 制造商:Linear Technology 功能描述:IC, OP-AMP, 200kHz, 5-SOT-23; Op Amp Type:High Current; No. of Amplifiers:1; Supply Voltage Range:2.7V to 36V; Amplifier Case Style:SOT-23; No. of Pins:5; Bandwidth:200kHz; Operating Temperature Min:-40C; MSL:MSL 1 - Unlimited ;RoHS Compliant: Yes |
| LT6106HS5#TRM | 制造商:Linear Technology 功能描述: |
| LT6106HS5#TRMPBF | 功能描述:IC AMP CURRENT SENSE TSOT23-5 RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 产品培训模块:Differential Circuit Design Techniques for Communication Applications 标准包装:1 系列:- 放大器类型:RF/IF 差分 电路数:1 输出类型:差分 转换速率:9800 V/µs 增益带宽积:- -3db带宽:2.9GHz 电流 - 输入偏压:3µA 电压 - 输入偏移:- 电流 - 电源:40mA 电流 - 输出 / 通道:- 电压 - 电源，单路/双路(±):3 V ~ 3.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:16-VQFN 裸露焊盘，CSP 供应商设备封装:16-LFCSP-VQ 包装:剪切带 (CT) 产品目录页面:551 (CN2011-ZH PDF) 其它名称:ADL5561ACPZ-R7CT |
| LT6106HS5#TRPBF | 功能描述:IC AMP CURRENT SENSE TSOT23-5 RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:160 系列:- 放大器类型:通用 电路数:4 输出类型:满摆幅 转换速率:10 V/µs 增益带宽积:9MHz -3db带宽:- 电流 - 输入偏压:1pA 电压 - 输入偏移:250µV 电流 - 电源:730µA 电流 - 输出 / 通道:28mA 电压 - 电源，单路/双路(±):2.7 V ~ 5.5 V，±1.35 V ~ 2.75 V 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:16-SOIC（0.154"，3.90mm 宽） 供应商设备封装:16-SOIC N 包装:管件 |
| LT6106HS5TRMPBF | 制造商:Linear Technology 功能描述:36V High-Side Current Sense TSOT23-5 |
发布紧急采购，3分钟左右您将得到回复。