参数资料
| 型号： | LT6559CUD#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 15/16页 |
| 文件大小： | 0K |
| 描述： | IC AMP VIDEO TRPL 16-QFN |
| 标准包装： | 2,500 |
| 应用： | 通用 |
| 电路数： | 3 |
| -3db带宽： | 300MHz |
| 转换速率： | 800 V/µs |
| 电流 - 电源： | 4.6mA |
| 电流 - 输出 / 通道： | 100mA |
| 电压 - 电源，单路/双路(±)： | 4 V ~ 12 V，±2 V ~ 6 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-WFQFN 裸露焊盘 |
| 供应商设备封装： | 16-QFN-EP（3x3） |
| 包装： | 带卷 (TR) |
LT6559
8
6559f
PIN FUNCTIONS
GND (Pins 1, 4): Ground. Not connected internally.
–IN G (Pin 2): Inverting Input of G Channel Amplier.
+IN G (Pin 3): Noninverting Input of G Channel Amplier.
+IN B (Pin 5): Noninverting Input of B Channel Amplier.
–IN B (Pin 6): Inverting Input of B Channel Amplier.
EN B (Pin 7): B Channel Enable Pin. Logic low to enable.
OUT B (Pin 8): B Channel Output.
V– (Pin 9):
Negative Supply Voltage, Usually Ground
or –5V.
OUT G (Pin 10): G Channel Output.
EN G (Pin 11): G Channel Enable Pin. Logic low to enable.
V+ (Pin 12):
Positive Supply Voltage, Usually 5V.
OUT R (Pin 13): R Channel Output.
EN R (Pin 14): R Channel Enable Pin. Logic low to enable.
–IN R (Pin 15): Inverting Input of R Channel Amplier.
+IN R (Pin 16): Noninverting Input of R Channel Amplier.
Exposed Pad (Pin 17): V–. Must Be Soldered to the PCB.
APPLICATIONS INFORMATION
Feedback Resistor Selection
The small-signal bandwidth of the LT6559 is set by the
external feedback resistors and the internal junction
capacitors. As a result, the bandwidth is a function of
the supply voltage, the value of the feedback resistor,
the closed-loop gain and the load resistor. Optimized for
±5V and single-supply 5V operation, the LT6559 has a
–3dB bandwidth of 300MHz at gains of +1, –1, or +2.
Refer to the resistor selection guide in the Typical AC
Performance table.
Capacitance on the Inverting Input
Current feedback ampliers require resistive feedback from
the output to the inverting input for stable operation. Take
care to minimize the stray capacitance between the output
and the inverting input. Capacitance on the inverting input
to ground will cause peaking in the frequency response
and overshoot in the transient response.
Capacitive Loads
The LT6559 can drive many capacitive loads directly when
the proper value of feedback resistor is used. The required
value for the feedback resistor will increase as load ca-
pacitance increases and as closed-loop gain decreases.
Alternatively, a small resistor (5Ω to 35Ω) can be put in
series with the output to isolate the capacitive load from
the amplier output. This has the advantage that the ampli-
er bandwidth is only reduced when the capacitive load
is present. The disadvantage is that the gain is a function
of the load resistance.
Power Supplies
The LT6559 will operate from single or split supplies from
±2V (4V total) to ±6V (12V total). It is not necessary to use
equal value split supplies, however the offset voltage and
inverting input bias current will change. The offset voltage
changes about 600V per volt of supply mismatch. The
inverting bias current will typically change about 2A per
volt of supply mismatch.
Slew Rate
Unlike a traditional voltage feedback op amp, the slew
rate of a current feedback amplier is dependent on the
amplier gain conguration. In a current feedback ampli-
er, both the input stage and the output stage have slew
rate limitations. In the inverting mode, and for gains of 2
or more in the noninverting mode, the signal amplitude
between the input pins is small and the overall slew rate
is that of the output stage. For gains less than 2 in the
noninverting mode, the overall slew rate is limited by the
input stage.
The input slew rate of the LT6559 is approximately 600V/s
and is set by internal currents and capacitances. The output
slew rate is set by the value of the feedback resistor and
相关PDF资料 |
PDF描述 |
|---|---|
| ADD8504WRUZ-REEL7 | IC GAMMA BUFFER LCD 4CH 16-TSSOP |
| VI-J4B-MW-S | CONVERTER MOD DC/DC 95V 100W |
| VI-BTX-MX-S | CONVERTER MOD DC/DC 5.2V 75W |
| VI-BTW-MX-S | CONVERTER MOD DC/DC 5.5V 75W |
| 5750340-2 | CONN RCPT MINI DIN 8P VRT SHLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT65W64JL-25LL | 制造商:LYONTEK 制造商全称:LYONTEK 功能描述:8K X 8 BIT HIGH SPEED CMOS SRAM |
| LT65W64JL-25LLI | 制造商:LYONTEK 制造商全称:LYONTEK 功能描述:8K X 8 BIT HIGH SPEED CMOS SRAM |
| LT65W64JL-25LLIT | 制造商:LYONTEK 制造商全称:LYONTEK 功能描述:8K X 8 BIT HIGH SPEED CMOS SRAM |
| LT65W64JL-25LLT | 制造商:LYONTEK 制造商全称:LYONTEK 功能描述:8K X 8 BIT HIGH SPEED CMOS SRAM |
| LT65W64RL-25LL | 制造商:LYONTEK 制造商全称:LYONTEK 功能描述:8K X 8 BIT HIGH SPEED CMOS SRAM |
发布紧急采购，3分钟左右您将得到回复。