- 您现在的位置：买卖IC网 > PDF目录11026 > LTC1063CSW#PBF (Linear Technology)IC FILTR 5TH ORDER LOWPASS16SOIC PDF资料下载
参数资料
| 型号： | LTC1063CSW#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 14/16页 |
| 文件大小： | 0K |
| 描述： | IC FILTR 5TH ORDER LOWPASS16SOIC |
| 标准包装： | 47 |
| 滤波器类型： | 巴特沃斯，低通开关电容器 |
| 频率 - 截止或中心： | 50kHz |
| 滤波器数： | 1 |
| 滤波器阶数： | 5th |
| 电源电压： | ±2.37 V ~ 8 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-SOIC（0.295"，7.50mm 宽） |
| 供应商设备封装： | 16-SOIC |
| 包装： | 管件 |
| 产品目录页面： | 1324 (CN2011-ZH PDF) |
LTC1063
7
1063fa
PI FU CTIO S
U
UU
Power Supply Pins (Pins 6, 3, N Package)
The positive and negative supply pin should be bypassed
with a high quality 0.1
Fceramiccapacitor.Inapplications
where the clock pin (5) is externally swept to provide
several cutoff frequencies, the output DC offset variation
is minimized by connecting an additional 1
F solid tanta-
lum capacitor in parallel with the 0.1
F disc ceramic. This
technique was used to generate the graphs of the output
DC offset variation versus clock; they are illustrated in the
Typical Performance Characteristics section.
When the power supply voltage exceeds
±7V, and when V–
is applied before V+, if V+ is allowed to go below ground,
connect a signal diode between the positive supply pin and
ground to prevent latch-up (see Typical Applications).
Ground Pin (Pin 2, N Package)
The ground pin merges the internal analog and digital
ground paths. The potential of the ground pin is the
reference for the internal switched-capacitor resistors,
and the reference for the external clock. The positive input
of the internal op amp is also tied to the ground pin.
For dual supply operation, the ground pin should be
connected to a high quality AC and DC ground. A ground
plane, if possible, should be used. A poor ground will
degrade DC offset and it will increase clock feedthrough,
noise and distortion.
A small amount of AC current flows out of the ground pin
whether or not the internal oscillator is used. The fre-
quency of the ground current equals the frequency of the
internal or external clock. The average value of this current
is approximately 55
A, 110A, 170A for ±2.5V, ±5V and
±7.5V supplies respectively.
For single supply operation, the ground pin should be
preferably biased at half supply (see Typical Applications).
VOS Adjust Pin (Pin 8, N Package)
The VOS adjust pin can be used to trim any small amount
of output DC offset voltage or to introduce a desired output
DC level. The DC gain from the VOS adjust pin to the filter
output pin equals two.
Any DC voltage applied to this pin will reflect at the output
pin of the filter multiplied by two.
If the VOS adjust pin is not used, it should be shorted to the
ground pin. The DC bias current flowing into the VOS adjust
pin is typically 10pA.
Pin 8 should always be connected to an AC ground; AC
signals applied to this pin will degrade the filter response.
Input Pin (Pin 1, N Package)
Pin 1 is the filter input and it is connected to an internal
switched-capacitor resistor. If the input pin is left floating,
the filter output will saturate. The DC input impedance of
pin 1 is very high; with
±5V supplies and 1MHz clock, the
DC input impedance is typically 1G
. A resistor, RIN, in
series, with the input pin will not alter the value of the
filter’s DC output offset (Figure 1). RIN should, however,
be limited to a maximum value (Table 1), otherwise the
filter’s passband flatness will be affected. Refer to the
Applications Information section for more details.
VIN
VOUT
1063 F01
V–
V+
RIN 1
2
3
4
8
7
6
5
LTC1063
fCLK
Table 1. RIN(MAX) vs Clock and Power Supply
RIN(MAX)
VS = ±7.5V
VS = ±5V
VS = ±2.5V
fCLK = 4MHz
2.2k
–
fCLK = 3MHz
3.4k
2.9k
–
fCLK = 2MHz
5.5k
5k
2.7k
fCLK = 1MHz
11k
9.2k
fCLK = 500kHz
24k
23k
21k
fCLK = 100kHz
120k
110k
Figure 1.
相关PDF资料 |
PDF描述 |
|---|---|
| VE-B00-IY-F2 | CONVERTER MOD DC/DC 5V 50W |
| LTC1566-1IS8#PBF | IC FILTER LP 7ORDER 2.3MHZ 8SOIC |
| LTC1068CG | IC FILTR BUILDNG BLK QUAD 28SSOP |
| LTC1068-50CG#PBF | IC FILTR BUILDNG BLK QUAD 28SSOP |
| LTC1068CN | IC FILTR BUILDNG BLK QUAD 24-DIP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1063MJ8 | 制造商:LINER 制造商全称:Linear Technology 功能描述:DC Accurate, Clock-Tunable 5th Order Butterworth Lowpass Filter |
| LTC1064 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Low Noise, Fast, Quad Universal Filter Building Block |
| LTC1064_09 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Low Noise, Fast, Quad Universal Filter Building Block |
| LTC1064-1 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Low Noise, 8th Order, Clock Sweepable Elliptic Lowpass Filter |
| LTC1064-1_09 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Low Noise, 8th Order, Clock Sweepable Elliptic Lowpass Filter |
发布紧急采购，3分钟左右您将得到回复。