- 您现在的位置：买卖IC网 > PDF目录11022 > LTC1064-4CN (Linear Technology)IC FILTR 8TH ORDR LOWPASS 14-DIP PDF资料下载
参数资料
| 型号： | LTC1064-4CN |
| 厂商： | Linear Technology |
| 文件页数： | 10/12页 |
| 文件大小： | 0K |
| 描述： | IC FILTR 8TH ORDR LOWPASS 14-DIP |
| 标准包装： | 25 |
| 滤波器类型： | 考尔，低通开关电容器 |
| 频率 - 截止或中心： | 100kHz |
| 滤波器数： | 1 |
| 滤波器阶数： | 8th |
| 电源电压： | ±2.37 V ~ 8 V |
| 安装类型： | 通孔 |
| 封装/外壳： | 14-DIP（0.300"，7.62mm） |
| 供应商设备封装： | 14-PDIP |
| 包装： | 管件 |
LTC1064-4
7
10644fb
UU
U
PI FU CTIO S
INV C, COMP1, INV A, COMP2 (Pins 1, 6, 7 and 13): To
obtain a Cauer response with minimum passband ripple
and cutoff frequencies above 20kHz, compensating com-
ponents are required. Figure 6 uses ±7.5V power supplies
and compensation components to achieve up to 40kHz
sweepable cutoff frequencies and ±0.1dBpassbandripple.
Table 7 lists the typical amplitude response of Figure 6.
Figure 7 illustrates the compensation scheme required to
obtain a 100kHz cutoff frequency; Graph 4 and Tables 8
and 9 list the typical response of Figure 7 for 25°C and
125°C ambient temperature. As shown the ripple in-
creases at high temperatures but still a ±0.25dB figure
can be obtained for ambient temperatures below 70°C.
VIN, VOUT (Pins 2, 9): The input Pin 2 is connected to a 12k
resistor tied to the inverting input of an op amp. Pin 2 is
protected against static discharge. The device’s output,
Pin 9, is the output of an op amp which can typically
source/sink 3mA/1mA. Although the internal op amps are
unity gain stable, driving long coax cables is not recom-
mended.
When testing the device for noise and distortion, the
output, Pin 9, should be buffered (Figure 4).
The op amp
power supply wire (or trace) should be connected
directly to the power source. To eliminate any output
clock feedthrough, Pin 9 should be buffered with a simple
R, C lowpass filter (Figure 5). The cutoff frequency of the
output filter should be fCLK/3.
AGND (Pins 3, 5): For dual supply operation these pins
should be connected to a ground plane. For single supply
operation both pins should be tied to one half supply
(Figure 2).
V+, V– (Pins 4, 12): Should be bypassed with a 0.1F
capacitor to an adequate analog ground. Low noise,
nonswitching power supplies are recommended.
To avoid
latchup when the power supplies exhibit high turn-on
transients, a 1N5817 Schottky diode should be added
from the V+ and V– pins to ground (Figures 1 and 2).
INV A, R(h, I) (Pins 7, 14): A very short connection
between Pin 7 and Pin 14 is recommended. This connec-
tion should be preferably done under the IC package. In a
breadboard, use a one inch, or less, shielded coaxial cable;
the shield should be grounded. In a PC board, use a one
inch trace or less; surround the trace by a ground plane.
NC (Pin 8 ): Pin 8 is not internally connected, it should be
preferably grounded.
50/100 Ratio (Pin 10): For an fCLK/fC ratio of 50:1,
Pin 10 should be tied to V+. For an fCLK/f –3dB ratio of
100:1, Pin 10 should be tied to V–. When Pin 10 is at
midsupplies (i.e. ground), the filter response is neither
Cauer nor transitional. Table 6 illustrates this response.
Bypassing Pin 10 with a 0.1F capacitor reduces the
already small clock feedthrough.
(Pin Numbers Refer to the 14-Pin Package)
相关PDF资料 |
PDF描述 |
|---|---|
| MC9S08QB4CWL | MCU 4KB FLASH ULT LP 28SOIC |
| LTC1562AIG#PBF | IC FILTER UNIV RC QUAD LN 20SSOP |
| LTC1562AIG | IC FILTER UNIVRSL RC QUAD 20SSOP |
| LTC1562AIG#TRPBF | IC FILTER UNIV RC QUAD LN 20SSOP |
| LTC1164-5CN#PBF | IC FILTR 8TH ORDER LOWPASS 14DIP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1064-4CN#PBF | 功能描述:IC FILTR 8TH ORDR LOWPASS 14-DIP RoHS:是 类别:集成电路 (IC) >> 接口 - 滤波器 - 有源 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1,000 系列:- 滤波器类型:连续时间，带通低通 频率 - 截止或中心:150kHz 滤波器数:4 滤波器阶数:8th 电源电压:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) |
| LTC1064-4CS | 制造商:LINER 制造商全称:Linear Technology 功能描述:Low Noise,8th Order, Clock Sweepable Cauer Lowpass Filter |
| LTC1064-4CSW | 功能描述:IC FILTR 8TH ORDR LOWPASS 16SOIC RoHS:否 类别:集成电路 (IC) >> 接口 - 滤波器 - 有源 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1,000 系列:- 滤波器类型:连续时间，带通低通 频率 - 截止或中心:150kHz 滤波器数:4 滤波器阶数:8th 电源电压:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) |
| LTC1064-4CSW#PBF | 功能描述:IC FILTR 8TH ORDR LOWPASS 16SOIC RoHS:是 类别:集成电路 (IC) >> 接口 - 滤波器 - 有源 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1,000 系列:- 滤波器类型:连续时间，带通低通 频率 - 截止或中心:150kHz 滤波器数:4 滤波器阶数:8th 电源电压:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) |
| LTC1064-4CSW#TR | 功能描述:IC FILTER LP 8ORD ELLIPTC 16SOIC RoHS:否 类别:集成电路 (IC) >> 接口 - 滤波器 - 有源 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1,000 系列:- 滤波器类型:连续时间，带通低通 频率 - 截止或中心:150kHz 滤波器数:4 滤波器阶数:8th 电源电压:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。