- 您现在的位置：买卖IC网 > PDF目录11025 > LTC1068-200IG#TRPBF (Linear Technology)IC FILTR BUILDNG BLK QUAD 28SSOP PDF资料下载
参数资料
| 型号： | LTC1068-200IG#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 6/30页 |
| 文件大小： | 0K |
| 描述： | IC FILTR BUILDNG BLK QUAD 28SSOP |
| 标准包装： | 2,000 |
| 滤波器类型： | 通用开关电容器 |
| 频率 - 截止或中心： | 25kHz |
| 滤波器数： | 4 |
| 滤波器阶数： | 8th |
| 电源电压： | 3.14 V ~ 11 V，±3.14 V ~ 5.5 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-SSOP（0.209"，5.30mm 宽） |
| 供应商设备封装： | 28-SSOP |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页当前第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
LTC1068 Series
14
1068fc
Operating Limits
The Maximum Q vs Center Frequency (fO) graphs, under
Typical Performance Characteristics, define an upper
limit of operating Q for each LTC1068 device 2nd order
section. These graphs indicate the power supply, fO and
Q value conditions under which a filter implemented with
an LTC1068 device will remain stable when operated at
temperatures of 70°C or less. For a 2nd order section, a
bandpass gain error of 3dB or less is arbitrarily defined
as a condition for stability.
When the passband gain error begins to exceed 1dB, the
use of capacitor CC will reduce the gain error (capacitor CC
is connected from the lowpass node to the inverting node
of a 2nd order section). Please refer to Figures 4 through 7.
The value of CC can be best determined experimentally,
and as a guide it should be about 5pF for each 1dB of
gain error and not to exceed 15pF. When operating an
LTC1068 device near the limits defined by the Maximum Q
vs Frequency graphs, passband gain variations of 2dB or
more should be expected.
Clock Feedthrough
Clock feedthrough is defined as the RMS value of the
clock frequency and its harmonics that are present at the
filter’s output pins. The clock feedthrough is tested with
the filter’s input grounded and depends on PC board layout
and on the value of the power supplies. With proper layout
techniques, the typical values of clock feedthrough are
listed under Electrical Characteristics.
Any parasitic switching transients during the rising and
falling edges of the incoming clock are not part of the clock
feedthrough specifications. Switching transients have fre-
quency contents much higher than the applied clock; their
amplitude strongly depends on scope probing techniques
as well as grounding and power supply bypassing. The
clock feedthrough, can be greatly reduced by adding a
simple RC lowpass network at the final filter output. This
RC will completely eliminate any switching transients.
Wideband Noise
The wideband noise of the filter is the total RMS value of
thedevice’snoisespectraldensityandisusedtodetermine
APPLICATIONS INFORMATION
the operating signal-to-noise ratio. Most of its frequency
contents lie within the filter passband and cannot be
reduced with post filtering. For a notch filter the noise of
the filter is centered at the notch frequency.
The total wideband noise (VRMS) is nearly independent
of the value of the clock. The clock feedthrough specifica-
tions are not part of the wideband noise.
For a specific filter design, the total noise depends on the
Q of each section and the cascade sequence. Please refer
to the Noise vs Q graphs under the Typical Performance
Characteristics.
Aliasing
Aliasingisaninherentphenomenonofswitched-capacitor
filters and occurs when the frequency of the input signals
that produce the strongest aliased components have a
frequency, fIN, such as (fSAMPLING – fIN) that falls into the
filter’s passband. For an LTC1068 device the sampling
frequency is twice fCLK. If the input signal spectrum is
not band-limited, aliasing may occur.
Demonstration Circuit 104
DC104 is a surface mount printed circuit board for the
evaluation of Linear Technology’s LTC1068 product family
in a 28-lead SSOP package. The LTC1068 product family
consists of four monolithic clock-tunable filter building
blocks.
Demo Board 104 is available in four assembled versions:
Assembly104-AfeaturesthelownoiseLTC1068CG(clock-
to-center frequency ratio = 100), assembly 104-B features
the low noise LTC1068-200CG (clock-to-center frequency
ratio = 200), assembly 104-C features the high frequency
LTC1068-25CG (clock-to-center frequency ratio = 25) and
assembly 104-D features the low power LTC1068-50CG
(clock-to-center frequency ratio = 50).
All DC104 boards are assembled with input, output and
power supply test terminals, a 28-lead SSOP filter device
(LTC1068CG Series), a dual op amp in an SO-8 for input
or output buffers and decoupling capacitors for the filter
and op amps. The filter and dual op amps share the power
相关PDF资料 |
PDF描述 |
|---|---|
| LTC1068-200IG#TR | IC FILTER BUILDG BLK QUAD 28SSOP |
| LTC1068-50IG#TRPBF | IC FILTR BUILDNG BLK QUAD 28SSOP |
| LTC1068-50IG#TR | IC FILTER BUILDG BLK QUAD 28SSOP |
| LTC1068IG | IC FILTR BUILDNG BLK QUAD 28SSOP |
| LTC1068-50IG#PBF | IC FILTR BUILDNG BLK QUAD 28SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC106825CG | 制造商:Linear Technology 功能描述: |
| LTC1068-25CG | 功能描述:IC FILTR BUILDNG BLK QUAD 28SSOP RoHS:否 类别:集成电路 (IC) >> 接口 - 滤波器 - 有源 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1,000 系列:- 滤波器类型:连续时间，带通低通 频率 - 截止或中心:150kHz 滤波器数:4 滤波器阶数:8th 电源电压:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) |
| LTC1068-25CG#PBF | 功能描述:IC FILTR BUILDNG BLK QUAD 28SSOP RoHS:是 类别:集成电路 (IC) >> 接口 - 滤波器 - 有源 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1,000 系列:- 滤波器类型:连续时间，带通低通 频率 - 截止或中心:150kHz 滤波器数:4 滤波器阶数:8th 电源电压:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) |
| LTC1068-25CG#TR | 功能描述:IC FILTER BUILDG BLK QUAD 28SSOP RoHS:否 类别:集成电路 (IC) >> 接口 - 滤波器 - 有源 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1,000 系列:- 滤波器类型:连续时间，带通低通 频率 - 截止或中心:150kHz 滤波器数:4 滤波器阶数:8th 电源电压:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) |
| LTC1068-25CG#TRPBF | 功能描述:IC FILTR BUILDNG BLK QUAD 28SSOP RoHS:是 类别:集成电路 (IC) >> 接口 - 滤波器 - 有源 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1,000 系列:- 滤波器类型:连续时间，带通低通 频率 - 截止或中心:150kHz 滤波器数:4 滤波器阶数:8th 电源电压:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。