- 您现在的位置：买卖IC网 > PDF目录15263 > LTC1159CG#TR (Linear Technology)IC REG CTRLR BUCK PWM CM 20-SSOP PDF资料下载
参数资料
| 型号： | LTC1159CG#TR |
| 厂商： | Linear Technology |
| 文件页数： | 15/20页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 20-SSOP |
| 标准包装： | 1,800 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 250kHz |
| 占空比： | 100% |
| 电源电压： | 4 V ~ 40 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 20-SSOP（0.209"，5.30mm 宽） |
| 包装： | 带卷 (TR) |
LTC1159
LTC1159-3.3/LTC1159-5
APPLICATIO S I FOR ATIO
1) Are the signal and power grounds segregated? The
LTC1159 signal ground must connect separately to the
(–) plate of C OUT . The other ground pin(s) should return to
the source of the N-channel MOSFET, anode of the Schot-
tky diode and (–) plate of C IN , which should have as short
lead lengths as possible.
2) Does the LTC1159 SENSE – pin connect to a point close
to R SENSE and the (+) plate of C OUT ? In adjustable applica-
tions, the resistive divider R1, R2 must be connected
between the (+) plate of C OUT and signal ground.
3) Are the SENSE – and SENSE + leads routed together
with minimum PC trace spacing? The differential
decoupling capacitor between the two SENSE pins should
be as close as possible to the LTC1159. Up to 100 ? may
be placed in series with each sense lead to help decouple
the SENSE pins. However, when these resistors are used,
the capacitor should be no larger than 1000pF.
4) Does the (+) plate of C IN connect to the source of the
P-channel MOSFET as closely as possible? An additional
0.1 μ F ceramic capacitor between V IN and power ground
may be required in some applications.
7) Is the SHDN1 pin actively pulled to ground during
normal operation? SHDN1 is a high impedance pin and
must not be allowed to float.
Troubleshooting Hints
Since efficiency is critical to LTC1159 applications it is very
important to verify that the circuit is functioning correctly
in both continuous and Burst Mode operation. The wave-
form to monitor is the voltage on the C T pin .
In continuous mode (I LOAD > I BURST ) the voltage should be
a sawtooth with a 0.9V P-P swing. This voltage should never
dip below 2V as shown in Figure 9a. When the load current
is low (I LOAD < I BURST ), Burst Mode operation should occur
with the C T waveform periodically falling to ground as
shown in Figure 9b.
If the C T pin is observed falling to ground at high output
currents, it indicates poor decoupling or improper ground-
ing. Refer to the Board Layout Checklist.
3.3V
5) Is the V CC decoupling capacitor connected closely be-
tween the V CC pins of the LTC1159 and power ground?
This capacitor carries the MOSFET driver peak currents.
6) In adjustable versions, the feedback pin is very sensitive
to pickup from the switch node. Care must be taken to
isolate V FB from possible capacitive coupling of the induc-
tor switch signal.
(a) CONTINUOUS MODE OPERATION
(b) Burst Mode OPERATION
Figure 9. C T Pin 6 Waveforms
0V
3.3V
0V
LTC1159 ? F09
15
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3834IUFD#PBF | IC REG CTRLR BUCK PWM CM 20-QFN |
| H2BXG-10108-L8-ND | JUMPER-H1501TR/A3048L/X 8" |
| LTC3834IFE#PBF | IC REG CTRLR BUCK PWM CM 20TSSOP |
| SRP1235-4R7M | INDUCTOR 4.7UH 10A SMD |
| LTC1735CGN | IC REG CTRLR BUCK PWM CM 16-SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1159CN | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Efficiency Synchronous Step-Down Switching Regulators |
| LTC1159CN-3.3 | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Efficiency Synchronous Step-Down Switching Regulators |
| LTC1159CN-5 | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Efficiency Synchronous Step-Down Switching Regulators |
| LTC1159CS | 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1159CS#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP（0.173"，4.40mm 宽） 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。