- 您现在的位置：买卖IC网 > PDF目录15265 > LTC1159CG (Linear Technology)IC REG CTRLR BUCK PWM CM 20-SSOP PDF资料下载
参数资料
| 型号： | LTC1159CG |
| 厂商： | Linear Technology |
| 文件页数： | 10/20页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 20-SSOP |
| 标准包装： | 66 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 250kHz |
| 占空比： | 100% |
| 电源电压： | 4 V ~ 40 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 20-SSOP（0.209"，5.30mm 宽） |
| 包装： | 管件 |
LTC1159
LTC1159-3.3/LTC1159-5
APPLICATIO S I FOR ATIO
C IN Required I RMS ≈ MAX
C IN and C OUT Selection
In continuous mode, the source current of the P-channel
MOSFET is a square wave of duty cycle V OUT /V IN .
To prevent large voltage transients, a low ESR input
capacitor sized for the maximum RMS current must be
used. The maximum RMS capacitor current is given by:
I [V OUT (V IN – V OUT )] 1/2
V IN
This formula has a maximum at V IN = 2V OUT , where
I RMS = I MAX /2. This simple worst-case condition is com-
monly used for design because even significant deviations
do not offer much relief. Note that capacitor manufacturer’s
ripple current ratings are often based on only 2000 hours
if 200 μ F/10V is called for in an application requiring 3mm
height, two AVX 100 μ F/10V (P/N TPSD107K010) could be
used. Consult the manufacturer for other specific recom-
mendations.
At low supply voltages, a minimum value of C OUT is
suggested to prevent an abnormal low frequency operating
mode (see Figure 4). When C OUT is too small, the output
ripple at low frequencies will be large enough to trip the
voltage comparator. This causes the Burst Mode operation
to be activated when the LTC1159 would normally be in
continuous operation. The effect is most pronounced with
low values of R SENSE and can be improved by operating at
higher frequencies with lower values of L. The output
remains in regulation at all times.
of life. This makes it advisable to further derate the
capacitor, or to choose a capacitor rated at a higher
temperature than required. Several capacitors may be
paralleled to meet size or height requirements in the
design. An additional 0.1 μ F ceramic capacitor may also be
required on V IN for high frequency decoupling.
The selection of C OUT is driven by the required effective
series resistance (ESR). The ESR of C OUT must be less than
twice the value of R SENSE for proper operation of the
1000
800
600
400
200
L = 50 μ H
R SENSE = 0.02 ?
L = 25 μ H
R SENSE = 0.02 ?
L = 50 μ H
R SENSE = 0.05 ?
LTC1159:
0
0
1
2
3
4
5
C OUT Required ESR < 2R SENSE
(V IN – V OUT ) VOLTAGE (V)
LTC1159 ? TPC04
Optimum efficiency is obtained by making the ESR equal to
R SENSE . Manufacturers such as Nichicon, Chemicon, and
Sprague should be considered for high performance ca-
pacitors. The OS-CON semiconductor dielectric capacitor
available from Sanyo has the lowest ESR for its size at a
somewhat higher price. Once the ESR requirement for
C OUT has been met, the RMS current rating generally far
exceeds the I RIPPLE(P-P) requirement.
In surface mount applications, multiple capacitors may
have to be paralleled to meet the capacitance, ESR or RMS
current handling requirements of the application. Alumi-
num electrolytic and dry tantalum capacitors are both
available in surface mount configurations. In the case of
tantalum, it is critical that the capacitors are surge tested
for use in switching power supplies. An excellent choice is
the AVX TPS series of surface mount tantalums, available
in case heights ranging from 2mm to 4mm. For example,
10
Figure 4. Minimum Suggested C OUT
Load Transient Response
Switching regulators take several cycles to respond to a
step in DC (resistive) load current. When a load step
occurs, V OUT shifts by an amount equal to ? I LOAD ? ESR,
where ESR is the effective series resistance of C OUT . ? I LOAD
also begins to charge or discharge C OUT until the regulator
loop adapts to the current change and returns V OUT to its
steady-state value. During this recovery time V OUT can be
monitored for overshoot or ringing which would indicate a
stability problem. The I TH external components shown in
the Figure 1 circuit will provide adequate compensation for
most applications.
A second, more severe transient is caused by switching in
loads with large (>1 μ F) supply bypass capacitors. The
相关PDF资料 |
PDF描述 |
|---|---|
| NCP301HSN18T1G | IC VOLT DETECT OD 1.8V 5TSOP |
| LTC1149CN-5#PBF | IC REG CTRLR BUCK PWM CM 16-DIP |
| H2AXT-10112-S4-ND | JUMPER-H1502TR/A2015S/X 12" |
| LTC1149CN-5 | IC REG CTRLR BUCK PWM CM 16-DIP |
| B41042A3128M | 1200UF 10V 10X25 SINGLE END |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1159CG#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 20-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1159CG#TR | 功能描述:IC REG CTRLR BUCK PWM CM 20-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1159CG#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 20-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,000 系列:- PWM 型:电压模式 输出数:1 频率 - 最大:1.5MHz 占空比:66.7% 电源电压:4.75 V ~ 5.25 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:40-VFQFN 裸露焊盘 包装:带卷 (TR) |
| LTC1159CG-3.3 | 功能描述:IC REG CTRLR BUCK PWM CM 20-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1159CG-3.3#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 20-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
发布紧急采购，3分钟左右您将得到回复。