- 您现在的位置：买卖IC网 > PDF目录10294 > LTC1285CN8 (Linear Technology)IC A/D CONV SAMPLING 12BIT 8-DIP PDF资料下载
参数资料
| 型号： | LTC1285CN8 |
| 厂商： | Linear Technology |
| 文件页数： | 10/24页 |
| 文件大小： | 0K |
| 描述： | IC A/D CONV SAMPLING 12BIT 8-DIP |
| 标准包装： | 50 |
| 位数： | 12 |
| 采样率（每秒）： | 7.5k |
| 数据接口： | MICROWIRE?，串行，SPI? |
| 转换器数目： | 1 |
| 功率耗散（最大）： | 480µW |
| 电压电源： | 单电源 |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 通孔 |
| 封装/外壳： | 8-DIP（0.300"，7.62mm） |
| 供应商设备封装： | 8-PDIP |
| 包装： | 管件 |
| 输入数目和类型： | 1 个差分，单极 |
18
LTC1285/LTC1288
APPLICATION INFORMATION
WU
U
FREQUENCY (kHz)
0
– 120
MAGNITUDE
(dB)
– 100
–80
–60
–40
1.0
2.0
3.0
4.0
LTC1285/88 TPC16
–20
0
0.5
1.5
2.5
3.5
TA = 25°C
VCC = 2.7V
VREF = 2.5V
fIN = 3.05kHz
fCLK = 120kHz
fSMPL = 7.5kHz
Figure 11. LTC1285 Non-Averaged, 4096 Point FFT Plot
Voltage). However, care must be taken when operating at
low values of VREF because of the reduced LSB step size
and the resulting higher accuracy requirement placed on
the converter. The following factors must be considered
when operating at low VREF values:
1. Offset
2. Noise
3. Conversion speed (CLK frequency)
Offset with Reduced VREF
The offset of the LTC1285 has a larger effect on the output
code. When the ADC is operated with reduced reference
voltage. The offset (which is typically a fixed voltage)
becomes a larger fraction of an LSB as the size of the LSB
is reduced. The typical curve of Change in Offset vs
Reference Voltage shows how offset in LSBs is related to
reference voltage for a typical value of VOS. For example,
a VOS of 122V which is 0.2LSB with a 2.5V reference
becomes 1LSB with a 1V reference and 5LSBs with a 0.2V
reference. If this offset is unacceptable, it can be corrected
digitally by the receiving system or by offsetting the “–”
input of the LTC1285.
Noise with Reduced VREF
The total input referred noise of the LTC1285 can be
reduced to approximately 400
V peak-to-peak using a
ground plane, good bypassing, good layout techniques
and minimizing noise on the reference inputs. This noise
is insignificant with a 2.5V reference but will become a
larger fraction of an LSB as the size of the LSB is reduced.
For operation with a 2.5V reference, the 400
V noise is
only 0.66LSB peak-to-peak. In this case, the LTC1285
noise will contribute a little bit of uncertainty to the
output code. However, for reduced references the noise
may become a significant fraction of an LSB and cause
undesirable jitter in the output code. For example, with
a 1.25V reference this same 400
V noise is 1.32LSB
peak-to-peak. This will reduce the range of input volt-
ages over which a stable output code can be achieved by
1LSB. If the reference is further reduced to 1V, the 400
V
noise becomes equal to 3.3LSBs and a stable code may
be difficult to achieve. In this case averaging multiple
readings may be necessary.
This noise data was taken in a very clean setup. Any setup
induced noise (noise or ripple on VCC, VREF or VIN) will add
to the internal noise. The lower the reference voltage to be
used the more critical it becomes to have a clean, noise free
setup.
Conversion Speed with Reduced VREF
With reduced reference voltages, the LSB step size is
reduced and the LTC1285 internal comparator over-
drive is reduced. Therefore, it may be necessary to
reduce the maximum CLK frequency when low values
of VREF are used.
DYNAMIC PERFORMANCE
The LTC1285/LTC1288 have exceptional sampling capa-
bility. Fast Fourier Transform (FFT) test techniques are
used to characterize the ADC’s frequency response, dis-
tortion and noise at the rated throughput. By applying a
low distortion sine wave and analyzing the digital output
using an FFT algorithm, the ADC’s spectral content can be
examined for frequencies outside the fundamental. Figure
11 shows a typical LTC1285 plot.
相关PDF资料 |
PDF描述 |
|---|---|
| D38999/20ME6AN | CONN HSG RCPT 6POS WALL MT PINS |
| VE-J3N-MX-S | CONVERTER MOD DC/DC 18.5V 75W |
| MS27467T25F43B | CONN HSG PLUG 43POS STRGHT SCKT |
| VE-J3M-MX-S | CONVERTER MOD DC/DC 10V 75W |
| LTC1288CN8 | IC A/D CONV SAMPLING 12BIT 8-DIP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1285CN8#PBF | 功能描述:IC A/D CONV SAMPLING 12BIT 8-DIP RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:16 采样率（每秒）:45k 数据接口:串行 转换器数目:2 功率耗散（最大）:315mW 电压电源:模拟和数字 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) 输入数目和类型:2 个单端，单极 |
| LTC1285CN8PBF | 制造商:Linear Technology 功能描述:LTC1285CN8PBF |
| LTC1285CS8 | 功能描述:IC A/D CONV SAMPLING 12BIT 8SOIC RoHS:否 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:16 采样率（每秒）:45k 数据接口:串行 转换器数目:2 功率耗散（最大）:315mW 电压电源:模拟和数字 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) 输入数目和类型:2 个单端，单极 |
| LTC1285CS8#PBF | 功能描述:IC A/D CONV SAMPLING 12BIT 8SOIC RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1 系列:microPOWER™ 位数:8 采样率（每秒）:1M 数据接口:串行，SPI? 转换器数目:1 功率耗散（最大）:- 电压电源:模拟和数字 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:24-VFQFN 裸露焊盘 供应商设备封装:24-VQFN 裸露焊盘（4x4） 包装:Digi-Reel® 输入数目和类型:8 个单端，单极 产品目录页面:892 (CN2011-ZH PDF) 其它名称:296-25851-6 |
| LTC1285CS8#TR | 功能描述:IC ADC 12BIT 3V SAMPLING 8SOIC RoHS:否 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:16 采样率（每秒）:45k 数据接口:串行 转换器数目:2 功率耗散（最大）:315mW 电压电源:模拟和数字 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) 输入数目和类型:2 个单端，单极 |
发布紧急采购，3分钟左右您将得到回复。