参数资料
| 型号： | LTC1409IG#TR |
| 厂商： | Linear Technology |
| 文件页数： | 3/20页 |
| 文件大小： | 0K |
| 描述： | IC ADC 12BIT 800KSPS SMPL 28SSOP |
| 标准包装： | 2,000 |
| 位数： | 12 |
| 采样率（每秒）： | 800k |
| 数据接口： | 并联 |
| 转换器数目： | 1 |
| 功率耗散（最大）： | 120mW |
| 电压电源： | 双 ± |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-SSOP（0.209"，5.30mm 宽） |
| 供应商设备封装： | 28-SSOP |
| 包装： | 带卷 (TR) |
| 输入数目和类型： | 2 个单端，双极；1 个差分，双极 |
11
LTC1409
U
S
A
O
PPLICATI
WU
U
I FOR ATIO
bandwidth must be greater than 20MHz to ensure
adequate small-signal settling for full throughput rate. If
slower op amps are used, more settling time can be
provided by increasing the time between conversions.
The best choice for an op amp to drive the LTC1409 will
depend on the application. Generally applications fall into
two categories: AC applications where dynamic specifi-
cations are most critical, and time domain applications
where DC accuracy and settling time are most critical.
The following list is a summary of the op amps that are
suitable for driving the LTC1409, more detailed informa-
tion is available in the Linear Technology databooks and
the LinearView
TM CD-ROM.
LT
1220: 30MHz unity-gain bandwidth voltage feed-
back amplifier.
±5V to ±15V supplies. Excellent DC
specifications, 90ns settling to 0.5LSB.
LT1223: 100MHz video current feedback amplifier. 6mA
supply current.
±5V to ±15V supplies. Low distortion up
to and above 400kHz. Low noise. Good for AC
applications.
LT1227: 140MHz video current feedback amplifier. 10mA
supply current
±5V to ±15V supplies. Lowest distortion
at frequencies above 400kHz. Low noise. Best for AC
applications.
LT1229/LT1230: Dual and quad 100MHz current feed-
back amplifiers.
±2V to ±15V supplies. Low noise. Good
AC specs. 6mA supply current for each amplifier.
LT1360: 37MHz voltage feedback amplifier. 3.8mA sup-
ply current. Good AC/DC specs.
±5V to ±15V supplies.
70ns settling to 0.5LSB.
LT1363: 50MHz, 450V/
s op amps. 6.3mA supply cur-
rent. Good AC/DC specs. 60ns settling to 0.5LSB.
LT1364/LT1365: Dual and quad 50MHz, 450V/
s op
amps. 6.3mA supply current per amplifier. 60ns settling
to 0.5LSB.
Input Filtering
The noise and the distortion of the input amplifier and
other circuitry must be considered since they will add to
the LTC1409 noise and distortion. The small-signal band-
width of the sample-and-hold circuit is 20MHz. Any noise
or distortion products that are present at the analog inputs
will be summed over this entire bandwidth. Noisy input
circuitry should be filtered prior to the analog inputs to
minimize noise. A simple 1-pole RC filter is sufficient for
many applications. For example, Figure 7 shows a 1000pF
capacitor from + AIN to ground and a 100 source resistor
to limit the input bandwidth to 1.6MHz. The 1000pF
capacitor also acts as a charge reservoir for the input
sample-and-hold and isolates the ADC input from sam-
pling glitch sensitive circuitry. High quality capacitors and
resistors should be used since these components can add
distortion. NPO and silver mica type dielectric capacitors
have excellent linearity. Carbon surface mount resistors
can also generate distortion from self heating and from
damage that may occur during soldering. Metal film
surface mount resistors are much less susceptible to both
problems.
When high amplitude unwanted signals are close in fre-
quency to the desired signal frequency, a multiple pole filter
LTC1409
+AIN
–AIN
VREF
REFCOMP
AGND
LTC1409 F07
1
2
3
4
5
LTC1560-1
1
2
3
4
8
7
6
5
10
F
0.1
F
5V
0.1
F
–5V
VIN
Figure 7b. 500kHz 5th Order Elliptic Lowpass Filter
LinearView is a trademark of Linear Technology Corporation.
LTC1409
+AIN
–AIN
VREF
REFCOMP
AGND
LTC1409 F07b
1
2
3
4
5
10
F
1000pF
50
ANALOG INPUT
Figure 7a. RC Input Filter
相关PDF资料 |
PDF描述 |
|---|---|
| LTC1410IG#TR | IC ADC 12BIT 1.25MSPS SMP 28SSOP |
| LTC1411IG#TRPBF | IC A/D CONV 14BIT 2.5MSPS 36SSOP |
| LTC1412IG#TR | IC ADC 12BIT 3MSPS SAMPLE 28SSOP |
| LTC1414IGN#TRPBF | IC A/D CONV 14BIT SAMPLNG 28SSOP |
| LTC1415CG#TRPBF | IC A/D CONV 12BIT SAMPLNG 28SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1409ISW | 功能描述:IC A/D CONV 12BIT SAMPLNG 28SOIC RoHS:否 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:12 采样率（每秒）:300k 数据接口:并联 转换器数目:1 功率耗散（最大）:75mW 电压电源:单电源 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:24-SOIC（0.295"，7.50mm 宽） 供应商设备封装:24-SOIC 包装:带卷 (TR) 输入数目和类型:1 个单端，单极；1 个单端，双极 |
| LTC1409ISW#PBF | 功能描述:IC A/D CONV 12BIT SAMPLNG 28SOIC RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:12 采样率（每秒）:300k 数据接口:并联 转换器数目:1 功率耗散（最大）:75mW 电压电源:单电源 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:24-SOIC（0.295"，7.50mm 宽） 供应商设备封装:24-SOIC 包装:带卷 (TR) 输入数目和类型:1 个单端，单极；1 个单端，双极 |
| LTC1409ISW#TR | 功能描述:IC ADC 12BIT 800KSPS SMPL 28SOIC RoHS:否 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:12 采样率（每秒）:300k 数据接口:并联 转换器数目:1 功率耗散（最大）:75mW 电压电源:单电源 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:24-SOIC（0.295"，7.50mm 宽） 供应商设备封装:24-SOIC 包装:带卷 (TR) 输入数目和类型:1 个单端，单极；1 个单端，双极 |
| LTC1409ISW#TRPBF | 功能描述:IC A/D CONV 12BIT SAMPLNG 28SOIC RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:12 采样率（每秒）:300k 数据接口:并联 转换器数目:1 功率耗散（最大）:75mW 电压电源:单电源 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:24-SOIC（0.295"，7.50mm 宽） 供应商设备封装:24-SOIC 包装:带卷 (TR) 输入数目和类型:1 个单端，单极；1 个单端，双极 |
| LTC1410CG | 功能描述:IC A/D CONV 12BIT SAMPLNG 28SSOP RoHS:否 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:12 采样率（每秒）:300k 数据接口:并联 转换器数目:1 功率耗散（最大）:75mW 电压电源:单电源 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:24-SOIC（0.295"，7.50mm 宽） 供应商设备封装:24-SOIC 包装:带卷 (TR) 输入数目和类型:1 个单端，单极；1 个单端，双极 |
发布紧急采购，3分钟左右您将得到回复。