- 您现在的位置：买卖IC网 > PDF目录1827 > LTC1550CGN#TRPBF (Linear Technology)IC REG SWITCHED CAP INV 16SSOP PDF资料下载
参数资料
| 型号： | LTC1550CGN#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 7/12页 |
| 文件大小： | 0K |
| 描述： | IC REG SWITCHED CAP INV 16SSOP |
| 标准包装： | 2,500 |
| 类型： | 切换式电容器（充电泵），反相 |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 可调 |
| 输入电压： | 4.5 V ~ 6.5 V |
| 频率 - 开关： | 900kHz |
| 电流 - 输出： | 20mA |
| 同步整流器： | 无 |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-SSOP（0.154"，3.90mm 宽） |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 16-SSOP |
LTC1550/LTC1551
APPLICATIO N S I N FOR M ATIO N
except that the Shutdown pin is active-high (SHDN). All
members of the LTC1550 family feature a 900kHz charge
pump frequency. The LTC1550/ LTC1551 come standard
with fixed – 4.1V output voltages and the LTC1550 is
PGND, AGND
LTC1550 ADJ
6, 7
10
R1
( )
V OUT = –1.24V
available with an adjustable output voltage. Both devices
can be configured with other fixed output voltages; contact
Linear Technology for more information.
V OUT , SENSE
4, 11
R2
R1 + R2
R2
LTC1550/51 ? F02
The LTC1550 consists of two major blocks (see Block
Diagram): an inverting charge pump and a negative linear
regulator. The charge pump uses two external capacitors,
C1 and C CP to generate a negative voltage at CP OUT . It
operates by charging and discharging C1 on alternate
phases of the internal 900kHz clock. C1 is initially charged
to V CC through switches S1 and S3. When the internal
clock changes phase, S1 and S3 open and S2 and S4 close,
shorting the positive side of C1 to ground. This forces the
negative side of C1 below ground, and charge is transferred
to C CP through S4. As this cycle repeats, the magnitude of
the negative voltage approaches V CC . The 900kHz internal
clock frequency helps keep noise out of 400kHz to 600kHz
IF bands commonly used by portable radio frequency
systems and reduces the size of the external capacitors
required. Most applications can use standard 0.1 μ F ceramic
capacitors for C1 and C CP . Increasing C1 and C CP beyond
0.1 μ F has little effect on the output ripple or the output
current capacity of the LTC1550/LTC1551.
The negative voltage at CP OUT supplies the input to the
negative regulator block. This block consists of an
N-channel MOSFET pass device and a feedback amplifier
that monitors the output voltage and compares it to the
internal reference. The regulated output appears at the
V OUT pin. The regulation loop is optimized for fast tran-
sient response, enabling it to remove most of the switch-
ing artifacts present at the CP OUT pin. Output ripple is
typically below 1mV P-P with output loads between 0mA
and 10mA. The output voltage is set to – 4.1V by a pair of
internal divider resistors. The N-channel pass device mini-
mizes dropout, allowing the output to remain in regulation
with supply voltages as low as 4.5V. An output capacitor
of at least 4.7 μ F from V OUT to ground is required to keep
the regulator loop stable; for optimum stability and mini-
mum output ripple, at least 10 μ F is recommended.
Figure 1. External Resistor Connections
Adjustable Hook-Up
The LTC1550CGN is available in an adjustable output
version in a 16-pin SSOP package. The output voltage is
set with a resistor divider from GND to SENSE/V OUT
(Figure 1). Note that the internal reference and the internal
feedback amplifier are set up as a positive-output regula-
tor referenced to the SENSE pin, not a negative regulator
referenced to ground. The output resistor divider must be
set to provide a 1.24V at the ADJ pin with respect to V OUT .
For example, a – 3V output would require a 13k resistor
from GND to ADJ, and a 9.1k resistor to SENSE/V OUT . If,
after connecting the divider resistors, the output voltage is
not what you expected, try swapping them.
CAPACITOR SELECTION
The LTC1550/LTC1551 requires four external capacitors:
an input bypass capacitor, two 0.1 μ F charge pump capaci-
tors and an output filter capacitor. The overall behavior of
the LTC1550/LTC1551 is strongly affected by the capaci-
tors used. In particular, the output capacitor has a signifi-
cant effect on the output ripple and noise performance.
Proper capacitor selection is critical for optimum perfor-
mance of the LTC1550/LTC1551.
Output Ripple vs Output Capacitor
Figure 3 shows the effect of using different output capaci-
tor values on LTC1550/LTC1551 output ripple. These
curves are taken using the circuit in Figure 2, with
C IN = 4.7 μ F and I LOAD = 5mA. The upper curve shows the
performance with a standard tantalum capacitor alone and
the lower curve shows the tantalum capacitor in parallel
with a 0.1 μ F ceramic capacitor. As a general rule, larger
7
相关PDF资料 |
PDF描述 |
|---|---|
| LTC1553CSW#TRPBF | IC SW REG CNTRLR 5BIT PROG20SOIC |
| LTC1558CS-3.3 | IC BACKUP BATT CNTRLR3.3V 16SOIC |
| LTC1559CS-5 | IC BACKUP BATT CNTRLR 5V 16-SOIC |
| LTC1574CS-3.3#TRPBF | IC REG BUCK INV 3.3V 16SOIC |
| LTC1622CMS8#PBF | IC REG CTRLR BUCK PWM CM 8-MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1550CS8-4.1 | 功能描述:IC REG SWITCHED CAP INV 8SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
| LTC1550CS8-4.1#PBF | 功能描述:IC REG SWITCHED CAP INV 8SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
| LTC1550CS8-4.1#TR | 功能描述:IC REG SWITCHED CAP INV 8SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
| LTC1550CS8-4.1#TRPBF | 功能描述:IC REG SWITCHED CAP INV 8SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
| LTC1550IGN | 功能描述:IC REG SWITCHED CAP INV 16SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
发布紧急采购，3分钟左右您将得到回复。