- 您现在的位置：买卖IC网 > PDF目录17166 > LTC1558CS-3.3#TRPBF (Linear Technology)IC BACKUP BATT CNTRLR3.3V 16SOIC PDF资料下载
参数资料
| 型号： | LTC1558CS-3.3#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 12/20页 |
| 文件大小： | 0K |
| 描述： | IC BACKUP BATT CNTRLR3.3V 16SOIC |
| 标准包装： | 2,500 |
| 功能： | 备份管理 |
| 电池化学： | 镍镉 |
| 电源电压： | 2.9 V ~ 3.46 V |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 16-SOIC |
| 包装： | 带卷 (TR) |
LTC1558-3.3/LTC1558-5
APPLICATIO N S I N FOR M ATIO N
In these cases, the LTC1558 assumes that the backup cell
is exhausted and presets the gas gauge counter to a
default capacity of 128mAhr. It then initiates a recharge
cycle.
Setting the gas gauge to this default value results in a fast
recharge cycle long enough to replenish 1.6 times 128mAhr
of charge into the backup cell (13.9 hours). If the backup
cell is actually exhausted, it will be fully recharged. If the
battery is partially or fully charged, or is significantly
smaller than 128mAhr capacity, the extra charging time
will be wasted. However, the LTC1558’s 15mA fast charge
current should not be high enough to damage the cell.
Once the full-count recharge has been completed, the
backup cell is assumed to be fully charged and subsequent
backup/recharge cycles resume normally.
Although the LTC1558 will not fully recharge backup cells
larger than 128mAhr capacity upon power-up, it can still
be used with such cells. Such a cell will be fully replenished
by the subsequent trickle charge cycle. Under most con-
Battery Backup Cell Trickle Charge
When the gas gauge counter reaches zero, the LTC1558
terminates fast recharge and reduces the recharge current
to the user-programmed trickle current level. The LTC1558
provides a trickle current that the user can program from
50 μ A to 2mA. The trickle current is set by an external
resistor from the positive terminal of the backup cell to the
CTL pin. In trickle charge mode, CTL is regulated to 0.5V,
resulting in a CTL pin current of (V BAT – 0.5)/R EXT . This
current is internally multiplied to feed back ten times the
R EXT current into the backup battery. Since the LTC1558
trickle charges only after the completion of the fast re-
charge cycle, the backup cell voltage should be very close
to 1.2V. This simplifies the calculation of the R EXT resistor
value. For example, a 47k resistor from V BAT to CTL sets
the trickle charge current to approximately 150 μ A.
V CC
ditions, even a partially charged large cell will still be
capable of supporting several hours of backup. For ex-
10I
SW
ample, a small 60mAhr button cell can back up the system
for 20 minutes at an output power of 100mW. Note that at
lower programmed V BAK values, the boost converter effi-
1.2V
NiCd
CELL
+
47 μ F
I
R EXT
ciency improves and allows more backup time from the
CTL
same cell compared to a higher V BAK value.
Once it reaches full recharge, a cell bigger than 512mAhr
is likely to overrun the gas gauge counter before it runs out
of charge during an extended backup cycle. The LTC1558
–
+
1 ×
11 ×
–
gas gauge counter will not roll over if this occurs; it will
stay at full count until the backup cycle ends and then
+
0.5V
LTC1558
partially recharge the cell with a full count cycle as above.
Very short backup cycles (< 32s) may not extract enough
charge from the backup cell to increment the gas gauge
counter at all. To ensure that the backup cell is not slowly
“nibbled” away, the gas gauge counter is always
incremented by 1mAhr each time the controller comes out
of backup. This ensures that the backup cell is always
replenished with at least a 1mAhr charge every time the
LTC1558 enters backup mode.
12
1558 F04
Figure 4. Trickle Current Charger
Undervoltage Lockout
The LTC1558 includes an undervoltage lockout (UVLO)
system that ensures that the system will shutdown grace-
fully if the backup cell is exhausted or overloaded. As
described in the previous section, the LTC1558 will
相关PDF资料 |
PDF描述 |
|---|---|
| V375C12C75B | CONVERTER MOD DC/DC 12V 75W |
| 24101C | INDUCTOR 100UH 0.52A SMD |
| 12RS334C | INDUCT RAD 330UH 0.85A T/H 10X10 |
| LT1579CGN-3#TRPBF | IC LDO REG SMART DUAL 3V 16SSOP |
| GSC15DRES-S13 | CONN EDGECARD 30POS .100 EXTEND |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1558CS-5 | 功能描述:IC BACKUP BATT CNTRLR 5V 16-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 电池管理 系列:- 标准包装:2,000 系列:Impedance Track™ 功能:燃料，电量检测计/监控器 电池化学:锂离子（Li-Ion） 电源电压:2.4 V ~ 2.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:20-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:20-TSSOP 包装:带卷 (TR) 产品目录页面:1020 (CN2011-ZH PDF) 配用:BQ27350EVM-ND - BQ27350EVM 其它名称:296-21665-2 |
| LTC1558CS-5#PBF | 功能描述:IC BACKUP BATT CNTRLR 5V 16-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:- 标准包装:1 系列:- 功能:充电管理 电池化学:锂离子（Li-Ion）、锂聚合物（Li-Pol） 电源电压:3.75 V ~ 6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SC-74A，SOT-753 供应商设备封装:SOT-23-5 包装:剪切带 (CT) 产品目录页面:669 (CN2011-ZH PDF) 其它名称:MCP73831T-2ACI/OTCT |
| LTC1558CS-5#TRPBF | 功能描述:IC BACKUP BATT CNTRLR 5V 16-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:- 标准包装:1 系列:- 功能:充电管理 电池化学:锂离子（Li-Ion）、锂聚合物（Li-Pol） 电源电压:3.75 V ~ 6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SC-74A，SOT-753 供应商设备封装:SOT-23-5 包装:剪切带 (CT) 产品目录页面:669 (CN2011-ZH PDF) 其它名称:MCP73831T-2ACI/OTCT |
| LTC1558CS8-3.3 | 功能描述:IC BACKUP BATT CNTRLR 3.3V 8SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 电池管理 系列:- 标准包装:2,000 系列:Impedance Track™ 功能:燃料，电量检测计/监控器 电池化学:锂离子（Li-Ion） 电源电压:2.4 V ~ 2.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:20-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:20-TSSOP 包装:带卷 (TR) 产品目录页面:1020 (CN2011-ZH PDF) 配用:BQ27350EVM-ND - BQ27350EVM 其它名称:296-21665-2 |
| LTC1558CS8-3.3#PBF | 功能描述:IC BACKUP BATT CNTRLR 3.3V 8SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:- 标准包装:1 系列:- 功能:充电管理 电池化学:锂离子（Li-Ion）、锂聚合物（Li-Pol） 电源电压:3.75 V ~ 6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SC-74A，SOT-753 供应商设备封装:SOT-23-5 包装:剪切带 (CT) 产品目录页面:669 (CN2011-ZH PDF) 其它名称:MCP73831T-2ACI/OTCT |
发布紧急采购，3分钟左右您将得到回复。