- 您现在的位置：买卖IC网 > PDF目录1934 > LTC1569IS8-6#TRPBF (Linear Technology)IC FILTER 10TH ORDR LOWPASS8SOIC PDF资料下载
参数资料
| 型号： | LTC1569IS8-6#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 12/12页 |
| 文件大小： | 0K |
| 描述： | IC FILTER 10TH ORDR LOWPASS8SOIC |
| 标准包装： | 2,500 |
| 滤波器类型： | 线性相位，低通开关电容器 |
| 频率 - 截止或中心： | 300kHz |
| 滤波器数： | 1 |
| 滤波器阶数： | 10th |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 8-SOIC |
| 包装： | 带卷 (TR) |
9
LTC1569-6
DC Accuracy
DC accuracy is defined as the error in the output voltage
after DC offset and DC gain errors are removed. This is
similar to the definition of the integral nonlinearity in A/D
converters. For example, after measuring values of VOUT(DC)
vs VIN(DC) for a typical LTC1569-6, a linear regression
shows that VOUT(DC) = VIN(DC) 0.99854 + 0.00134V is the
straight line that best fits the data. The DC accuracy
describes how much the actual data deviates from this
straight line (i.e., DCERROR = VOUT(DC) –(VIN(DC) 0.99854
+ 0.00134V). In a 12-bit system with a full-scale value of
2V, the LSB is 488
V. Therefore, if the DCERROR of the
filter is less than 488
V over a 2V range, the filter has
12-bit DC accuracy. Figure 9 illustrates the typical DC
accuracy of the LTC1569-6 on a single 5V supply.
DC Offset
The output DC offset of the LTC1569-6 is trimmed to less
than
±5mV. The trimming is performed with VS = 1.9V,
–1.1V with the filter cutoff frequency set to 4kHz (REXT =
10k, DIV/CLK shorted to V +). To obtain optimum DC offset
performance, appropriate PC layout techniques should be
used. The filter IC should be soldered to the PC board. The
power supplies should be well decoupled including a 1
F
ceramic capacitor from V + (Pin 7) to V – (Pin 4). A ground
plane should be used. Noisy signals should be isolated
from the filter input pins.
When the power supply is 3V, the output DC offset should
change less than
±2mV when the clock frequency varies
from 64kHz to 4096kHz. When the clock frequency is
fixed, the output DC offset will typically change by less
than
±3mV (±15mV) when the power supply varies from
3V to 5V (
±5V) in the divide-by-1 mode. In the divide-by-
4 or divide-by-16 modes, the output DC offset will typically
change less than – 9mV (– 27mV) when the power supply
varies from 3V to 5V (
±5V). The offset is measured with
respect to GND (Pin 3).
Aliasing
Aliasing is an inherent phenomenon of sampled data
filters. In lowpass filters significant aliasing only occurs
when the frequency of the input signal approaches the
sampling frequency or multiples of the sampling fre-
APPLICATIONS INFORMATION
WU
U
fCUTOFF), as shown in the Typical Applications section. The
typical variation in dynamic input impedance for a given
clock frequency is
±10%.
Wideband Noise
The wideband noise of the filter is the RMS value of the
device’s output noise spectral density. The wideband
noise data is used to determine the operating signal-to-
noise at a given distortion level. The wideband noise is
nearly independent of the value of the clock frequency and
excludes the clock feedthrough. Most of the wideband
noise is concentrated in the filter passband and cannot be
removed with post filtering (Table 2). Table 3 lists the
typical wideband noise for each supply.
Table 2. Wideband Noise vs Supply Voltage, Single 3V Supply
Bandwidth
Total Integrated Noise
DC to fCUTOFF
80
VRMS
DC to 2 fCUTOFF
95
VRMS
DC to fCLK
110
VRMS
Table 3. Wideband Noise vs Supply Voltage, fCUTOFF = 64kHz
Total Integrated Noise
Power Supply
DC to 2 fCUTOFF
3V
95
VRMS
5V
100
VRMS
±5V
105
VRMS
Clock Feedthrough
Clock feedthrough is defined as the RMS value of the clock
frequency and its harmonics that are present at the filter’s
OUT pin (Pin 8). The clock feedthrough is measured with
IN + and IN – (Pins 1 and 2) grounded and depends on the
PC board layout and the power supply decoupling. Table 4
shows the clock feedthrough (the RMS sum of the first 11
harmonics) when the LTC1569-6 is self-clocked with
REXT = 10k, DIV/CLK (Pin 5) open (divide-by-4 mode). The
clock feedthrough can be reduced with a simple RC post
filter.
Table 4. Clock Feedthrough
Power Supply
Feedthrough
3V
0.1mVRMS
5V
0.3mVRMS
±5V
0.9mVRMS
相关PDF资料 |
PDF描述 |
|---|---|
| LTC1569IS8-7#TRPBF | IC FILTER 10TH ORDR LOWPASS8SOIC |
| LTC1685IS8 | IC TXRX RS485 PREC DELAY 8-SOIC |
| LTC1755EGN#TR | IC SMART CARD INTERFACE 24SSOP |
| LTC1955IUH#TRPBF | IC SMART CARD INTERFACE DL 32QFN |
| LTC202CS#TRPBF | IC SWITCH QUAD SPST 16SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1569IS8-7 | 功能描述:IC FILTER LP 10TH ORD LIN 8SOIC RoHS:否 类别:集成电路 (IC) >> 接口 - 滤波器 - 有源 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1,000 系列:- 滤波器类型:连续时间，带通低通 频率 - 截止或中心:150kHz 滤波器数:4 滤波器阶数:8th 电源电压:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) |
| LTC1569IS8-7#PBF | 功能描述:IC FILTER 10TH ORDR LOWPASS8SOIC RoHS:是 类别:集成电路 (IC) >> 接口 - 滤波器 - 有源 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1,000 系列:- 滤波器类型:连续时间，带通低通 频率 - 截止或中心:150kHz 滤波器数:4 滤波器阶数:8th 电源电压:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) |
| LTC1569IS8-7#TR | 功能描述:IC FILTER LP 10TH ORD LIN 8SOIC RoHS:否 类别:集成电路 (IC) >> 接口 - 滤波器 - 有源 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1,000 系列:- 滤波器类型:连续时间，带通低通 频率 - 截止或中心:150kHz 滤波器数:4 滤波器阶数:8th 电源电压:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) |
| LTC1569IS8-7#TRPBF | 功能描述:IC FILTER 10TH ORDR LOWPASS8SOIC RoHS:是 类别:集成电路 (IC) >> 接口 - 滤波器 - 有源 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1,000 系列:- 滤波器类型:连续时间，带通低通 频率 - 截止或中心:150kHz 滤波器数:4 滤波器阶数:8th 电源电压:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) |
| LTC1574CS | 功能描述:IC REG BUCK INV ADJ 16SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
发布紧急采购，3分钟左右您将得到回复。