- 您现在的位置：买卖IC网 > PDF目录15310 > LTC1622CMS8 (Linear Technology)IC REG CTRLR BUCK PWM CM 8-MSOP PDF资料下载
参数资料
| 型号： | LTC1622CMS8 |
| 厂商： | Linear Technology |
| 文件页数： | 8/16页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 8-MSOP |
| 标准包装： | 50 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 625kHz |
| 占空比： | 100% |
| 电源电压： | 2 V ~ 10 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 8-TSSOP，8-MSOP（0.118"，3.00mm 宽） |
| 包装： | 管件 |
| 产品目录页面： | 1333 (CN2011-ZH PDF) |
LTC1622
APPLICATIO N S I N FOR M ATIO N
preferred at high switching frequencies, so design goals
can concentrate on copper loss and preventing saturation.
Ferrite core materials saturate “hard,” which means that
In applications where the maximum duty cycle is less than
100% and the LTC1622 is in continuous mode, the R DS(ON)
is governed by:
( DC ) I OUT ( 1 + δ p )
the inductance collapses abruptly when the peak design
current is exceeded. This results in an abrupt increase in
inductor ripple current and consequently, output voltage
ripple. Do not allow the core to saturate!
R DS ( ON ) ?
P P
2
( ) ( ) p δ R DS ( ON )
V OUT + V D
P MOSFET =
1 +
+ V
+ K ( V IN ) ( I OUT )( C RSS )( )
Molypermalloy(fromMagnetics,Inc.)isaverygood,low
loss core material for toroids, but it is more expensive than
ferrite. A reasonable compromise from the same manu-
facturer is Kool Mu. Toroids are very space efficient,
especially when you can use several layers of wire.
Because they generally lack a bobbin, mounting is more
difficult. However, new surface mountable designs that do
not increase the height significantly are available.
Power MOSFET Selection
An external P-channel power MOSFET must be selected
for use with the LTC1622. The main selection criteria for
the power MOSFET are the threshold voltage V GS(TH) and
the “on” resistance R DS(ON) ,reverse transfer capacitance
C RSS and total gate charge.
Since the LTC1622 is designed for operation down to low
input voltages, a sublogic level threshold MOSFET (R DS(ON)
guaranteed at V GS = 2.5V) is required for applications that
work close to this voltage. When these MOSFETs are used,
make sure that the input supply to the LTC1622 is less than
the absolute maximum MOSFET V GS rating, typically 8V.
The gate drive voltage levels are from ground to V IN .
The required minimum R DS(ON) of the MOSFET is gov-
erned by its allowable power dissipation. For applications
that may operate the LTC1622 in dropout, i.e., 100% duty
cycle, at its worst case the required R DS(ON) is given by:
where DC is the maximum operating duty cycle of the
LTC1622.
When the LTC1622 is operating in continuous mode, the
MOSFET power dissipation is:
2
I OUT
V IN D
2
f
where K is a constant inversely related to gate drive
current. Because of the high switching frequency, the
second term relating to switching loss is important not to
overlook. The constant K = 3 can be used to estimate the
contributions of the two terms in the MOSFET dissipation
equation.
Output Diode Selection
The catch diode carries load current during the off-time.
The average diode current is therefore dependent on the
P-channel switch duty cycle. At high input voltages the
diode conducts most of the time. As V IN approaches V OUT
the diode conducts only a small fraction of the time. The
most stressful condition for the diode is when the output
is short circuited. Under this condition the diode must
safely handle I PEAK at close to 100% duty cycle. Therefore,
( I OUT ( MAX ) ) ( ) p δ
1 +
R DS ( ON ) DC = 100 % =
P P
2
it is important to adequately specify the diode peak current
and average power dissipation so as not to exceed the
diode ratings.
I D = ? IN OUT ? I OUT
whereP P istheallowablepowerdissipationandδpisthe
temperature dependency of R DS(ON) . (1 + δ p) is generally
given for a MOSFET in the form of a normalized R DS(ON) vs
temperature curve, but δ p = 0.005/ ° C can be used as an
approximation for low voltage MOSFETs.
8
Under normal load conditions, the average current con-
ducted by the diode is:
? V ? V ?
? V IN + V D ?
相关PDF资料 |
PDF描述 |
|---|---|
| VI-2WD-EW-F3 | CONVERTER MOD DC/DC 85V 100W |
| LT1725IS#TRPBF | IC REG CTRLR FLYBK ISO CM 16SOIC |
| SRP1235-R47M | INDUCTOR 470NH 32A SMD |
| EEC49DREH-S93 | CONN EDGECARD 98POS .100 EYELET |
| ADM1060ARU-REEL | IC SUPERVISOR/SEQUENCER 28TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1622CMS8#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 8-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC1622CMS8#TR | 功能描述:IC REG CTRLR BUCK PWM CM 8-MSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC1622CMS8#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 8-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC1622CS8 | 功能描述:IC REG CTRLR BUCK PWM CM 8-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC1622CS8#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 8-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
发布紧急采购，3分钟左右您将得到回复。