- 您现在的位置：买卖IC网 > PDF目录15278 > LTC1625CS#TR (Linear Technology)IC REG CTRLR BUCK PWM CM 16-SOIC PDF资料下载
参数资料
| 型号： | LTC1625CS#TR |
| 厂商： | Linear Technology |
| 文件页数： | 16/24页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 16-SOIC |
| 标准包装： | 2,500 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 165kHz |
| 占空比： | 99% |
| 电源电压： | 3.7 V ~ 36 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 16-SOIC（0.154"，3.90mm 宽） |
| 包装： | 带卷 (TR) |
LTC1625
APPLICATIO N S I N FOR M ATIO N
where L1, L2, etc. are the individual losses as a percentage
of input power. It is often useful to analyze individual
losses to determine what is limiting the efficiency and
which change would produce the most improvement.
Although all dissipative elements in the circuit produce
losses, four main sources usually account for most of the
losses in LTC1625 circuits:
1. INTV CC current. This is the sum of the MOSFET driver
and control currents. The driver current results from
switching the gate capacitance of the power MOSFETs.
Each time a MOSFET gate is switched on and then off,
a packet of gate charge Q g moves from INTV CC to
ground. The resulting current out of INTV CC is typically
much larger than the control circuit current. In continu-
ous mode, I GATECHG = f(Q g(TOP) + Q g(BOT) ).
By powering EXTV CC from an output-derived source,
the additional V IN current resulting from the driver and
control currents will be scaled by a factor of Duty Cycle/
Efficiency. For example, in a 20V to 5V application at
400mA load, 10mA of INTV CC current results in ap-
proximately 3mA of V IN current. This reduces the loss
from 10% (if the driver was powered directly from V IN )
to about 3%.
2. DC I 2 R Losses. Since there is no separate sense resis-
tor, DC I 2 R losses arise only from the resistances of the
MOSFETs and inductor. In continuous mode the aver-
age output current flows through L, but is “chopped”
between the top MOSFET and the bottom MOSFET. If
the two MOSFETs have approximately the same R DS(ON) ,
then the resistance of one MOSFET can simply be
summed with the resistance of L to obtain the DC I 2 R
loss. For example, if each R DS(ON) = 0.05 ? and R L =
0.15 ? , then the total resistance is 0.2 ? . This results in
losses ranging from 2% to 8% as the output current
increases from 0.5A to 2A for a 5V output. I 2 R losses
cause the efficiency to drop at high output currents.
3. Transition losses apply only to the topside MOSFET,
and only when operating at high input voltages (typi-
cally 20V or greater). Transition losses can be esti-
mated from:
Transition Loss = (1.7)(V IN2 )(I O(MAX) )(C RSS )(f)
16
4. LTC1625 V IN supply current. The V IN current is the DC
supply current to the controller excluding MOSFET gate
drive current. Total supply current is typically about
850 μ A. If EXTV CC is connected to 5V, the LTC1625 will
draw only 330 μ A from V IN and the remaining 520 μ A will
come from EXTV CC . V IN current results in a small
(< 1%) loss which increases with V IN .
Other losses including C IN and C OUT ESR dissipative
losses, Schottky conduction losses during dead time
and inductor core losses, generally account for less
than 2% total additional loss.
Checking Transient Response
The regulator loop response can be checked by looking at
the load transient response. Switching regulators take
several cycles to respond to a step in DC (resistive) load
current. When a load step occurs, V OUT immediately shifts
by an amount equal to ( ? I LOAD )(ESR), where ESR is the
effective series resistance of C OUT , and C OUT begins to
charge or discharge. The regulator loop acts on the
resulting feedback error signal to return V OUT to its steady-
state value. During this recovery time V OUT can be moni-
tored for overshoot or ringing which would indicate a
stability problem. The I TH pin external components shown
in Figure 1 will provide adequate compensation for most
applications.
A second, more severe transient is caused by connecting
loads with large (> 1 μ F) supply bypass capacitors. The
discharged bypass capacitors are effectively put in parallel
with C OUT , causing a rapid drop in V OUT . No regulator can
deliver enough current to prevent this problem if the load
switch resistance is low and it is driven quickly. The only
solution is to limit the rise time of the switch drive in order
to limit the inrush current to the load.
Automotive Considerations: Plugging into the
Cigarette Lighter
As battery-powered devices go mobile, there is a natural
interest in plugging into the cigarette lighter in order to
conserve or even recharge battery packs during opera-
tion. But before you connect, be advised: you are plug-
ging into the supply from hell. The main battery line in an
相关PDF资料 |
PDF描述 |
|---|---|
| EBM43DTMI-S189 | CONN EDGECARD 86POS R/A .156 SLD |
| B43086F2226M | 22UF 250V 12.5X20 SINGLE END |
| LTC1159CS#TRPBF | IC REG CTRLR BUCK PWM CM 16-SOIC |
| GBA50DRSI-S288 | CONN EDGECARD 100POS .125 EXTEND |
| HBC18DRXH | CONN EDGECARD 36POS DIP .100 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1625IGN | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1625IGN#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC1625IGN#TR | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1625IGN#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1625IGNPBF | 制造商:Linear Technology 功能描述:No RSENSE Current Mode Regulator SSOP16 |
发布紧急采购，3分钟左右您将得到回复。