- 您现在的位置：买卖IC网 > PDF目录15251 > LTC1625IS (Linear Technology)IC REG CTRLR BUCK PWM CM 16-SOIC PDF资料下载
参数资料
| 型号： | LTC1625IS |
| 厂商： | Linear Technology |
| 文件页数： | 11/24页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 16-SOIC |
| 标准包装： | 50 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 165kHz |
| 占空比： | 99% |
| 电源电压： | 3.9 V ~ 36 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 16-SOIC（0.154"，3.90mm 宽） |
| 包装： | 管件 |
LTC1625
APPLICATIO N S I N FOR M ATIO N
The corresponding average current depends on the amount
of ripple current. Lower inductor values (higher ? I L ) will
reduce the load current at which Burst Mode operation
begins.
The output voltage ripple can increase during Burst Mode
operation if ? I L is substantially less than I BURST . This will
primarily occur when the duty cycle is very close to unity
(V IN is close to V OUT ) or if very large value inductors are
chosen. This is generally only a concern in applications
with V OUT ≥ 5V. At high duty cycles, a skipped cycle
causes the inductor current to quickly descend to zero.
However, it takes multiple cycles to ramp the current back
up to I BURST(PEAK) . During this interval, the output capaci-
tor must supply the load current and enough charge may
be lost to cause significant droop in the output voltage. It
is a good idea to keep ? I L comparable to I BURST(PEAK) .
Otherwise, one might need to increase the output capaci-
tance in order to reduce the voltage ripple or else disable
Burst Mode operation by forcing continuous operation
with the FCB pin.
maximum values for R DS(ON) , but not a minimum. A
reasonable, but perhaps overly conservative, assumption
is that the minimum R DS(ON) lies the same amount below
the typical value as the maximum R DS(ON) lies above it.
Consult the MOSFET manufacturer for further guidelines.
The LTC1625 includes current foldback to help further
limit load current when the output is shorted to ground. If
the output falls by more than half, then the maximum
sense voltage is progressively lowered from 150mV to
30mV. Under short-circuit conditions with very low duty
cycle, the LTC1625 will begin skipping cycles in order to
limit the short-circuit current. In this situation the bottom
MOSFET R DS(ON) will control the inductor current trough
rather than the top MOSFET controlling the inductor
current peak. The short-circuit ripple current is deter-
mined by the minimum on-time t ON(MIN) of the LTC1625
(approximately 0.5 μ s), the input voltage, and inductor
value:
? I L(SC) = t ON(MIN) V IN /L.
The resulting short-circuit current is:
+ ? I L ( SC )
Fault Conditions: Current Limit and Output Shorts
The LTC1625 current comparator can accommodate a
maximum sense voltage of 150mV. This voltage and the
I SC =
( R DS ( ON )( BOT ) )( ρ T )
30 mV
1
2
sense resistance determine the maximum allowed peak
inductor current. The corresponding output current limit
is:
Normally, the top and bottom MOSFETs will be of the same
type. A bottom MOSFET with lower R DS(ON) than the top
may be chosen if the resulting increase in short-circuit
– ? I L
I LIMIT =
( R DS ( ON ) )( ρ T )
150 mV
1
2
current is tolerable. However, the bottom MOSFET should
never be chosen to have a higher nominal R DS(ON) than the
top MOSFET.
The current limit value should be checked to ensure that
I LIMIT(MIN) > I O(MAX) . The minimum value of current limit
generally occurs with the largest V IN at the highest ambi-
ent temperature, conditions which cause the highest power
dissipation in the top MOSFET. Note that it is important to
check for self-consistency between the assumed junction
temperature of the top MOSFET and the resulting value of
I LIMIT which heats the junction.
Caution should be used when setting the current limit
based upon R DS(ON) of the MOSFETs. The maximum
current limit is determined by the minimum MOSFET on-
resistance. Data sheets typically specify nominal and
Inductor Core Selection
Once the value for L is known, the type of inductor must be
selected. High efficiency converters generally cannot
afford the core loss found in low cost powdered iron cores,
forcing the use of more expensive ferrite, molypermalloy
or Kool M μ ? cores. Actual core loss is independent of core
size for a fixed inductor value, but it is very dependent on
the inductance selected. As inductance increases, core
losses go down. Unfortunately, increased inductance
requires more turns of wire and therefore copper losses
will increase.
Kool M μ is a registered trademark of Magnetics, Inc.
11
相关PDF资料 |
PDF描述 |
|---|---|
| VE-2T3-EY-B1 | CONVERTER MOD DC/DC 24V 50W |
| NCP300LSN34T1G | IC DETECTOR VOLTAGE 3.4V 5TSOP |
| SLPX152M080A3P3 | CAP ALUM 1500UF 80V 20% SNAP |
| VE-J54-EY-F2 | CONVERTER MOD DC/DC 48V 50W |
| SK100M400ST | CAP ALUM 10UF 400V 20% RADIAL |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1625IS#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC1625IS#PBF | 制造商:Linear Technology 功能描述:IC SYNC STEP-DOWN REGULATOR 16-SOIC |
| LTC1625IS#TR | 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1625IS#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1625ISPBF | 制造商:Linear Technology 功能描述:No RSENSE Current Mode Regulator SOIC16 |
发布紧急采购，3分钟左右您将得到回复。