- 您现在的位置：买卖IC网 > PDF目录98002 > LTC1626CS#TR (LINEAR TECHNOLOGY CORP) 1.6 A SWITCHING REGULATOR, PDSO14 PDF资料下载
参数资料
| 型号： | LTC1626CS#TR |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | 1.6 A SWITCHING REGULATOR, PDSO14 |
| 封装： | 0.150 INCH, PLASTIC, SO-14 |
| 文件页数： | 9/12页 |
| 文件大小： | 258K |
| 代理商： | LTC1626CS#TR |
6
LTC1626
APPLICATIONS INFORMATION
WU
U
inductor current should be continuous during burst peri-
ods. Hence, the peak-to-peak inductor ripple current must
not exceed 25mV/RSENSE.
To account for light load conditions, the IOUT(MAX) is then
given by:
IOUT(MAX) = 150mV/RSENSE – 25mV/2RSENSE (A)
= 137.5mV/RSENSE (A)
Solving for RSENSE and allowing a margin of variations in
the LTC1626 and external component values yields:
RSENSE = 100mV/IOUT(MAX) ()
The LTC1626 switch is capable of supplying a maximum
of 1.2A of output current.
Therefore, the minimum value
of RSENSE that can be used is 0.083. A graph for
selecting RSENSE versus maximum output current is given
in Figure 2.
Operating Frequency Considerations
For most applications, the LTC1626 should be operated in
the 100kHz to 300kHz range. This range can be extended,
however, up to 600kHz, to accommodate smaller size/
valued inductors, such as low profile types, with a slight
decrease in efficiency due to gate charge losses. Some
experimentation may be required to determine the opti-
mum operating frequency for a particular set of external
components and operating conditions.
CT and L Selection
The value of CT is calculated from the desired continuous
mode operating frequency:
C
VV
V
f
F
T
IN
OUT
IN
D
IN
BE
O
=
()
+
()( )
()( ) ()
3300
where VD is the drop across the Schottky diode D1 and VBE
is a base-emitter voltage drop (0.6V).
The complete expression for operating frequency is given
by:
f
t
VV
Hz
O
OFF
IN
OUT
IN
D
≈
+
()
1
where:
tC
V
OFF
T
IN
BE
=
()( )
() ( )
3300
sec
Figure 3 is a graph of operating frequency versus power
supply voltage for the 2.5V regulator circuit shown in
Figure 1 (CT = 270pF). Note that the frequency is relatively
constant with supply voltage but drops as the supply
voltage approaches the regulated output voltage.
To maintain continuous inductor current at light load, the
inductor must be chosen to provide no more than 25mV/
RSENSE of peak-to-peak ripple current. This results in the
following expression for L:
LRSENSE
≥
()
()( )(
) ( )
52 105
.
C
V
H
T
REG
Using an inductance smaller than the above value will
result in inductor current being discontinuous. As a con-
MAXIMUM OUTPUT CURRENT (A)
0.5
0.4
0.3
0.2
0.1
0
R
SENSE
(
)
1626 F02
0.6
0.8
1.0
0.4
0
0.2
Figure 2. Selecting RSENSE
During a short circuit of the regulator output to ground, the
peak current is determined by:
ISC = 150mV/RSENSE (A)
In this condition, the LTC1626 automatically extends the
off-time period of the P-channel MOSFET switch to allow
the inductor current to decay far enough to prevent any
current buildup. The resulting ripple current causes the
average current to be approximately IOUT(MAX).
相关PDF资料 |
PDF描述 |
|---|---|
| LTC1732EMS-4.2#TR | BATTERY CHARGE CONTROLLER, PDSO10 |
| LTC1772IS6#PBF | 1 A SWITCHING CONTROLLER, 650 kHz SWITCHING FREQ-MAX, PDSO6 |
| LTC1938IDD#TRPBF | 4 A SWITCHING REGULATOR, 3300 kHz SWITCHING FREQ-MAX, PDSO10 |
| LTC1955IUH#TR | 2-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC32 |
| LTC1955IUH | 2-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC32 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1627CS8 | 功能描述:IC REG BUCK SYNC ADJ 0.5A 8SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
| LTC1627CS8#PBF | 功能描述:IC REG BUCK SYNC ADJ 0.5A 8SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LTC1627CS8#TR | 功能描述:IC REG BUCK SYNC ADJ 0.5A 8SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
| LTC1627CS8#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 0.5A 8SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
| LTC1627IS8 | 功能描述:IC REG BUCK SYNC ADJ 0.5A 8SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
发布紧急采购，3分钟左右您将得到回复。