- 您现在的位置：买卖IC网 > PDF目录20625 > LTC1704EGN#TR (Linear Technology)IC REG DL BUCK/LINEAR 16SSOP PDF资料下载
参数资料
| 型号： | LTC1704EGN#TR |
| 厂商： | Linear Technology |
| 文件页数： | 7/28页 |
| 文件大小： | 347K |
| 描述： | IC REG DL BUCK/LINEAR 16SSOP |
| 标准包装： | 2,500 |
| 拓扑： | 降压（降压）（1），线性（LDO）（1） |
| 功能： | 任何功能 |
| 输出数： | 2 |
| 频率 - 开关： | 550kHz |
| 电压/电流 - 输出 1： | 控制器 |
| 电压/电流 - 输出 2： | 控制器 |
| 带 LED 驱动器： | 无 |
| 带监控器： | 无 |
| 带序列发生器： | 无 |
| 电源电压： | 3.15 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-SSOP（0.154"，3.90mm 宽） |
| 供应商设备封装： | 16-SSOP |
| 包装： | 带卷 (TR) |
| 其它名称： | LTC1704EGNTR |
第1页第2页第3页第4页第5页第6页当前第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LTC1704/LTC1704B
7
1704bfa
PI FU CTIO S
U
U
TG (Pin 1): Switcher Controller Top Gate Drive. The TG pin
drives the gate of the top N-channel MOSFET, QT. The TG
driver draws power from the BOOST pin and returns it to
the SW pin, providing true floating drive to QT. TG is de-
signed to typically drive up to 10,000pF of gate capacitance.
SW (Pin 2): Switcher Controller Switching Node. Connect
SW to the switching node of the main converter. The TG
driver ground returns to SW, providing floating gate drive
to the top N-channel MOSFET, QT. The voltage at SW is
compared to I
MAX
by the current limit comparator while
the bottom MOSFET, QB is on. The Burst comparator
(BURST, see Block Diagram) monitors the potential at SW
and switches to Burst Mode operation under light load
conditions.
I
MAX
(Pin 3): Switcher Controller Current Limit Set. The
I
MAX
pin sets the current limit comparator threshold for
the switcher controller. If the voltage drop across the
bottom MOSFET, QB, exceeds the magnitude of the volt-
age at I
MAX
, the switcher controller enters current limit.
The I
MAX
pin has an internal 10礎 current source pull-up,
allowing the current threshold to be set with a single
external resistor to PGND. Kelvin connect this current
setting resistor to the source of QB. Refer to the Current
Limit Programming section for more information on choos-
ing R
IMAX
.
RUN/SS (Pin 4): Switcher Controller Soft-Start. A capaci-
tor from RUN/SS to GND controls the turn-on time and
rate of rise of the switcher output voltage at power up. An
internal 3礎 current source pull-up at RUN/SS sets the
turn-on time at approximately 300ms/礔. If both RUN/SS
and REGILM are pulled low, the LTC1704 enters shutdown
mode.
COMP (Pin 5): Switcher Controller Loop Compensation.
The COMP pin is connected directly to the output of the
switcher controllers error amplifier and the input to the
PWM comparator. Use an RC network between the COMP
pin and the FB pin to compensate the feedback loop for
optimum transient response.
FB (Pin 6): Switcher Controller Feedback Input. FB should
be connected through a resistor divider network to V
OUTSW
to set the switcher output voltage. Also, connect the
switcher loop compensation network to FB.
REGDR (Pin 7): Linear Regulator Controller Driver Output.
Connect REGDR to the base of the external NPN Pass
transistor. The REGILM pin input current controls the
linear regulator controller maximum driving capability.
GND (Pin 8): Signal Ground. All internal low power cir-
cuitry returns to the GND pin. Connect to a low impedance
ground, separated from the PGND node. All feedback,
TYPICAL PERFOR A CE CHARACTERISTICS
W
Supply Current vs Temperature
I
PVCC
, I
BOOST
vs Driver Load
TEMPERATURE (癈)
50
0
1.5
3.0
4.5
6.0
25 0 25 50
1704 G26
75 100 125
I
VCC
I
PVCC
I
BOOST
V
CC
= PV
CC
= BOOST = 5V
TG, BG FLOAT
TG, BG LOAD (pF)
0
0
5
15
20
25
35
1704 G27
10
30
4000
10000
2000
6000 8000
T
A
= 25癈
PV
CC
= BOOST = 5V
相关PDF资料 |
PDF描述 |
|---|---|
| LT3500HDD#PBF | IC REG DL BUCK/LINEAR 12-DFN |
| LT3500IMSE#PBF | IC REG DL BUCK/LINEAR 16-MSOP |
| LTC1704BEGN | IC REG DL BUCK/LINEAR 16-SSOP |
| GBM22DRXN | CONN EDGECARD 44POS DIP .156 SLD |
| ADE7759ARSZRL | IC ENERGY METERING 1PHASE 20SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1705EGN | 功能描述:IC PWR SUPPLY CONTROLLER 28SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 电源控制器，监视器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 应用:多相控制器 输入电压:- 电源电压:9 V ~ 14 V 电流 - 电源:- 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:40-WFQFN 裸露焊盘 供应商设备封装:40-TQFN-EP（5x5） 包装:带卷 (TR) |
| LTC1705EGN#PBF | 功能描述:IC PWR SUPPLY CONTROLLER 28SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 电源控制器，监视器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 应用:多相控制器 输入电压:- 电源电压:9 V ~ 14 V 电流 - 电源:- 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:40-WFQFN 裸露焊盘 供应商设备封装:40-TQFN-EP（5x5） 包装:带卷 (TR) |
| LTC1705EGN#TR | 功能描述:IC PWR SUPPLY CONTROLLER 28SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 电源控制器，监视器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 应用:多相控制器 输入电压:- 电源电压:9 V ~ 14 V 电流 - 电源:- 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:40-WFQFN 裸露焊盘 供应商设备封装:40-TQFN-EP（5x5） 包装:带卷 (TR) |
| LTC1705EGN#TRPBF | 功能描述:IC PWR SUPPLY CONTROLLER 28SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 电源控制器，监视器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 应用:多相控制器 输入电压:- 电源电压:9 V ~ 14 V 电流 - 电源:- 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:40-WFQFN 裸露焊盘 供应商设备封装:40-TQFN-EP（5x5） 包装:带卷 (TR) |
| LTC1706CS8-19 | 功能描述:IC VID VOLTAGE PROGRAMMER 8SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 电源控制器，监视器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 应用:多相控制器 输入电压:- 电源电压:9 V ~ 14 V 电流 - 电源:- 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:40-WFQFN 裸露焊盘 供应商设备封装:40-TQFN-EP（5x5） 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。