参数资料
型号: LTC1709EG-7#PBF
厂商: Linear Technology
文件页数: 16/28页
文件大小: 0K
描述: IC REG CTRLR BUCK PWM CM 36-SSOP
标准包装: 37
PWM 型: 电流模式
输出数: 1
频率 - 最大: 360kHz
占空比: 99.5%
电源电压: 4 V ~ 36 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 85°C
封装/外壳: 36-SSOP(0.209",5.30mm 宽)
包装: 管件
产品目录页面: 1339 (CN2011-ZH PDF)
LTC1709-7
APPLICATIO S I FOR ATIO
50mA peak and must be bypassed to power ground with
a minimum of 4.7 μ F tantalum or electrolytic capacitor. An
additional 1 μ F ceramic capacitor placed very close to the
IC is recommended due to the extremely high instanta-
neous currents required by the MOSFET gate drivers.
High input voltage applications in which large MOSFETs
are being driven at high frequencies may cause the maxi-
mum junction temperature rating for the LTC1709-7 to be
exceeded. The supply current is dominated by the gate
charge supply current, in addition to the current drawn
from the differential amplifier output. The gate charge is
dependent on operating frequency as discussed in the
Efficiency Considerations section. The supply current can
either be supplied by the internal 5V regulator or via the
EXTV CC pin. When the voltage applied to the EXTV CC pin
is less than 4.7V, all of the INTV CC load current is supplied
by the internal 5V linear regulator. Power dissipation for
the IC is higher in this case by (I IN )(V IN – INTV CC ) and
efficiency is lowered. The junction temperature can be
estimated by using the equations given in Note 1 of the
Electrical Characteristics. For example, the LTC1709-7 V IN
current is limited to less than 24mA from a 24V supply:
T J = 70 ° C + (24mA)(24V)(85 ° C/W) = 119 ° C
Use of the EXTV CC pin reduces the junction temperature
to:
T J = 70 ° C + (24mA)(5V)(85 ° C/W) = 80.2 ° C
The input supply current should be measured while the
controller is operating in continuous mode at maximum
V IN and the power dissipation calculated in order to
prevent the maximum junction temperature from being
exceeded.
EXTV CC Connection
The LTC1709-7 contains an internal P-channel MOSFET
switch connected between the EXTV CC and INTV CC pins.
When the voltage applied to EXTV CC rises above 4.7V, the
internal regulator is turned off and an internal switch
closes, connecting the EXTV CC pin to the INTV CC pin
thereby supplying internal and MOSFET gate driving power
to the IC. The switch remains closed as long as the voltage
16
applied to EXTV CC remains above 4.5V. This allows the
MOSFET driver and control power to be derived from the
output during normal operation (4.7V < V EXTVCC < 7V) and
from the internal regulator when the output is out of
regulation (start-up, short-circuit). Do not apply greater
than 7V to the EXTV CC pin and ensure that EXTV CC < V IN +
0.3V when using the application circuits shown. If an
external voltage source is applied to the EXTV CC pin when
the V IN supply is not present, a diode can be placed in
series with the LTC1709-7’s V IN pin and a Schottky diode
between the EXTV CC and the V IN pin, to prevent current
from backfeeding V IN .
Significant efficiency gains can be realized by powering
INTV CC from the output, since the V IN current resulting
from the driver and control currents will be scaled by the
ratio: (Duty Factor)/(Efficiency). For 5V regulators this
means connecting the EXTV CC pin directly to V OUT . How-
ever, for 3.3V and other lower voltage regulators, addi-
tional supply circuitry is required to derive INTV CC power
from the output.
The following list summarizes the four possible connec-
tions for EXTV CC:
1. EXTV CC left open (or grounded). This will cause INTV CC
to be powered from the internal 5V regulator resulting in
a significant efficiency penalty at high input voltages.
2. EXTV CC connected directly to V OUT . This is the normal
connection for a 5V regulator and provides the highest
efficiency.
3. EXTV CC connected to an external supply. If an external
supply is available in the 5V to 7V range, it may be used to
power EXTV CC providing it is compatible with the MOSFET
gate drive requirements.
4. EXTV CC connected to an output-derived boost network.
For 3.3V and other low voltage regulators, efficiency gains
can still be realized by connecting EXTV CC to an output-
derived voltage which has been boosted to greater than
4.7V but less than 7V. This can be done with either the
inductive boost winding as shown in Figure 5a or the
capacitive charge pump shown in Figure 5b. The charge
pump has the advantage of simple magnetics.
相关PDF资料
PDF描述
LTC1709EG-7 IC REG CTRLR BUCK PWM CM 36-SSOP
LTC3830EGN#PBF IC REG CTRLR BUCK PWM VM 16-SSOP
LTC1149CN-3.3 IC REG CTRLR BUCK PWM CM 16-DIP
RCC36DRES-S13 CONN EDGECARD 72POS .100 EXTEND
LTC1628CUH#PBF IC REG CTRLR BUCK PWM CM 32-QFN
相关代理商/技术参数
参数描述
LTC1709EG-8 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC1709EG-8#PBF 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP(0.173",4.40mm 宽) 包装:带卷 (TR)
LTC1709EG-8#TR 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC1709EG-8#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC1709EG-85 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX