- 您现在的位置：买卖IC网 > PDF目录10228 > LTC1745IFW#PBF (Linear Technology)IC ADC 12BIT 25MSPS LN 48TSSOP PDF资料下载
参数资料
| 型号： | LTC1745IFW#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 5/20页 |
| 文件大小： | 0K |
| 描述： | IC ADC 12BIT 25MSPS LN 48TSSOP |
| 标准包装： | 39 |
| 位数： | 12 |
| 采样率（每秒）： | 25M |
| 数据接口： | 并联 |
| 转换器数目： | 1 |
| 功率耗散（最大）： | 455mW |
| 电压电源： | 单电源 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 48-TFSOP（0.240"，6.10mm 宽） |
| 供应商设备封装： | 48-TSSOP |
| 包装： | 管件 |
| 输入数目和类型： | 2 个单端，双极；1 个差分，双极 |
13
LTC1745
1745f
APPLICATIO S I FOR ATIO
WU
UU
Input Drive Impedance
As with all high performance, high speed ADCs the dy-
namic performance of the LTC1745 can be influenced by
the input drive circuitry, particularly the second and third
harmonics. Source impedance and input reactance can
influence SFDR. At the falling edge of encode the sample-
and-hold circuit will connect the 4pF sampling capacitor to
the input pin and start the sampling period. The sampling
period ends when encode rises, holding the sampled input
on the sampling capacitor. Ideally the input circuitry
should be fast enough to fully charge the sampling capaci-
tor during the sampling period 1/(2FENCODE); however,
this is not always possible and the incomplete settling may
degrade the SFDR. The sampling glitch has been designed
to be as linear as possible to minimize the effects of
incomplete settling.
For the best performance, it is recomended to have a
source impedence of 100
or less for each input. The S/H
circuit is optimized for a 50
source impedance. If the
source impedance is less than 50
, a series resistor
should be added to increase this impedance to 50
. The
source impedence should be matched for the differential
inputs. Poor matching will result in higher even order
harmonics, especially the second.
Input Drive Circuits
Figure 3 shows the LTC1745 being driven by an RF
transformer with a center tapped secondary. The second-
ary center tap is DC biased with VCM, setting the ADC input
signal at its optimum DC level. Figure 3 shows a 1:1 turns
ratio transformer. Other turns ratios can be used if the
source impedence seen by the ADC does not exceed
100
for each ADC input. A disadvantage of using a
transformer is the loss of low frequency response. Most
small RF transformers have poor performance at frequen-
cies below 1MHz.
Figure 4 demonstrates the use of operational amplifiers to
convert a single ended input signal into a differential input
signal. The advantage of this method is that it provides low
frequency input response; however, the limited gain band-
width of most op amps will limit the SFDR at high input
frequencies.
The 25
resistors and 12pF capacitors on the analog
inputs serve two purposes: isolating the drive circuitry
from the sample-and-hold charging glitches and limiting
the wideband noise at the converter input. For input
frequencies higher than 50MHz, the capacitors may need
to be decreased to prevent excessive signal loss.
Figure 3. Single-Ended to Differential
Conversion Using a Transformer
Figure 4. Differential Drive with Op Amps
1:1
25
0.1
F
ANALOG
INPUT
VCM
AIN
+
AIN
–
100
100
12pF
1745 F03
4.7
F
25
25
25
LTC1745
25
5V
SINGLE-ENDED
INPUT
2.35V
±1/2
RANGE
VCM
AIN
+
AIN
–
12pF
1745 F04
4.7
F
25
25
100
500
500
25
LTC1745
–
+
1/2 LT1810
–
+
1/2 LT1810
相关PDF资料 |
PDF描述 |
|---|---|
| SP1485EEN-L/TR | IC TXRX RS485 DIFF ESD 8SOIC |
| LTC1745IFW | IC ADC SMPL 12BIT 25MSPS 48TSSOP |
| LTC1403AHMSE#PBF | IC ADC 14BIT 2.8MSPS DIFF 10MSOP |
| LTC1855CG#PBF | IC ADC 14BIT 8CH 100KSPS 28SSOP |
| SP1485ECN-L/TR | IC TXRX RS485 DIFF ESD 8SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1746CFW | 功能描述:IC ADC 14BIT 25MSPS LP 48TSSOP RoHS:否 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:12 采样率（每秒）:300k 数据接口:并联 转换器数目:1 功率耗散（最大）:75mW 电压电源:单电源 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:24-SOIC（0.295"，7.50mm 宽） 供应商设备封装:24-SOIC 包装:带卷 (TR) 输入数目和类型:1 个单端，单极；1 个单端，双极 |
| LTC1746CFW#PBF | 功能描述:IC ADC 14BIT 25MSPS LP 48TSSOP RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1 系列:microPOWER™ 位数:8 采样率（每秒）:1M 数据接口:串行，SPI? 转换器数目:1 功率耗散（最大）:- 电压电源:模拟和数字 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:24-VFQFN 裸露焊盘 供应商设备封装:24-VQFN 裸露焊盘（4x4） 包装:Digi-Reel® 输入数目和类型:8 个单端，单极 产品目录页面:892 (CN2011-ZH PDF) 其它名称:296-25851-6 |
| LTC1746CFW#TR | 功能描述:IC ADC SMPL 14BIT 25MSPS 48TSSOP RoHS:否 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:12 采样率（每秒）:300k 数据接口:并联 转换器数目:1 功率耗散（最大）:75mW 电压电源:单电源 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:24-SOIC（0.295"，7.50mm 宽） 供应商设备封装:24-SOIC 包装:带卷 (TR) 输入数目和类型:1 个单端，单极；1 个单端，双极 |
| LTC1746CFW#TRPBF | 功能描述:IC ADC 14BIT 25MSPS LP 48TSSOP RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:12 采样率（每秒）:300k 数据接口:并联 转换器数目:1 功率耗散（最大）:75mW 电压电源:单电源 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:24-SOIC（0.295"，7.50mm 宽） 供应商设备封装:24-SOIC 包装:带卷 (TR) 输入数目和类型:1 个单端，单极；1 个单端，双极 |
| LTC1746IFW | 制造商:Linear Technology 功能描述:ADC Single Pipelined 25Msps 14-bit Parallel 48-Pin TSSOP |
发布紧急采购，3分钟左右您将得到回复。