- 您现在的位置：买卖IC网 > PDF目录15333 > LTC1772IS6#TRPBF (Linear Technology)IC REG CTRLR BUCK PWM CM SOT23-6 PDF资料下载
参数资料
| 型号： | LTC1772IS6#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 7/12页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM SOT23-6 |
| 标准包装： | 2,500 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 650kHz |
| 占空比： | 100% |
| 电源电压： | 2.5 V ~ 9.8 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | SOT-23-6 细型，TSOT-23-6 |
| 包装： | 带卷 (TR) |
LTC1772
APPLICATIO N S I N FOR M ATIO N
I RIPPLE ≤
wherefistheoperatingfrequency.Acceptinglargervalues
of I RIPPLE allows the use of low inductances, but results in
higher output voltage ripple and greater core losses. A
reasonable starting point for setting ripple current is
I RIPPLE = 0.4(I OUT(MAX) ). Remember, the maximum I RIPPLE
occurs at the maximum input voltage.
In Burst Mode operation on the LTC1772, the ripple
current is normally set such that the inductor current is
continuous during the burst periods. Therefore, the peak-
to-peak ripple current must not exceed:
0 . 03
R SENSE
This implies a minimum inductance of:
Molypermalloy (from Magnetics, Inc.) is a very good, low
loss core material for toroids, but it is more expensive than
ferrite. A reasonable compromise from the same manu-
facturer is Kool M μ . Toroids are very space efficient,
especially when you can use several layers of wire. Be-
cause they generally lack a bobbin, mounting is more
difficult. However, new designs for surface mount that do
not increase the height significantly are available.
Power MOSFET Selection
An external P-channel power MOSFET must be selected
for use with the LTC1772. The main selection criteria for
the power MOSFET are the threshold voltage V GS(TH) and
the “on” resistance R DS(ON) , reverse transfer capacitance
C RSS and total gate charge.
V IN ? V OUT ? V OUT + V D ?
? 0 . 03 ? ? V IN D ?
+ V
? R SENSE ?
L MIN =
f ? ?
? ?
Since the LTC1772 is designed for operation down to low
input voltages, a sublogic level threshold MOSFET (R DS(ON)
guaranteed at V GS = 2.5V) is required for applications that
work close to this voltage. When these MOSFETs are used,
(Use V IN(MAX) = V IN )
A smaller value than L MIN could be used in the circuit;
however, the inductor current will not be continuous
during burst periods.
Inductor Core Selection
make sure that the input supply to the LTC1772 is less than
the absolute maximum V GS rating, typically 8V.
The required minimum R DS(ON) of the MOSFET is gov-
erned by its allowable power dissipation. For applications
that may operate the LTC1772 in dropout, i.e., 100% duty
cycle, at its worst case the required R DS(ON) is given by:
R DS ( ON )
OncethevalueforLisknown,thetypeofinductormustbe
selected. High efficiency converters generally cannot af-
ford the core loss found in low cost powdered iron cores,
DC = 100 %
=
P P
( I OUT ( MAX ) ) 2 ( 1 + δ p )
forcing the use of more expensive ferrite, molypermalloy
or Kool M μ ? cores. Actual core loss is independent of core
size for a fixed inductor value, but it is very dependent on
inductance selected. As inductance increases, core losses
go down. Unfortunately, increased inductance requires
more turns of wire and therefore copper losses will in-
crease. Ferrite designs have very low core losses and are
preferred at high switching frequencies, so design goals
can concentrate on copper loss and preventing saturation.
where P P is the allowable power dissipation and δ p is the
temperature dependency of R DS(ON) . (1 + δ p) is generally
given for a MOSFET in the form of a normalized R DS(ON) vs
temperature curve, but δ p = 0.005/ ° C can be used as an
approximation for low voltage MOSFETs.
In applications where the maximum duty cycle is less than
100% and the LTC1772 is in continuous mode, the R DS(ON)
is governed by:
Ferrite core material saturates “hard,” which means that
inductance collapses abruptly when the peak design cur-
rent is exceeded. This results in an abrupt increase in
R DS ( ON ) ?
P P
( DC ) I OUT 2 ( 1 + δ p )
inductor ripple current and consequent output voltage
ripple. Do not allow the core to saturate!
where DC is the maximum operating duty cycle of the
LTC1772.
1772fb
7
相关PDF资料 |
PDF描述 |
|---|---|
| ADM8691ARN-REEL | IC SUPERVSR MPU 4.65V ADJ 16SOIC |
| VI-JW2-EY-F3 | CONVERTER MOD DC/DC 15V 50W |
| LTC1772IS6#TR | IC REG CTRLR BUCK PWM CM SOT23-6 |
| RCM36DSXS | CONN EDGECARD 72POS DIP .156 SLD |
| PM105-100M-RC | INDUCTOR POWER 10UH 20% SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1773EMS | 功能描述:IC REG CTRLR BUCK PWM CM 10-MSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC1773EMS#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 10-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC1773EMS#TR | 功能描述:IC REG CTRLR BUCK PWM CM 10-MSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC1773EMS#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 10-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC1775CGN | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
发布紧急采购，3分钟左右您将得到回复。