- 您现在的位置：买卖IC网 > PDF目录1828 > LTC1773EMS#PBF (Linear Technology)IC REG CTRLR BUCK PWM CM 10-MSOP PDF资料下载
参数资料
| 型号： | LTC1773EMS#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 7/20页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 10-MSOP |
| 标准包装： | 50 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 600kHz |
| 占空比： | 100% |
| 电源电压： | 2.65 V ~ 8.5 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 10-TFSOP，10-MSOP（0.118"，3.00mm 宽） |
| 包装： | 管件 |
| 产品目录页面： | 1333 (CN2011-ZH PDF) |
LTC1773
OPERATIO
(Refer to Functional Diagram)
and forces the main switch to stay off for the same number
of cycles. Increasing the output load current slightly,
above the minimum required for discontinuous conduc-
tion mode, allows constant frequency PWM.
Frequency synchronization is inhibited when the feedback
voltage, V FB , is below 0.6V. This prevents the external
clock from interfering with the frequency foldback for
short-circuit protection.
Low Supply Operation
The LTC1773 is designed to operate down to a 2.65V
supply voltage. For proper operation at this low input
voltage, sub-logic level MOSFETs are required. When the
value of the output voltage is very close to the input
voltage, the converter is running at high duty cycles or in
dropout where the main switch is on continuously. See
Efficiency Considerations in the Applications Information
section.
Dropout Operation
When the input supply voltage decreases toward the
output voltage, the duty cycle increases toward the maxi-
mum on-time. Further reduction of the supply voltage
forces the main switch to remain on for more than one
cycle until it reaches 100% duty cycle. The output voltage
will then be determined by the input voltage minus the IR
voltage drop across the external P-channel MOSFET,
sense resistor, and the inductor.
Undervoltage Lockout
A precision undervoltage lockout shuts down the LTC1773
when V IN drops below 2.5V, making it ideal for single
lithium-ion battery applications. In shutdown, the LTC1773
draws only several microamperes, which is low enough to
prevent deep discharge and possible damage to the lithium-
ion battery that’s nearing its end of charge. A 150mV
hysteresis ensures reliable operation with noisy supplies.
APPLICATIO N S I N FOR M ATIO N
The basic LTC1773 application circuit is shown in
Figure 1. External component selection is driven by the
load requirement and begins with the selection of R SENSE .
Once R SENSE is known, L can be chosen, followed by the
external power MOSFETs. Finally, C IN and C OUT are se-
lected .
R SENSE Selection for Output Current
R SENSE is chosen based on the required output current.
The LTC1773 current comparator has a maximum thresh-
old of 100mV/R SENSE . The current comparator threshold
Slope Compensation and Inductor Peak Current
Slope compensation provides stability by preventing
subharmonic oscillations. It works by internally adding a
ramp to the inductor current signal at duty cycles in excess
of 30%. This causes the internal current comparator to trip
earlier. The I TH clamp level is also reached earlier than
conditions in which the duty cycle is below 30%. As a
result, the maximum inductor peak current is lower for
V OUT /V IN > 0.3 than when V OUT /V IN < 0.3.
To compensate for this loss in maximum inductor peak
current during high duty cycles, the LTC1773 uses a
patent pending scheme that raises the I TH clamp level
(proportional to the amount of slope compensation) when
duty cycle is above 30%.
average output current I MAX equal to the peak value less
half the peak-to-peak ripple current ? I L .
Allowing a margin for variations in the LTC1773 and
external component values yields:
R SENSE = 70mV/I MAX
Inductor Value Calculation
The inductor selection will depend on the operating fre-
quency of the LTC1773. The internal preset frequency is
550kHz, but can be externally synchronized up to 750kHz.
sets the peak of the inductor current, yielding a maximum
1773fb
7
相关PDF资料 |
PDF描述 |
|---|---|
| LTC1775CS#PBF | IC REG CTRLR BUCK PWM CM 16-SOIC |
| LTC1778EGN-1#PBF | IC REG CTRLR BUCK PWM CM 16-SSOP |
| LTC1779ES6#TRPBF | IC REG BUCK ADJ 0.25A SOT23-6 |
| LTC1844ES5-1.5#TRM | IC REG LDO 1.5V .15A TSOT23-5 |
| LTC1871EMS#PBF | IC REG CTRLR BST FLYBK CM 10MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1775CGN | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1775CGN#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1775CGN#TR | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1775CGN#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1775CS | 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
发布紧急采购，3分钟左右您将得到回复。