- 您现在的位置：买卖IC网 > PDF目录15323 > LTC1778EGN (Linear Technology)IC REG CTRLR BUCK PWM CM 16-SSOP PDF资料下载
参数资料
| 型号： | LTC1778EGN |
| 厂商： | Linear Technology |
| 文件页数： | 14/24页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 16-SSOP |
| 标准包装： | 100 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 电源电压： | 4 V ~ 36 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 16-SSOP（0.154"，3.90mm 宽） |
| 包装： | 管件 |
LTC1778/LTC1778-1
APPLICATIO S I FOR ATIO
V OUT 2 ( MIN ) = 0 . 8 V ? 1 + ?
but an additional ceramic capacitor in parallel is recom-
mended to reduce the effect of their lead inductance.
Top MOSFET Driver Supply (C B , D B )
An external bootstrap capacitor C B connected to the BOOST
pin supplies the gate drive voltage for the topside MOSFET.
This capacitor is charged through diode D B from INTV CC
when the switch node is low. When the top MOSFET turns
on, the switch node rises to V IN and the BOOST pin rises
to approximately V IN + INTV CC . The boost capacitor needs
to store about 100 times the gate charge required by the
top MOSFET. In most applications 0.1 μ F to 0.47 μ F, X5R or
X7R dielectric capacitor is adequate.
Discontinuous Mode Operation and FCB Pin
The FCB pin determines whether the bottom MOSFET
remains on when current reverses in the inductor. Tying
this pin above its 0.8V threshold enables discontinuous
transformer. However, if the controller goes into discon-
tinuous mode and halts switching due to a light primary
load current, then V OUT2 will droop. An external resistor
divider from V OUT2 to the FCB pin sets a minimum voltage
V OUT2(MIN) below which continuous operation is forced
until V OUT2 has risen above its minimum.
? R 4 ?
? R 3 ?
Fault Conditions: Current Limit and Foldback
The maximum inductor current is inherently limited in a
current mode controller by the maximum sense voltage. In
the LTC1778, the maximum sense voltage is controlled by
the voltage on the V RNG pin. With valley current control,
the maximum sense voltage and the sense resistance
determine the maximum allowed inductor valley current.
The corresponding output current limit is:
operation where the bottom MOSFET turns off when
inductor current reverses. The load current at which
current reverses and discontinuous operation begins de-
pends on the amplitude of the inductor ripple current and
I LIMIT =
V SNS ( MAX )
R DS ( ON ) ρ T
1
+ ? I L
2
will vary with changes in V IN . Tying the FCB pin below the
0.8V threshold forces continuous synchronous operation,
allowing current to reverse at light loads and maintaining
high frequency operation.
In addition to providing a logic input to force continuous
operation, the FCB pin provides a means to maintain a
flyback winding output when the primary is operating in
discontinuous mode. The secondary output V OUT2 is nor-
mally set as shown in Figure 6 by the turns ratio N of the
The current limit value should be checked to ensure that
I LIMIT(MIN) > I OUT(MAX) . The minimum value of current limit
generally occurs with the largest V IN at the highest ambi-
ent temperature, conditions that cause the largest power
loss in the converter. Note that it is important to check for
self-consistency between the assumed MOSFET junction
temperature and the resulting value of I LIMIT which heats
the MOSFET switches.
Caution should be used when setting the current limit
based upon the R DS(ON) of the MOSFETs. The maximum
current limit is determined by the minimum MOSFET on-
V IN
+
V IN
C IN
resistance. Data sheets typically specify nominal and
maximum values for R DS(ON) , but not a minimum. A
OPTIONAL
EXTV CC
CONNECTION
5V < V OUT2 < 7V
R4
LTC1778
EXTV CC
FCB
TG
SW
1N4148
T1 ? +
1:N
+
V OUT2
C OUT2
1 μ F
V OUT1
C OUT
reasonable assumption is that the minimum R DS(ON) lies
the same amount below the typical value as the maximum
lies above it. Consult the MOSFET manufacturer for further
guidelines.
R3
SGND
BG
PGND
1778 F06
To further limit current in the event of a short circuit to
ground, the LTC1778 includes foldback current limiting. If
the output falls by more than 25%, then the maximum
sense voltage is progressively lowered to about one sixth
Figure 6. Secondary Output Loop and EXTV CC Connection
of its full value.
1778fb
14
相关PDF资料 |
PDF描述 |
|---|---|
| MIC2186YQS TR | IC REG CTRLR BST FLYBK CM 16QSOP |
| ABC18DRTF-S13 | CONN EDGECARD 36POS DIP .100 SLD |
| RCC36DRYS | CONN EDGECARD 72POS DIP .100 SLD |
| ADM8696ANZ | IC SUPERVSR MPU ADJ/RESET 16DIP |
| ADM8697ANZ | IC SUPERVSR MPU ADJ/RESET 16DIP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1778EGN#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC1778EGN#TR | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC1778EGN#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC1778EGN-1 | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC1778EGN-1#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
发布紧急采购，3分钟左右您将得到回复。