参数资料
| 型号： | LTC1851CFW |
| 厂商： | Linear Technology |
| 文件页数： | 6/28页 |
| 文件大小： | 0K |
| 描述： | IC ADC 12BIT 1.25MSPS 48-TSSOP |
| 标准包装： | 39 |
| 位数： | 12 |
| 采样率（每秒）： | 1.25M |
| 数据接口： | 并联 |
| 转换器数目： | 1 |
| 功率耗散（最大）： | 50mW |
| 电压电源： | 单电源 |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 48-TFSOP（0.240"，6.10mm 宽） |
| 供应商设备封装： | 48-TSSOP |
| 包装： | 管件 |
| 输入数目和类型： | 8 个单端，单极；8 个单端，双极；4 个差分，单极；4 个差分，双极 |
| 产品目录页面： | 1347 (CN2011-ZH PDF) |
第1页第2页第3页第4页第5页当前第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
14
LTC1850/LTC1851
18501f
APPLICATIO S I FOR ATIO
WU
UU
If two pure sine waves of frequencies fa and fb are applied
to the ADC input, nonlinearities in the ADC transfer func-
tion can create distortion products at the sum and differ-
ence frequencies of mfa
± nfb, where m and n = 0, 1, 2, 3,
etc. For example, the 2nd order IMD terms include (fa
±fb).
If the two input sine waves are equal in magnitude, the
value (in decibels) of the 2nd order IMD products can be
expressed by the following formula:
IMD fa
fb
Log
Amplitude at fa
fb
Amplitude at fa
±
()=
±
()
20
Peak Harmonic or Spurious Noise
The peak harmonic or spurious noise is the largest spec-
tral component excluding the input signal and DC. This
value is expressed in decibels relative to the RMS value of
a full-scale input signal.
Full-Power and Full-Linear Bandwidth
The full-power bandwidth is that input frequency at which
the amplitude of the reconstructed fundamental is
reduced by 3dB for a full-scale input signal.
The full-linear bandwidth is the input frequency at which
the S/(N + D) has dropped to 68dB for the LTC1851 (11
effective bits) or 56dB for the LTC1850 (9 effective bits).
The LTC1850/LTC1851 have been designed to optimize
input bandwidth, allowing the ADC to undersample input
signals with frequencies above the converter’s Nyquist
frequency. The noise floor stays very low at high frequen-
cies; S/(N + D) becomes dominated by distortion at
frequencies far beyond Nyquist.
ANALOG INPUT MULTIPLEXER
The analog input multiplexer is controlled using the single-
ended/differential pin (DIFF), three MUX address pins (A2,
A1, A0), the unipolar/bipolar pin (UNI/BIP) and the gain
select pin (PGA). The single-ended/differential pin (DIFF)
allows the user to configure the MUX as eight single-
ended channels relative to the analog input common pin
(COM) when DIFF is low or as four differential pairs (CH0
and CH1, CH2 and CH3, CH4 and CH5, CH6 and CH7) when
DIFF is high. The channels (and polarity in the differential
case) are selected using the MUX address inputs as shown
in Table 1. Unused inputs (including the COM in the
differential case) should be grounded to prevent noise
coupling.
Table 1. Multiplexer Address Table
MUX ADDRESS
SINGLE-ENDED CHANNEL SELECTION
DIFF A2 A1 A0 CH0 CH1 CH2 CH3 CH4 CH5 CH6 CH7 COM
00
0
+
–
00
0
1
+
–
00
1
0
+
–
00
1
+
–
01
0
+
–
01
0
1
+
–
01
1
0
+
–
01
1
+
–
MUX ADDRESS
DIFFERENTIAL CHANNEL SELECTION
DIFF A2 A1 A0 CH0 CH1 CH2 CH3 CH4 CH5 CH6 CH7 COM
10
0
+
–
*
10
0
1
–
+
*
10
1
0
+
–
*
10
1
–
+
*
11
0
+
–
*
11
0
1
–
+
*
11
1
0
+
–
*
11
1
–
+
*
*Not used in differential mode. Connect to GND.
In addition to selecting the MUX channel, the LTC1850/
LTC1851 also allows the user to select between two gains
and unipolar or bipolar inputs for a total of four input
spans. PGA high selects a gain of 1 (the input span is equal
to the voltage on REFCOMP). PGA low selects a gain of 2
where the input span is equal to half of the voltage on
REFCOMP. UNI/BIP low selects a unipolar input span,
UNI/BIP high selects a bipolar input span. Table 2 summa-
rizes the possible input spans.
相关PDF资料 |
PDF描述 |
|---|---|
| LTC1853IFW#TRPBF | IC A/D CONV 8CH 12BIT 48-TSSOP |
| LTC1856IG#PBF | IC ADC 16BIT 100KSPS 28-SSOP |
| LTC1859IG#TRPBF | IC A/D CONV 8CH 16BIT 28-SSOP |
| LTC1867AIGN#TRPBF | IC ADC 16BIT 8CH 200KSPS 16SSOP |
| LTC1867LCGN#PBF | IC ADC 16BIT 8CH 175KSPS 16SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1851CFW#PBF | 功能描述:IC ADC 12BIT 1.25MSPS 48-TSSOP RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1 系列:microPOWER™ 位数:8 采样率（每秒）:1M 数据接口:串行，SPI? 转换器数目:1 功率耗散（最大）:- 电压电源:模拟和数字 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:24-VFQFN 裸露焊盘 供应商设备封装:24-VQFN 裸露焊盘（4x4） 包装:Digi-Reel® 输入数目和类型:8 个单端，单极 产品目录页面:892 (CN2011-ZH PDF) 其它名称:296-25851-6 |
| LTC1851CFW#TR | 功能描述:IC ADC 12BIT 1.25MSPS 48-TSSOP RoHS:否 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:16 采样率（每秒）:45k 数据接口:串行 转换器数目:2 功率耗散（最大）:315mW 电压电源:模拟和数字 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) 输入数目和类型:2 个单端，单极 |
| LTC1851CFW#TRPBF | 功能描述:IC ADC 12BIT 1.25MSPS 48-TSSOP RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:16 采样率（每秒）:45k 数据接口:串行 转换器数目:2 功率耗散（最大）:315mW 电压电源:模拟和数字 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) 输入数目和类型:2 个单端，单极 |
| LTC1851CFWPBF | 制造商:Linear Technology 功能描述:ADC,LTC1851 12bit 1.25MSPS 8 ch TSSOP |
| LTC1851IFW | 功能描述:IC ADC 12BIT 1.25MSPS 48-TSSOP RoHS:否 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:12 采样率（每秒）:300k 数据接口:并联 转换器数目:1 功率耗散（最大）:75mW 电压电源:单电源 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:24-SOIC（0.295"，7.50mm 宽） 供应商设备封装:24-SOIC 包装:带卷 (TR) 输入数目和类型:1 个单端，单极；1 个单端，双极 |
发布紧急采购，3分钟左右您将得到回复。