- 您现在的位置：买卖IC网 > PDF目录15347 > LTC1872ES6#TRM (Linear Technology)IC REG CTRLR BST PWM CM SOT23-6 PDF资料下载
参数资料
| 型号： | LTC1872ES6#TRM |
| 厂商： | Linear Technology |
| 文件页数： | 6/12页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BST PWM CM SOT23-6 |
| 标准包装： | 1 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 650kHz |
| 电源电压： | 2.5 V ~ 9.8 V |
| 降压： | 无 |
| 升压： | 是 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | SOT-23-6 |
| 包装： | 剪切带 (CT) |
| 其它名称： | LTC1872CS6 LTC1872CS6-ND LTC1872ES6 LTC1872ES6#TRMCT LTC1872ES6-ND |
LTC1872
APPLICATIO N S I N FOR M ATIO N
? RIPPLE ?
I OUT = ?
V IN ? V OUT + V D ? V IN ?
()
I RIPPLE =
V OUT + V D
fL ?
?
I RIPPLE = 0 . 4 ? I OUT ( ) ? ? OUT D ?
?
?
? MAX ? V
( )( ) V OUT V IN + V D
The basic LTC1872 application circuit is shown in
Figure 1. External component selection is driven by the
load requirement and begins with the selection of L1 and
R SENSE (= R1). Next, the power MOSFET and the output
diode D1 is selected followed by C IN (= C1) and C OUT (= C2).
R SENSE Selection for Output Current
R SENSE is chosen based on the required output current.
With the current comparator monitoring the voltage devel-
oped across R SENSE , the threshold of the comparator
determines the inductor’s peak current. The output cur-
rent the LTC1872 can provide is given by:
? 0 . 12 I ? V IN
? R SENSE 2 ? V OUT + V D
where I RIPPLE is the inductor peak-to-peak ripple current
(see Inductor Value Calculation section) and V D is the
forward drop of the output diode at the full rated output
current.
A reasonable starting point for setting ripple current is:
I RIPPLE = O .4 I OUT
Rearranging the above equation, it becomes:
Inductor Value Calculation
The operating frequency and inductor selection are inter-
related in that higher operating frequencies permit the use
of a smaller inductor for the same amount of inductor
ripple current. However, this is at the expense of efficiency
due to an increase in MOSFET gate charge losses.
The inductance value also has a direct effect on ripple
current. The ripple current, I RIPPLE , decreases with higher
inductance or frequency and increases with higher V OUT .
The inductor’s peak-to-peak ripple current is given by:
? ?
where f is the operating frequency. Accepting larger values
of I RIPPLE allows the use of low inductances, but results in
higher output voltage ripple and greater core losses. A
reasonable starting point for setting ripple current is:
? V + V ?
IN
In Burst Mode operation, the ripple current is normally set
such that the inductor current is continuous during the
burst periods. Therefore, the peak-to-peak ripple current
must not exceed:
( )( )
10 I OUT ? V OUT + V D ?
R SENSE =
1 ? V IN ?
? ?
I RIPPLE ≤
0 . 03
R SENSE
for Duty Cycle < 40%
This implies a minimum inductance of:
? 0 . 03 ? ?
V OUT + V D
?
f ? ?
However,foroperationthatisabove40%dutycycle,slope
compensation’s effect has to be taken into consideration
to select the appropriate value to provide the required
amount of current. Using the scaling factor (SF, in %) in
L MIN =
? R SENSE ?
V IN ? V OUT + V D ? V IN ?
? ?
( )( I OUT )( )
R SENSE =
100 ? V OUT + V D ?
? ?
Figure 2, the value of R SENSE is:
SF ? V IN ?
10
6
A smaller value than L MIN could be used in the circuit;
however, the inductor current will not be continuous
during burst periods.
相关PDF资料 |
PDF描述 |
|---|---|
| UVY1C332MHD | CAP ALUM 3300UF 16V 20% RADIAL |
| URU0J472MRD | CAP ALUM 4700UF 6.3V 20% RADIAL |
| ISC1210EB390K | INDUCTOR WW 39UH 10% 1210 |
| ISC1210EB330K | INDUCTOR WW 33UH 10% 1210 |
| URZ1C222MHD | CAP ALUM 2200UF 16V 20% RADIAL |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1872ES6TRMPBF | 制造商:Linear Technology 功能描述:DC-DC Controller Step-Up 2.5-9.8V TSOT23 |
| LTC1873EG | 功能描述:IC REG CTRLR BUCK PWM VM 28-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1873EG#PBF | 功能描述:IC REG CTRLR BUCK PWM VM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1873EG#TR | 功能描述:IC REG CTRLR BUCK PWM VM 28-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC1873EG#TRPBF | 功能描述:IC REG CTRLR BUCK PWM VM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
发布紧急采购，3分钟左右您将得到回复。