参数资料
型号: LTC1967CMS8#TR
厂商: Linear Technology
文件页数: 17/28页
文件大小: 327K
描述: IC CONVERTER RMS-DC PREC 8MSOP
标准包装: 2,500
电流 - 电源: 320µA
电源电压: 4.5 V ~ 5.5 V
安装类型: 表面贴装
封装/外壳: 8-TSSOP,8-MSOP(0.118",3.00mm 宽)
供应商设备封装: 8-MSOP
包装: 带卷 (TR)
17
LTC1967
1967f
APPLICATIO S I FOR ATIO
U
U
U
Figures 18 and 19 show the settling time versus settling
accuracy for the Buffered and DC accurate post filters,
respectively. The different curves represent different
scalings of the filters, as indicated by the C
AVE
 value. These
are comparable to the curves in Figure 11 (single capacitor
case), with somewhat less settling time for the buffered
post filter, and somewhat more settling time for the
DC-accurate post filter. These differences are due to the
change in overall bandwidth as mentioned earlier.
Although the settling times for the post-filtered configura-
tions shown on Figures 18 and 19 are not that much
different from those with a single capacitor, the point of
using a post filter is that the settling times are far better for
a given level peak error. The filters dramatically reduce the
low frequency averaging ripple with far less impact on
settling time.
Crest Factor and AC + DC Waveforms
In the preceding discussion, the waveform was assumed
to be AC coupled, with a modest crest factor. Both
assumptions ease the requirements for the averaging
capacitor. With an AC-coupled sine wave, the calculation
engine squares the input, so the averaging filter that
follows is required to filter twice the input frequency,
making its job easier. But with a sinewave that includes
DC offset, the square of the input has frequency content
at the input frequency and the filter must average out that
lower frequency. So with AC + DC waveforms, the re-
quired value for C
AVE
 should be based on half of the lowest
input frequency, using the same design curves presented
in Figures 6, 8, 16 and 17.
Figure 17. Peak Error vs Input Frequency with DC-Accurate Post Filter
Figure 16. Peak Error vs Input Frequency with Buffered Post Filter
INPUT FREQUENCY (Hz)
1
2.0
1.6
1.2
0.8
0.4
10
100
1967 F16
0
1.8
1.4
1.0
0.6
0.2
C = 22礔
C = 10礔
C = 4.7礔
C = 2.2礔
C = 1礔
C = 0.47礔
C = 0.22礔
INPUT FREQUENCY (Hz)
1
2.0
1.6
1.2
0.8
0.4
10
100
1967 F17
0
1.8
1.4
1.0
0.6
0.2
C = 10礔
C = 4.7礔
C = 2.2礔
C = 1礔
C = 0.47礔
C = 0.22礔
C = 0.1礔
相关PDF资料
PDF描述
NCP5501DT15RKG IC REG LDO 1.5V .5A DPAK-3
VI-J1Z-IZ CONVERTER MOD DC/DC 2V 10W
WSU050-3000-R POWER SUPPLY 100-240V 3000MA
EN91F2 BATTERY PK 3.0V AA SIZE ALKALINE
MC78M15ACDTRKG IC REG LDO 15V .5A DPAK-3
相关代理商/技术参数
参数描述
LTC1967IMS8 功能描述:IC CONVERTER RMS-DC PREC 8MSOP RoHS:否 类别:集成电路 (IC) >> PMIC - RMS 至 DC 转换器 系列:- 标准包装:46 系列:- 电流 - 电源:1.2mA 电源电压:±18 V,36 V 安装类型:表面贴装 封装/外壳:16-SOIC(0.295",7.50mm 宽) 供应商设备封装:16-SOIC W 包装:管件
LTC1967IMS8#PBF 功能描述:IC CONVERTER RMS-DC PREC 8MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - RMS 至 DC 转换器 系列:- 标准包装:46 系列:- 电流 - 电源:1.2mA 电源电压:±18 V,36 V 安装类型:表面贴装 封装/外壳:16-SOIC(0.295",7.50mm 宽) 供应商设备封装:16-SOIC W 包装:管件
LTC1967IMS8#TR 功能描述:IC CONVERTER RMS-DC PREC 8MSOP RoHS:否 类别:集成电路 (IC) >> PMIC - RMS 至 DC 转换器 系列:- 标准包装:46 系列:- 电流 - 电源:1.2mA 电源电压:±18 V,36 V 安装类型:表面贴装 封装/外壳:16-SOIC(0.295",7.50mm 宽) 供应商设备封装:16-SOIC W 包装:管件
LTC1967IMS8#TRPBF 功能描述:IC CONVERTER RMS-DC PREC 8MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - RMS 至 DC 转换器 系列:- 标准包装:46 系列:- 电流 - 电源:1.2mA 电源电压:±18 V,36 V 安装类型:表面贴装 封装/外壳:16-SOIC(0.295",7.50mm 宽) 供应商设备封装:16-SOIC W 包装:管件
LTC1968CMS8 功能描述:IC CONVERTER RMS-DC PREC 8MSOP RoHS:否 类别:集成电路 (IC) >> PMIC - RMS 至 DC 转换器 系列:- 标准包装:46 系列:- 电流 - 电源:1.2mA 电源电压:±18 V,36 V 安装类型:表面贴装 封装/外壳:16-SOIC(0.295",7.50mm 宽) 供应商设备封装:16-SOIC W 包装:管件