- 您现在的位置：买卖IC网 > PDF目录10365 > LTC2450CDC#TRPBF (Linear Technology)IC ADC 16BIT DELTA SIG 6-DFN PDF资料下载
参数资料
| 型号： | LTC2450CDC#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 18/20页 |
| 文件大小： | 0K |
| 描述： | IC ADC 16BIT DELTA SIG 6-DFN |
| 标准包装： | 2,500 |
| 位数： | 16 |
| 采样率（每秒）： | 30 |
| 数据接口： | 串行，SPI? |
| 转换器数目： | 1 |
| 功率耗散（最大）： | 1.05mW |
| 电压电源： | 单电源 |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 6-WFDFN 裸露焊盘 |
| 供应商设备封装： | 6-DFN-EP（2x2） |
| 包装： | 带卷 (TR) |
| 输入数目和类型： | 1 个单端，单极 |
| 配用： | DC1067A-B-ND - BOARD DELTA SIGMA ADC LTC2450-1 DC1067A-A-ND - BOARD DELTA SIGMA ADC LTC2450 |
LTC2450
7
2450fb
CONVERTER OPERATION
Converter Operation Cycle
The LTC2450 is a low power, delta-sigma analog-to-
digital converter with a simple 3-wire interface (see
Figure 1). Its operation is composed of three successive
states: CONVERT, SLEEP and DATA OUTPUT. The operat-
ing cycle begins with the CONVERT state, is followed
by the SLEEP state and ends with the DATA OUTPUT
state (see Figure 2). The 3-wire interface consists of
serial data output (SDO), serial clock input (SCK) and the
active low chip select input (CS).
The CONVERT state duration is determined by the LTC2450
conversion time (nominally 33.3 milliseconds). Once
started, this operation can not be aborted except by a low
power supply condition (VCC < 2.1V) which generates an
internal power-on reset signal.
After the completion of a conversion, the LTC2450 enters
the SLEEP state and remains here until both the chip
select and clock inputs are low (CS = SCK = LOW). Fol-
lowing this condition the ADC transitions into the DATA
OUTPUT state.
Figure 2. LTC2450 State Transition Diagram
APPLICATIONS INFORMATION
While in the SLEEP state, whenever the chip select input
is pulled high (CS = HIGH), the LTC2450’s power supply
current is reduced to less than 200nA. When the chip select
input is pulled low (CS = LOW), and SCK is maintained
at a HIGH logic level, the LTC2450 will return to a normal
power consumption level. During the SLEEP state, the
result of the last conversion is held indenitely in a static
register.
Upon entering the DATA OUTPUT state, SDO outputs the
most signicant bit (D15) of the conversion result. During
this state, the ADC shifts the conversion result serially
through the SDO output pin under the control of the SCK
input pin. There is no latency in generating this result and
it corresponds to the last completed conversion. A new
bit of data appears at the SDO pin following each falling
edge detected at the SCK input pin. The user can reliably
latch this data on every rising edge of the external serial
clock signal driving the SCK pin (see Figure 3).
The DATA OUTPUT state concludes in one of two dif-
ferent ways. First, the DATA OUTPUT state operation is
completed once all 16 data bits have been shifted out and
the clock then goes low, which corresponds to the 16th
falling edge of SCK. Second, the DATA OUTPUT state can
be aborted at any time by a LOW-to-HIGH transition on
the CS input. Following either one of these two actions,
the LTC2450 will enter the CONVERT state and initiate a
new conversion cycle.
Power-Up Sequence
When the power supply voltage VCC applied to the con-
verter is below approximately 2.1V, the ADC performs a
power-on reset. This feature guarantees the integrity of
the conversion result.
When VCC rises above this critical threshold, the converter
generates an internal power-on reset (POR) signal for
approximately 0.5ms. The POR signal clears all internal
registers. Following the POR signal, the LTC2450 starts
a conversion cycle and follows the succession of states
described in Figure 2. The rst conversion result fol-
lowing POR is accurate within the specications of the
device if the power supply voltage VCC is restored within
the operating range (2.7V to 5.5V) before the end of the
POR time interval.
DATA OUTPUT
SLEEP
CONVERT
POWER-ON RESET
YES
2450 F02
16TH FALLING
EDGE OF SCK
OR
CS = HIGH?
SCK = LOW
AND
CS = LOW?
NO
YES
NO
相关PDF资料 |
PDF描述 |
|---|---|
| MS27473E12F98P | CONN PLUG 10POS STRAIGHT W/PINS |
| VE-2NM-MX-S | CONVERTER MOD DC/DC 10V 75W |
| LTC2360CTS8#TRMPBF | IC ADC 12BIT 100KSPS TSOT23-8 |
| MS27497E12A3S | CONN RCPT 3POS WALL MNT W/SCKT |
| LTC2360CTS8#TRPBF | IC ADC 12BIT 100KSPS TSOT23-8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC2450IDC#PBF | 制造商:Linear Technology 功能描述:ADC Single Delta-Sigma 30sps 16-bit Serial 6-Pin DFN EP 制造商:Linear Technology 功能描述:Bulk 制造商:Linear Technology 功能描述:ADC 16BIT 30SPS SPI DFN-6 制造商:Linear Technology 功能描述:ADC, 16BIT, 30SPS, SPI, DFN-6; Resolution (Bits):16bit; Sampling Rate:30SPS; Supply Voltage Type:Single; Supply Voltage Min:2.7V; Supply Voltage Max:5.5V; Supply Current:350A; Digital IC Case Style:DFN; No. of Pins:6 ;RoHS Compliant: Yes |
| LTC2450IDC#TRMPBF | 功能描述:IC ADC 16BIT DELTA SIG 6-DFN RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1 系列:microPOWER™ 位数:8 采样率（每秒）:1M 数据接口:串行，SPI? 转换器数目:1 功率耗散（最大）:- 电压电源:模拟和数字 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:24-VFQFN 裸露焊盘 供应商设备封装:24-VQFN 裸露焊盘（4x4） 包装:Digi-Reel® 输入数目和类型:8 个单端，单极 产品目录页面:892 (CN2011-ZH PDF) 其它名称:296-25851-6 |
| LTC2450IDC#TRPBF | 功能描述:IC ADC 16BIT DELTA SIG 6-DFN RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:2,500 系列:- 位数:16 采样率（每秒）:15 数据接口:MICROWIRE?，串行，SPI? 转换器数目:1 功率耗散（最大）:480µW 电压电源:单电源 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:38-WFQFN 裸露焊盘 供应商设备封装:38-QFN（5x7） 包装:带卷 (TR) 输入数目和类型:16 个单端，双极；8 个差分，双极 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| LTC2450IDC-1#PBF | 制造商:Linear Technology 功能描述:ADC Single Delta-Sigma 60sps 16-bit Serial 6-Pin DFN EP 制造商:Linear Technology 功能描述:Bulk 制造商:Linear Technology 功能描述:ADC 16BIT DEL SIG 60HZ 6DF 制造商:Linear Technology 功能描述:ADC, 16BIT, 60SPS, SPI, DFN-6; Resolution (Bits):16bit; Sampling Rate:60SPS; Supply Voltage Type:Single; Supply Voltage Min:2.7V; Supply Voltage Max:5.5V; Supply Current:350A; Digital IC Case Style:DFN; No. of Pins:6 ;RoHS Compliant: Yes |
| LTC2450IDC-1#TRMPBF | 功能描述:IC ADC 16BIT DELTA SIG 6-DFN RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1 系列:microPOWER™ 位数:8 采样率（每秒）:1M 数据接口:串行，SPI? 转换器数目:1 功率耗散（最大）:- 电压电源:模拟和数字 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:24-VFQFN 裸露焊盘 供应商设备封装:24-VQFN 裸露焊盘（4x4） 包装:Digi-Reel® 输入数目和类型:8 个单端，单极 产品目录页面:892 (CN2011-ZH PDF) 其它名称:296-25851-6 |
发布紧急采购，3分钟左右您将得到回复。