- 您现在的位置：买卖IC网 > PDF目录10015 > LTC2845CUHF#TRPBF (Linear Technology)IC TXRX 3.3V MULTIPROTOCOL 38QFN PDF资料下载
参数资料
| 型号： | LTC2845CUHF#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 3/20页 |
| 文件大小： | 0K |
| 描述： | IC TXRX 3.3V MULTIPROTOCOL 38QFN |
| 标准包装： | 2,500 |
| 类型： | 收发器 |
| 驱动器/接收器数： | 5/5 |
| 规程： | 多协议 |
| 电源电压： | 3.3V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 38-WFQFN 裸露焊盘 |
| 供应商设备封装： | 38-QFN（5x7） |
| 包装： | 带卷 (TR) |
11
LTC2845
sn2845 2845fs
APPLICATIONS INFORMATION
WU
U
Mode Selection
The interface protocol is selected using the mode select
pins M0, M1 and M2 (see the Mode Selection table).
For example, if the port is configured as a V.35 interface,
the mode selection pins should be M2 = 1, M1 = 0, M0 = 0.
For the control signals, the drivers and receivers will
operate in V.28 (RS232) electrical mode. For the clock and
data signals, the drivers and receivers will operate in V.35
electrical mode. The DCE/DTE pin will configure the port
for DCE mode when high, and DTE when low.
The interface protocol may be selected simply by plugging
the appropriate interface cable into the connector. The
mode pins are routed to the connector and are left uncon-
nected (1) or wired to ground (0) in the cable as shown in
Figure 10.
The internal pull-up current sources will ensure a binary 1
when a pin is left unconnected and that the LTC2846/
LTC2845 enters the no-cable mode when the cable is
removed. In the no-cable mode the LTC2846/LTC2845
supply current drops to less than 1000
A and all driver
outputs are forced into a high impedance state.
The mode selection may also be accomplished by using
jumpers to connect the mode pins to ground or VIN.
Cable Termination
Traditional implementations have included switching
resistors with expensive relays, or required the user to
change termination modules every time the interface
standard has changed. Custom cables have been used
with the termination in the cable head or separate termina-
tions are built on the board and a custom cable routes the
signals to the appropriate termination. Switching the
termination with FETs is difficult because the FETs must
remain off even though the signal voltage is beyond the
supply voltage for the FET drivers or the power is off.
Using the LTC2846/LTC2845 solves the cable termination
switching problem. Via software control, appropriate ter-
mination for the V.10 (RS423), V.11 (RS422), V.28 (RS232)
and V.35 electrical protocols is chosen.
V.10 (RS423) Interface
A typical V.10 unbalanced interface is shown in Figure 11.
A V.10 single-ended generator output A with ground C is
connected to a differential receiver with inputs A
' con-
nected to A, and input C
' connected to the signal return
ground C. Usually, no cable termination is required for
V.10 interfaces, but the receiver inputs must be compliant
with the impedance curve shown in Figure 12.
Figure 10. Single Port DCE V.35 Mode Selection in the Cable
NC
VIN
CABLE
3.3k
2845 F10
LTC2846
LTC2845
CONNECTOR
(DATA)
M0
M1
M2
DCE/DTE
M2
M1
M0
D4ENB
R4EN
(DATA)
相关PDF资料 |
PDF描述 |
|---|---|
| LTC2845CUHF#TR | IC TXRX 3.3V MULTIPROTOCOL 38QFN |
| VE-B3H-MX-B1 | CONVERTER MOD DC/DC 52V 75W |
| LTC2845CUHF#PBF | IC TXRX 3.3V MULTIPROTOCOL 38QFN |
| IDT72851L25TF | IC FIFO SYNC DUAL 8192X9 64QFP |
| LTC2845CUHF | IC TXRX 3.3V MULTIPROTOCOL 38QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC2845IG | 功能描述:IC TXRX 3.3V MULTIPROTCOL 36SSOP RoHS:否 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 标准包装:250 系列:- 类型:收发器 驱动器/接收器数:2/2 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:16-TSSOP 包装:带卷 (TR) |
| LTC2845IG#PBF | 功能描述:IC TXRX 3.3V MULTIPROTCOL 36SSOP RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 标准包装:250 系列:- 类型:收发器 驱动器/接收器数:2/2 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:16-TSSOP 包装:带卷 (TR) |
| LTC2845IG#TR | 功能描述:IC TXRX 3.3V MULTIPROTCOL 36SSOP RoHS:否 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 标准包装:250 系列:- 类型:收发器 驱动器/接收器数:2/2 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:16-TSSOP 包装:带卷 (TR) |
| LTC2845IG#TRPBF | 功能描述:IC TXRX 3.3V MULTIPROTCOL 36SSOP RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 标准包装:250 系列:- 类型:收发器 驱动器/接收器数:2/2 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:16-TSSOP 包装:带卷 (TR) |
| LTC2845IUHF | 功能描述:IC TXRX 3.3V MULTIPROTOCOL 38QFN RoHS:否 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 标准包装:250 系列:- 类型:收发器 驱动器/接收器数:2/2 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:16-TSSOP 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。